USER TAG - PROGRAMMING INSTRUCTIONS
PROGRAMMING FUNCTION USER ACTION CONTROLLER RESPONSE
Teaching the controller a new USER
TAG
1. Present the Master Tag to
the reader and keep it in the
reader field.
2. Remove the Master Tag and
present the new User Tag(s)
to be learned one at a time to
the reader.
3. After teaching the controller
the new User Tag(s), present
the Master Tag to the reader
again to exit User Tag learn
mode.
The controller responds with a single
beep. After a few seconds, the
controller responds with an additional
3 beeps indicating that it has entered
User Tag learn mode.
1 second after presenting a new User
Tag, the controller will respond with a
single beep. This indicates that the
controller has learned the new User
Tag.(Note: Should the controller
respond with 3 beeps instead, it is
indicating that the 1000 user limit
has been exceeded and that the
controller has exited User Tag learn
mode.)
The controller responds with 3 beeps
indicating that it has left User Tag
learn mode. (Note: Should the user
forget to exit User Tag learn mode,
the unit will automatically exit this
mode after 30 seconds.)
Note:
After completing this procedure,
present each tag to the reader, press
button S1 on the controller to display
the tag number and record this
number against the name of the user
in a register.
Repeat this exercise for all the new
tags entered into the system.
Note: Should an invalid card or tag be presented to the reader, the unit will NOT
respond with a beep and no user number will appear on the controller.
