General recommendations
The angle grinder is designed for cutting* and trimming, using the suitable disks, steel and
building materials (stone, brick, breeze-blocks, reinforced concrete, etc.). It can also be tted
with accessories and used for sanding and brushing.
• There is a whole range of sizes for grinders, generally 115 mm to 230 mm in diameter. The 115
mm - 125 mm models are generally used for carrying out small jobs, because they are light and
easy to use. The 230 mm models are used for much heavier tasks.
• The cutting* capacity of the grinders depends, to a great extent, on the type of disk used.
There are disks for cutting metal, sheet metal, masonry (stone, breeze-block, etc.)
• The speed control, if your machine is tted with one, makes trimming and sanding work
easier.
• The soft start function, if your machine is tted with it, makes it easier to start on the piece to
be ground more eciently and with greater precision.
• The trimming function can be used to remove burr that is left behind after cutting, for exam-
ple. You must use a disk that is appropriate to the material, and work at an angle of around 25°,
and move the tool back and forth constantly and smoothly. The cutting* function consist to
work at an angle of 90° with an appropriate disk to the material.
*= Only with suitable not provided carter
1
BRUSHLESS TECH series
BRUSHLESS CORDLESS ANGLE GRINDER
