Sigtronics SE-40RPTT Manuale utente

igtronics

Sigtronics

…when it counts!

Sigtronics Corporation

178 East Arrow Highway

San Dimas, CA 91773

Phone: 909 305-9399

E-mail: info@sigtronics.com

Web Site: www.sigtronics.com

Model SE-40RPTT

Headset Instructions

The SE-40RPTT series headset is adjusted at the factory for immediate use. The

headset is equipped with a single plug and a coiled cord.

The headband is adjustable through a full range of motion, and the locking nuts

may be tightened to allow you to custom t the headphone. Place the headphone

over your head and adjust the slides up until minimum pressure is felt on the top

of your head. For maximum noise attenuation, the clamping pressure of the head-

band has been set at the factory. Releasing the clamping pressure by bending the

headband is not advised, because loss of attenuation will result.

The microphone boom is fully adjustable and will rotate 180 degrees for use on

the left or right side of the head. The locking screw that secures the boom to the

ear cup is factory set to insure the correct tension. Turning it will not change the

tension, because the nut on the inside of the cup will turn as well.

Microphone placement should be at the corner of the mouth, approximately

¼” from the lips. The exclusive thumb screw on the mic boom may be used to

assure proper placement.

Your SE-40RPTT headset has a push to transmit switch located on the mic side ear

cup. When the headset is connected to a radio, depressing this switch will cause

the radio to transmit. The switch is not used for intercom function.

When you rst connect the headset, turn the volume control on the headset up

to the full clockwise position, then adjust the listening volume with the audio

control of either your radio or intercom as appropriate. If applicable, crew mem-

bers should also turn their individual headset volumes up fully. Doing this allows

for a full range of adjustment for each passenger, since those with the most acute

hearing can turn their headset volume down, if necessary.

continued on back…

The headset parts may be cleaned with mild soap and water using a soft cloth.

Then dry immediately. Caution: Do Not immerse any part of the headset in water

or any other liquid. Be especially careful not to allow the microphone to become

wet! Exposure to moisture may cause internal corrosion and failure and will void

your manufacturers warranty.

Cleaning will help the headset maintain its “like new” condition for many years.

WINDSCREEN

The microphone windscreen will reduce annoying wind noise and breath pops

picked up by headset microphones. It also protects the microphone element

from dirt and moisture. The windscreen should be washed regularly to maintain

hygiene and avoid clogging. Wash in warm water and mild soap. Rinse thoroughly

and make sure it is completely dry before putting it back on.

To remove the windscreen, take out the screw that holds the microphone on the

boom and grasp the windscreen lightly along its entire length and slip it o.

Put the windscreen on the microphone by gently pulling from the open end. Do

not pull it so tightly that it stretches against the end of the microphone.

WARRANTY

Your headset is covered by a limited two-year parts and labor warranty. Please see

the enclosed warranty card for details.

You may refer to the parts list on the reverse side, if you choose to replace parts

yourself. The parts list describes parts for this particular headset only. Parts lists

for other models are available on our Web Site or can be obtained by contacting

Sigtronics Corporation.

SIGTRONICS SE-40RPTT HEADSET PARTS IDENTIFICATION BREAKDOWN

ITEM P/N DESCRIPTION ITEM P/N DESCRIPTION ITEM P/N DESCRIPTION

1800048 HEADBAND , WITH CUSHION, SE-40 16 100959 EAR CUP, PRINTED AND DRILLED, VOLUME CONTROL SIDE 31 800039 CABLE, MICROPHONE BOOM, 12 INCH

2100383 HEADBAND, METAL, STANDARD 17 100049 GROMMET, 5/16 INCH, RUBBER 32 100933 WIRE, CROSSOVER, OVER THE HEAD, 28 INCH

3100367 YOKE, EAR CUP MOUNT, METAL 18 800082 MICROPHONE, ELECTRET, M-80 33 100935 WIRE, #22, JUMPER, HEADSET, 4 INCH

4100384 BRACKET, YOKE SUPPORT WITH TANG 19 100415 WINDSCREEN, MICROPHONE, FOAM, BULK 34 100569 STRAIN RELIEF, CABLE

5100373 SLIDE, YOKE BRACKET, LONG, NYLON 20 900084 WINDSCREEN, MICROPHONE, FOAM, PACKAGED 35 100063 KNOB, 3/8 INCH, BLACK

6100258 CLIP, HEADBAND GUIDE, PLASTIC 21 100249 BOOM, ELECTRET MICROPHONE SUPPORT, SWIVEL 36 100077 POTENTIOMETER

7100393 CLIP, ANTI-ROTATION, YOKE, PLASTIC 22 100156 SCREW, THUMB, MICROPHONE BOOM, 2-56 X 1 37 100858 RECEIVER AND MOUNT, 300 OHM, MONO

