Note: Your spy pen will not work without the micro SD memory card. If SD card is not inserted
properly, red light will flash when pen is turned on. All recordings/photos are stored on the SD
card.
Ensure the micro SD card is pushed in completely; otherwise, it will not collect data
from the recording session.
The status light will blink red to indicate an SD card error. This typically occurs when
the micro SD card is not inserted properly.
Your micro SD card's memory capacity (2GB - 4GB - 8GB - 16GB) will determine how
much data can be recorded while using the Spy Cam Pen.
Your Spy Cam Pen has a rechargeable lithium battery that can accommodate
approximately 1.5 hours of recording time for both videos and photos. You will need
to recharge your spy pen battery to continue your spy mission, even though you'll
have a lot more memory on your micro SD card.
STEP 2 –Turn on the Spy Pen
Power up the Spy Cam Pen by pressing the On/Off Button on the top of the pen for
3 seconds. (To power off, press On/Off Button for 3 seconds.)
Check the status light to ensure the Spy Cam Pen has powered up properly. It will
display a solid green LED light to indicate that the Spy Cam Pen is on and ready to
record or take a photo. (Solid green light indicates Ready Mode.)
STEP 3 –Start Recording Video
Start recording with the Spy Cam Pen by pressing the On/Off Button on the top of
the pen for 2 seconds.
Check the status light. The LED will blink several times to indicate that recording is
about to begin.
Once recording begins, the light goes out (or a dim, delayed blinking light may
occur) so it does not attract attention during a covert recording session.
Remember to take measures to ensure that the camera lens, located above the pen
clip, remains unobstructed during the recording session.
To produce clean, clear recordings, limit the Spy Cam Pen's movement during
recording sessions.
STEP 4 –Ending a Recording Session
