ZigBee/High Power Hardware Technical Operation Manual
User’s Guideline Index:
A) Pre-operation instruction
B) Introduction of ZigBee/High Power Wireless Products & Parts
C) Installation Procedure
D) Attachment: Jump Setting/LED Display Interpretation
A) Pre-operation Instruction
(a) Check the model numbers/quantities.
(b) Get the external equipment & tools ready for use.
(c) Install the software attached with this product to computer set.
(d) Priority of installing hardware and setting up software: first, install the wireless coordinator; next, install
the wireless transmitter.
(e) Follow the transmission interface of wireless coordinator to manually set up the IP address or search for
the COM port of computer.
(f) Boot the software products (setting/monitoring software); follow this Manual to operate this product.
A-1 Follow the Transmission Interface of Wireless Coordinator to Perform the Following Steps:
《Manually set up the IP address》
For Ethernet transmission interface, prior to setting up IP manually, you have to comprehend the
following default of wireless coordinator:
IP address: 192.168.0.10
Subnet mask: 255.255.255.0
Set up the server IP address at the《LAN-Internet Protocol》; and this IP address shall be in the same
domain. For instance: IP address is 192.168.0.XXX
XXX can be any number between 001~254 (not duplicate to the coordinator’s IP address), and not used
by any other device.
《Search for the COM port》
For the USB transmission interface, prior to running the product, you have to install the driver CO.USB to
inspect the COM port at the《Driver Manager-Ports》