8100362 CLIP, CROSS-OVER, WIRE, PLASTIC 23 100368 KNOB, MICROPHONE BOOM ADAPTER, PLASTIC 38 100232 SWITCH, SPDT, MOMENTARY

9100363 SCREW, 8-32 X 1/2, PHILLIPS HEAD 24 100408 WASHER, GROOVED BOOM 39 100625 O-RING, PTT, HEADSET

10 100364 SCREW, 8-32 X 3/8, PHILLIPS HEAD 25 100385 WASHER, SPRING, BOOM ADAPTER 40 100428 SWITCHGUARD, PTT, BLACK

11 100377 SCREW, 8-32 X 5/8, PHILLIPS HEAD 26 100369 EAR SEAL, FOAM FILLED 41 10 0317 BUTTON, SWITCH, PTT, RED

12 100108 SCREW, 4 X 1/4, THREAD FORMING 27 100374 FOAM, SOUND ATTENUATING. NOTCHED, 1/2 INCH 42 100257 OPTIONAL – HEADBAND, METAL, LARGE

13 100251 E-RING, EAR CUP TO YOKE RETAINER 28 100376 FOAM, SOUND ATTENUATING. RECEIVER HOLE, 1/2 INCH 43 100402 OPTIONAL – EAR SEAL, GEL FILLED

14 100252 NUT, HEX, 8-32, LOCKING 29 100379 FOAM, SOUND ATTENUATING, RECEIVER COVER, 1/4 INCH

15 100960 EAR CUP, PRINTED AND DRILLED, MICROPHONE SIDE 30 800046 CABLE, HEADSET, COILED

































 





















































10-1-2021

se-40rptt.pdf

Altri manuali Sigtronics Cuffia

Sigtronics

Sigtronics SE-8P Series Manuale utente

Sigtronics

Sigtronics SE-18T Manuale utente

Sigtronics

Sigtronics S-20H Series Manuale utente

Sigtronics

Sigtronics ST-18 Series Manuale utente

Sigtronics

Sigtronics ST-8 Series Manuale utente

Sigtronics

Sigtronics ST-11 Manuale utente

Sigtronics

Sigtronics SE-8 Series Manuale utente

Sigtronics

Sigtronics SE-40P Series Manuale utente

Sigtronics

Sigtronics SE-40RPTT Series Manuale utente

Sigtronics

Sigtronics S-ARH Manuale utente

Sigtronics

Sigtronics ST-48RPTT Series Manuale utente

Sigtronics

Sigtronics SE-18P Manuale utente

Sigtronics

Sigtronics S-18C Manuale utente

Sigtronics

Sigtronics ST-48P Series Manuale utente

Sigtronics

Sigtronics SE-48P Series Manuale utente

Sigtronics

Sigtronics S-41C Manuale utente

Sigtronics

Sigtronics SE-48P Manuale utente

Sigtronics

Sigtronics SE-48RVC Series Manuale utente

Sigtronics

Sigtronics SE-41T Series Manuale utente

Sigtronics

Sigtronics S-41 Series Manuale utente

Sigtronics

Sigtronics SE-40 Manuale utente

Sigtronics

Sigtronics ST-8S Series Manuale utente

Sigtronics

Sigtronics SE-18T Manuale utente

Sigtronics

Sigtronics S-45 Manuale utente

Manuali Cuffia popolari di altre marche

Sena

Sena SMH10 Manuale utente

IASUS

IASUS Stealth IA-NT4-BASIC-BT Manuale utente

Sennheiser

Sennheiser EPOS ADAPT 230 Manuale utente

Doro

Doro Flexus HS2005 Manuale utente

GE 98971 Manuale utente

Hama

Hama 00184070 Manuale utente

Plantronics

Plantronics Blackwire 3200 Series Manuale utente

Blue Tiger

Blue Tiger Advantage PLUS Manuale utente

Jawbone

Jawbone Icon Manuale utente

Jabra

Jabra FR 20 Manuale utente

Roxcore

Roxcore Flow A+ Manuale utente

Turtle Beach

Turtle Beach XP 510 Manuale utente

Philips

Philips SHB6101 Manuale utente

Jabra

Jabra PRO 9460 Duo Manuale utente

HyperX

HyperX HyperX Cloud Flight Manuale utente

Bose

Bose MIE2 Mobile Manuale utente

Jabra

Jabra Steel Manuale utente

HyperX

HyperX cloud ii Manuale utente