Shure Microflex MX424/N Manuale tecnico

MX400 Series

Gooseneck Microphones

Online user guide for Shure Microflex MX400 Series miniature gooseneck-mounted electret condenser microphones.

Version: 5 (2019-J)

Shure Incorporated

2/11

Table of Contents

MX400 SeriesGooseneck Microphones 3

General Description 3

Interchangeable Cartridges 3

Snap-Fit Windscreen 4

Preamp Gain 5

Microphone Placement 5

Permanent Installation 5

Flange 6

Shock Mount 6

Specifications 7

Certifications 10

Shure Incorporated

3/11

•

MX400 Series

Gooseneck Microphones

General Description

Shure Microflex MX400S Series microphones are miniature gooseneck-mounted electret condenser microphones designed

primarily for speech and vocal pickup. They can be mounted on lecterns, pulpits, or conference tables. All models include a

preamplifier and are available with interchangeable cardioid, supercardioid, or omnidirectional cartridges.

Wide dynamic range and frequency response for accurate sound reproduction

Interchangeable cartridges that provide an optimal polar pattern choice for each application

Shock mount provides over 20 dB of isolation from surface vibration noise

Snap-fit foam windscreen

RF filtering

MX400 microphones are available with 305 mm (12 in.) or 457 mm (18 in.) goosenecks, with or without a mute switch. They

are available in supercardioid, cardioid and omnidirectional polar patterns.

"S" models include a mute button and LED.

"D" models include a desktop base with programmable mute button and LED and logic input and output.

"SE" models feature a surface mount flange with side-exit cable.

The polar pattern of the included cartridge is indicated by a model number suffix:

/C Cardioid

/S Supercardioid

/O Omnidirectional

/N Cartridge not included

Interchangeable Cartridges

Shure Incorporated

4/11

•

Microflex microphones use interchangeable cartridges that allow you to choose the polar pattern for different installations.

Snap-Fit Windscreen

Snap into the groove below the cartridge.

To remove, spread the gap with a screwdriver or thumbnail.

Shure Incorporated

5/11

•

Provides 30 dB of "pop" protection.

Preamp Gain

If necessary, the preamplifier gain can be reduced by 12 dB. Contact an authorized Shure service center for information.

Microphone Placement

Aim the microphone toward the desired source, such as the talker.

Aim it away from any unwanted source, such as a loudspeaker.

Place the microphone within 15 to 30cm (6 to 12 in.) of the desired sound source.

Always use the supplied windscreen or optional metal windscreen to control breath noise.

If four or more microphones will be open at the same time, use of an automatic mixer, such as the Shure SCM810 or

SCM410, is recommended.

Permanent Installation

Mount the microphone using one of the following methods.

Shure Incorporated

6/11

Flange

Drill a 22 mm (7/8 in.) diameter hole in the desired location.

Trace and drill three starter holes for the supplied screws using the flange as a template.

Insert the preamplifier through the mounting flange.

Slip the mounting flange retaining ring over the bottom of the preamplifier and slide it up until it is flush to the bottom of

the flange. Then press the ring firmly into place.

Secure the flange to the mounting surface with three screws.

Shock Mount

Drill a 44mm(1-3/4 in.) diameter hole in desired mounting surface.

Mark and drill starter holes for screws, using shock mount as a template.

Secure shock mount to mounting surface with screws.

Thread the supplied adapter onto the MX400 microphone before inserting it into the shock mount.

Shure Incorporated

7/11

Specifications

Type

Electret Condenser

Frequency Response

50–17000Hz

Polar Pattern

MX412/C, MX418/C Cardioid

MX412/S, MX418/S Supercardioid

Shure Incorporated

8/11

Output Impedance

180Ω

Output Configuration

Active Balanced

Sensitivity

@ 1 kHz, open circuit voltage

Cardioid –35dBV/Pa(18 mV)

Supercardioid –34dBV/Pa(21 mV)

1 Pa=94 dB SPL

Maximum SPL

1 kHz at 1% THD, 1 kΩ load

Cardioid 124dB

Supercardioid 123dB

Self Noise

A-weighted

Cardioid 28dBSPL

Supercardioid 27dBSPL

Signal-to-Noise Ratio

Ref. 94 dB SPL at 1 kHz

Cardioid 66dB

Supercardioid 68dB

Dynamic Range

1 kΩ load, @ 1 kHz

96dB

Common Mode Rejection

10 Hz to 100 kHz

45dB, minimum

Clipping Level

at 1% THD

–6dBV (0.5V)

Polarity

Positive sound pressure on diaphragm produces positive voltage on pin 2 relative to pin 3 of output XLR

connector

Mute Switch

MX412S/MX418S

–50dB minimum

Shure Incorporated

9/11

Environmental Conditions

Operating Temperature –18–57°C (0–135°F)

Storage Temperature –29–74°C(–20–165°F)

Relative Humidity 0–95%

Power Requirements

11–52 VDC, 2.0mA

Shure Incorporated

10/11

Certifications

Meets essential requirements of all applicable European Directives.

Eligible for CE marking.

The CE Declaration of Conformity can be obtained from Shure Incorporated or any of its European representatives. For contact

information please visit www.shure.com

The CE Declaration of Conformity can be obtained from: www.shure.com/europe/compliance

Authorized European representative:

Shure Europe GmbH

Headquarters Europe, Middle East & Africa

Department: EMEA Approval

Jakob-Dieffenbacher-Str. 12

Questo manuale è adatto per i seguenti modelli

Indice

Altri manuali Shure Microfono

Manuali Microfono popolari di altre marche

IK Multimedia

IK Multimedia iRig Stream MIC PRO Manuale utente

DAPAudio

DAPAudio RM-101 Manuale utente

AKG

AKG CHM 21 Manuale utente

Sennheiser

Sennheiser evolution wireless series EM 100 Manuale utente

Sony

Sony C-48 Manuale utente

GIGAMEDIA

GIGAMEDIA GGM PAMICUHFG Manuale utente

auna PRO

auna PRO MIC-900 Manuale utente

AKG

AKG D 3800 Manuale utente

MAIIN SOUND

MAIIN SOUND IIN style Manuale utente

Earthworks

Earthworks TC25 Manuale utente

Sennheiser

Sennheiser evolution D1 Manuale utente

Alesis

Alesis MicLink Wireless Manuale utente

DSPPA

DSPPA D6234 Manuale utente

Monacor

Monacor IMG STAGELINE ECM-300B Manuale utente

Ansr Audio

Ansr Audio Scan16 Manuale utente

JLab

JLab GO TALK Manuale utente

Renkforce

Renkforce TY-109 Manuale utente

Trust

Trust 31008 Manuale utente