Sharper Image Ionic Breeze GP SI730 Manuale utente
Ionic
Breeze®
GP
SI730 Instructions
INCLUDES IMPORTANT
SAFETY INFORMATION
READ ALL INSTRUCTIONS
BEFORE USING THIS
APPLIANCE
SAVE THESE
INSTRUCTIONS
•This appliance operates at 110-120v AC and 60Hz only.
•Connect to a properly grounded outlet only.
•Use indoors only.
•Unplug from outlet when not in use and before servicing.
•Do not allow the appliance to be used as a toy. Close
attention is necessary when the appliance is operated
near children.
•Use only as described in this user manual.
•Do not use if cord or plug appears to be damaged. If the
appliance is not working properly, or has been dropped,
damaged, left outdoors, or dropped into water, return it
to a service center or to the original place of purchase.
•Do not pull, lift, or carry by the power cord. Do not use
the cord as a handle, close a door on the cord, or pull the
cord around or against sharp edges or corners.
•Keep the cord away from heated surfaces.
WARNING: To reduce the risk of fire, electric shock,
or injury when using any electrical appliance, basic
precautions should always be followed, including:
READ AND SAVE THESE INSTRUCTIONS
•Damaged power cord must only be replaced by qualified
service personnel. There are no user-serviceable parts
inside the unit. Any attempt to open the unit will void
the warranty and could lead to serious damage to the
unit and/or personal injury to the operator.
•Turn off all controls before unplugging unit from outlet.
•Do not unplug by pulling the cord. Grasp the plug itself,
not the cord, when unplugging from an outlet.
•Do not handle the plug or appliance with wet hands.
•Do not put any object into openings. Do not continue to
use with any opening blocked. Keep all openings free of
dust, lint, hair, or anything that may reduce airflow.
•Keep hair, loose clothing, fingers, and all parts of the
body away from openings.
•Do not operate the unit in areas where flammable or
combustible products or vapors may be present.
The collection grid has many edges and areas that can
trap water. If running water is used to clean the grid,
allow the collection grid to dry completely.
If candles or oil lamps are burned, the collection grid
must be cleaned immediately or the collected soot may
be released back into the room. In any area where this
product will be subjected to heavy pollution it will be
necessary to clean the collection grid more frequently.
H
A
a
H
W
t
g
t
W
T
a
o
W
I
y
CAUTION: This product generates invisible ultraviolet
light. To avoid overexposure when the lamp
is on, persons must stay at least one foot
away from the unit if the total duration of
exposure to the unit will be more than 1 hour
per day. Shorter durations of exposure at
close proximity are safe. If the enclosure is
damaged, do not use the product.
Never stare at the U.V. lamp or place your
face directly against the front or rear grill
during operation.
Failure to follow these warnings can result in direct
exposure to germicidal light, which can cause temporary
or chronic damage to your eyesight, or may even result
in blindness.
Please read this product instruction manual for important
safety information and operating instructions.
Frequently Asked Questions
About the Ionic Breeze®
How often is cleaning required?
At least every two weeks or anytime the Ionic Breeze makes
an audible sound or the CLEANING INDICATOR lights.
How should it be cleaned?
Wipe the removable collection grid with a damp cloth, paper
towel or sponge. It is very important that the collection
grid be allowed to dry completely before returning it
to the main housing.
What is the clean fresh scent I smell?
This scent is ozone, (O3), a combination of three oxygen
atoms. (The U.S. government has set safe standards for
ozone, and the Ionic Breeze complies with those standards.)
Which power setting should I use?
If the odor of ozone is strong (for instance in a smaller room),
you may prefer to have the power setting on medium or low.
Place the Ionic Breeze
GP at least twelve inches
from the wall and in
a location where children
cannot stare directly into
the unit at a close range.
Plug into a grounded 110v
outlet (read warnings for
details). 12”
Set-Up and Operation
Switch the MODE CONTROL to
the desired setting:
ON - The unit will clean,
and circulate the air but
the germicidal lamp is not
activated.
ON/G.P. - Air is also passed
through UV light produced
by a germicidal lamp.
