INITIAL SET UP
1. Make sure the camera is OFF before adding or removing the
memory card!
2. Screw out the rear cap (open) located at the back of the camera
③.
3. Install a Micro SD memory card (max up to 32GB) into the rear
slot. To insert the micro SD card, slide the micro SD card into the
card slot on the back of the camera with the card label facing down.
The SD card will click into place once it is inserted past flush with
the camera. Use your fingernail to do this. Then screw in the rear
cap till is complete lock.
4. If “no” SD Memory card is inserted into the camera, a
Red/Green LED light on top of the camera will blink.
5. The Micro SD memory cards must be clean (no images from
other sources). If you are using the Micro SD memory card from
other cameras, please make sure to format the SD memory card in
your computer prior to use in the camera. New cards are good to
