Shure WL183 Manuale utente

WL183 WL184 WL185

Lavalier Condenser Microphone

The Shure lavalier condenser microphones, WL183, WL184, and WL185, user guide.

Version: 2.1 (2021-C)

Shure Incorporated

2/8

Table of Contents

WL183 WL184 WL185 Lavalier Condenser Microphone3

General Description 3

Model Variations 3

Installation 3

Changing Cartridges 4

Specifications 6

Replacement Parts 7

Certifications 7

Shure Incorporated

3/8

•

WL183 WL184 WL185 

Lavalier Condenser Microphone

General Description

Models WL183, WL184 and WL185 are lavalier electret condenser microphones for use with a wireless bodypack transmitter.

Each microphone has a 1.2 meter (4 ft.) cable terminated with a miniature 4-pin connector (TA4F). The furnished tie clip can be

rotated in 90° intervals for placement flexibility.

Model Variations

WL183 (Omnidirectional): General purpose sound reinforcement, recording, or remote monitoring applications. Low handling

noise. Pickup angle is 360°. WL184 (Supercardioid): Sound reinforcement applications requiring high rejection of ambient

noiseandnarrowpickupangle.Useofwindscreenhighlyrecommended.Pickupangleis115°.WL185(Cardioid):Generalpur

pose sound reinforcement applications requiring good rejection of ambient noise. Use of windscreen highly recommended.

Pickup angle is 130°.

Installation

1. Insert the top of the microphone through tie clip loop from below until tie clip loop snaps into place over the lower groove on

the microphone. 2. To install the snap-fit windscreen, press it down on the microphone until it clicks into place inside the upper

groove on the microphone. The snap-fit windscreen provides 30 dB of pop protection. 3. Attach the microphone approximately

76 mm to 152 mm (3 to 6 in.) below the neckline.

Note

The snap-fit windscreen can be removed by spreading the slot in the plastic snapfit ring.

To install the smaller foam windscreen, slip the windscreen over the top of the microphone so that it covers the side slots.

The foam windscreen provides 5 to 10 dB of pop protection

NOTE: Do not cover the microphone with your hand or clothing

Shure Incorporated

4/8

Changing Cartridges

TheWL183,WL184,andWL185microphonesuseinterchangeablecartridges.Tochangethecartridge,unscrewitfromthemi

crophone base and replace it with one of the replacement cartridges listed below.

Shure Incorporated

5/8

OMNIDIRECTIONAL (WL183)

SUPERCARDIOID (WL184)

Shure Incorporated

6/8

CARDIOID (WL185)

Specifications

Type

Condenser (electret bias)

Frequency Response

50 to 17,000 Hz

Output Impedance

1800 Ω

Sensitivity

WL183 -40.0 dBV/Pa

WL184 -44.5 dBV/Pa

WL185 -45.5 dBV/Pa

Maximum SPL

WL183 125.0 dBSPL

WL184 129.5 dBSPL

WL185 130.5 dBSPL

Self Noise (A-Weighted):

WL183 22.5 dBSPL

WL184 27.0 dBSPL

WL185 28.0 dBSPL

[1]

Shure Incorporated

7/8

Dynamic Range

102.5 dB

Polarity

Positive pressure on diaphragm produces positive voltage on pin 3 with respect to pin 1

Power Requirements

Regulated nominal +5 Vdc (1.5 Vdc to 10 Vdc) provided at microphone connector pin 2 relative to pin 1 of a

Shure wireless microphone transmitter

1 Pa = 94 dB SPL

MICROPHONE WIRING DIAGRAM

Replacement Parts

Black Omnidirectional Cartridge for all MX- (Microflex ) Models and WL183 R183B

Black Supercardioid Cartridge for all MX- (Microflex ) and WL183, WL184 and

WL185 Models R184B

Black Cardioid Cartridge for WL185 and all MX- (Microflex ) Models R185B

Black Snap-Fit Foam Windscreens (4) for SM35, BETA98, BETA98A, BETA98/S,

BETA98D/S, BETA98H/C, MX183, MX184, MX185, MX202, WH30, WL183, WL184 and

WL185

RK183WS

Black Small Foam Windscreens (4) for MX183, MX184, MX185, SM84, WL84A,

WL183, WL184 and WL185 RK261BWS

Single Mount Tie-Clips (2) for MX183, MX184 and MX185, WL183, WL184 and WL185 RK183T1

4-Pin Mini Connector (TA4F/TQG) WA330

[1][1]

Shure Incorporated

8/8

Certifications

This product meets the Essential Requirements of all relevant European directives and is eligible for CE marking.

The CE Declaration of Conformity can be obtained from: www.shure.com/europe/compliance

Authorized European representative:

Shure Europe GmbH

Headquarters Europe, Middle East & Africa

Department: EMEA Approval

Jakob-Dieffenbacher-Str. 12

75031 Eppingen, Germany

Phone: +49-7262-92 49 0

Fax: +49-7262-92 49 11 4

Email: [email protected]

Altri manuali per WL183

Questo manuale è adatto per i seguenti modelli

Indice

Altri manuali Shure Microfono

Manuali Microfono popolari di altre marche

IK Multimedia

IK Multimedia iRig Stream MIC PRO Manuale utente

DAPAudio

DAPAudio RM-101 Manuale utente

AKG

AKG CHM 21 Manuale utente

Sennheiser

Sennheiser evolution wireless series EM 100 Manuale utente

Sony

Sony C-48 Manuale utente

GIGAMEDIA

GIGAMEDIA GGM PAMICUHFG Manuale utente

auna PRO

auna PRO MIC-900 Manuale utente

AKG

AKG D 3800 Manuale utente

MAIIN SOUND

MAIIN SOUND IIN style Manuale utente

Earthworks

Earthworks TC25 Manuale utente

Sennheiser

Sennheiser evolution D1 Manuale utente

Alesis

Alesis MicLink Wireless Manuale utente

DSPPA

DSPPA D6234 Manuale utente

Monacor

Monacor IMG STAGELINE ECM-300B Manuale utente

Ansr Audio

Ansr Audio Scan16 Manuale utente

JLab

JLab GO TALK Manuale utente

Renkforce

Renkforce TY-109 Manuale utente

Trust

Trust 31008 Manuale utente