v 1.1 300319
SEO CANeasy programming manual
Automatic calibration and the most appropriate Program number detection for specific vehicle:
Press and hold the button for 5 seconds to activate the automatic calibration and Program number selection
process. SEO CANeasy device will select and set the most appropriate for a specific vehicle from the
existing database of 2500 vehicles and it will additionally select another 8 similar Program numbers that
may also be appropriate for specific vehicle.
• After holding the button for 5 seconds, the LED will flash rapidly, and then will shine during the
whole calibration and Program number detection process (it may take up to 60 seconds). Then the
module restarts and will enter the normal operation mode – if the LED flashes rapidly, the module
does correctly receive data from CAN BUS.
• To check which Program numbers have been selected as the most compatible with your vehicle,
enter code 11, 12, 13, 14, 15, 16, 17, 18 or 19.
• To switch between Program numbers suggested by the device, enter code 22, 23, 24, 25, 26, 27,
28, 29 or 21 to return to the Program number selected as the most appropriate.
Setting the Program number (using button located on the device)
To set the Program number, enter each digit one-by-one by the appropriate number of keystrokes. After
entering each digit, the LED will signal the entered digit with a series of short blinks. Then immediately
(in less than 3 s) start entering the next digit. After entering all the digits of the Program number, press
and hold the button until the LED blinks rapidly. Then the module restarts and the correct connection with
the CAN BUS will be signaled by a fast LED flickering. If the LED, instead of rapidly blinking, shines
for about 2 seconds, the incorrect Program number was entered. Please enter the Program number again.
You can always start entering the next digit immediately after the LED starts signaling the entered
digit. However, it is recommended that the user check the correctness of the entered digit by
counting the number of flashes after entering each digit.
Examples of entering the Program number (or other function)
If you intend to enter the Program number 11188:
• Press the button once; the LED will flash once indicating the entered digit
• Press the button once; the LED will flash once indicating the entered digit
• Press the button once; the LED will flash once indicating the entered digit
• Press the button 8 times; the LED will flash 8 times indicating the entered digit
• Press the button 8 times; the LED will flash 8 times indicating the entered digit
• Press and hold the button until the LED blinks rapidly. If the LED shines for about 2 seconds
instead, of rapidly flashing, an incorrect Program number has been entered or the Program number
is not supported by the device.
If you intend to check the automatically selected Program number or choose one of them, for example
code 12 (to check the 5-digit Program number suggested by the device):
• Press the button once; the LED will flash once indicating the entered digit
• Press the button twice; the LED will flash twice indicating the entered digit
• Press and hold the button. The LED will blink the appropriate number of times for each digit
blinking out one digit after another.
