5. After the Seeker®’s external power is switched on, please
refer to How to pair with Silux Home®Devices.
6. Place the lid over the plastic and turn the lid clockwise.
Please make sure that the big pin on the lid slots into the big
groove on the back plastic.
IV. Replacing the AA 1.5V batteries:
There will be two AA batteries supplied with the product. The two
batteries will have a life span of 1 to 2 years, depending on the
sensitivity setting and how often the Seeker®is triggered.
1. Open the plastics by turning the top plastic anticlockwise and
removing the lid.
2. Pop out the two old AA batteries and replace it with two new AA
batteries. The Seeker®will now be powered on.
3. Place the lid over the plastic and turn the lid clockwise. Please
make sure that the big pin on the lid slots into the big groove on
the back plastic.
*Please Note: It’s not necessary to pair the Silux Home®
devices again after replacing the batteries.
V. How to pair with Silux Home®Devices:
1. Ensure the Silux Home®device you would like to pair is
powered on.
This can be any device excluding triggers such as the Touch
Lamina. Press the Teach button on the Silux Home® device in a
similar area or room to the Seeker position. The light will start
flashing.
2. Ensure the Seeker®is on, then press the Teach button on the
Seeker®. The light on the Seeker®will start flashing.
3. The light will switch off once successfully paired. If the light
stays on, the pairing was unsuccessful and you should wait for
30 seconds for the light to go off before trying again.
OFF
123
ON
4
Big Slot
Battery Cutout
Battery Cutout
Big Slot
Small Slot
Small Slot
Small Slot
6
We recommend testing your settings before permanent installation of the
Seeker®
II. Installing the Seeker®:
You have the option to mount the Seeker®on the ceiling using the supplied
screws or supplied 3M double sided tape.
1. Open the plastics by holding the back plastic firmly and turning the lid
anticlockwise.
2.1.1 If using screws use the backside plastics and mark with a pencil or pen
where your holes are going to be.
2.1.2 Drill holes in the ceiling and screw the back side against the ceiling.
2.2.1 If using the double sided tape, remove the first liner of the tape, apply the
tape to the backside plastics, let the adhesive set before you try and remove the
second liner.
2.2.2 Place the back side firmly onto the ceiling, where you would like your PIR
to be positioned and let it set.
3. Insert the two AA Batteries into the battery holders. The Seeker®will now be
powered on. You can keep an Eye on your battery levels using the Silux Control®
App. Please refer to “IV. How to pair with Silux Control®Devices”
4. Place the lid over the plastic and turn the lid clockwise.
Please make sure that the big pin on the lid slots into the big groove on the
back plastic.
III. Installing the external power supply:
There will be a Silux Control®external power supply included with the package.
You have the choice to install it. This will ensure that the Seeker®never runs flat.
1. Please make sure the power is off before supplying 110V AC – 230V AC to the
external power supply.
2. Push the connector through the back of the plastic
3. Plug the connector into the 5V socket on the Seeker®.
4. It is now safe to power the 110V AC – 230V AC back on again. The Seeker®
will also be powered on.