B
o
o
s
t
O
f
f
O
n
O
n
/
G
.
P
.
L
o
M
e
d
H
i
C
L
E
A
N
MODE
CONTROL
Blue Glow
coming from
within the
unit indicates
that the
germicidal
lamp is
operating.
Set-Up and Operation
Press BOOST to override the
POWER CONTROL setting and
run the unit at maximum
power for five minutes.
Your previously selected
power level will resume
after the five minutes has
elapsed.
Switch the POWER CONTROL
to the desired HI, MED, or
LO setting.
Normal operation at all
power levels involves a pre
programmed cycle of alter-
ing high and low air move-
ment.
B
o
o
s
t
O
f
f
O
n
O
n
/
G
.
P
.
L
o
M
e
d
H
i
C
L
E
A
N
BOOST
B
o
o
s
t
O
f
f
O
n
O
n
/
G
.
P
.
L
o
M
e
d
H
i
C
L
E
A
N
POWER
CONTROL
Cleaning the Collection Grid
Unplug the unit before
cleaning.
Remove the collection grid
by pulling it from the top
of the unit.
Use a dry or slightly damp
towel or sponge to quickly
wipe the dust from each of
the three collection bars.
Invert the entire unit for
two or three times before
replacing the grid.
Cleaning the grid every one or two weeks. As a reminder, the
cleaning indicator light will turn amber after two weeks. If
the cleaning indicator light turns red, the unit has shut down
because of excessive dirt or circuitry problems. In most cases a
thorough cleaning will return the unit to normal operation.
COLLECTION
GRID
2X
I
o
Thorough Cleaning
Remove the collection grid
by pulling it from the top
of the unit.
Wash the grid with warm
soapy water, rinse, and
allow to dry for 24 hours
before returning to unit.
Use a compressed gas
dusting product to remove
any accumulated particles
from the ionizing wires
and to blow out any dust
that is settled in the base
of the unit. (Because of the
dust, it is advisable to do
this outside.)
If the unit makes noise during operation, a thorough cleaning
of the grid and ionizing wires may be required.
Additional Information
The exterior of the unit can be cleaned using a cloth or
sponge and a solution of one part household bleach to five
parts water or any bleach based spray cleaner.
Allow the surface to dry completely before plugging it
back into an outlet.
The unit will not function while the collection grid is
removed and/or the germicidal lamp cover is removed.
L
R
w
O
t
w
o
r
a
The Ionic Breeze has been independently tested and found
to comply with U.S. government limits on the maximum
acceptable level of ozone, less than 50 parts per billion by
volume of air circulating through the device.Persons with
a history of asthma, heart disease, or any lung disease
or breathing problem should consult with their physician
before using this product.
Indice
Altri manuali Sharper Image Purificatore d'aria
Sharper Image
Sharper Image 203833-01 Manuale utente
Sharper Image
Sharper Image 207377 Manuale utente
Sharper Image
Sharper Image A552 Manuale utente
Sharper Image
Sharper Image 202439 Manuale utente
Sharper Image
Sharper Image SI871 Manuale utente
Sharper Image
Sharper Image 204460 Manuale utente
Sharper Image
Sharper Image PURIFY 9 Manuale utente
Sharper Image
Sharper Image SI724 Manuale utente
Sharper Image
Sharper Image 203758 Manuale utente
Sharper Image
Sharper Image Quadra SI867 Manuale utente
Sharper Image
Sharper Image SI853 Manuale utente
Sharper Image
Sharper Image 201218 Manuale utente
Sharper Image
Sharper Image SI861 Manuale utente
Sharper Image
Sharper Image 206051 Manuale utente
Sharper Image
Sharper Image EVSI-AR60 Manuale di istruzioni
Sharper Image
Sharper Image Sharper Image 202441 Manuale utente
Sharper Image
Sharper Image SI857 Manuale utente
Sharper Image
Sharper Image A501 Manuale del proprietario
Sharper Image
Sharper Image Ionic Breeze SI627 Manuale utente
Sharper Image
Sharper Image PURIFY 3 Manuale utente
