Silvercrest KH 2198 Manuale utente
PROJECTION ALARM
CLOCK
PROJECTION ALARM CLOCK
Operating instructions
KOMPERNASS GMBH · BURGSTRASSE 21 ·
D-44867 BOCHUM
www.kompernass.com
ID-Nr.: KH2198_99-11/08-V2
KH 2198 KH 2199
CV_KH2198_99DT42360_LB6 15.12.2008 12:35 Uhr Seite 1
KH 2198
12
3
456
7
89
0
q
i
uztr e
w
KH 2199
1
23
4
5
6
7
8
9
0
q
i
u
ztre
w
CV_KH2198_99DT42360_LB6 15.12.2008 12:35 Uhr Seite 5
INDEX PAGE
Safety information 2
Intended Use 4
Items supplied 5
Operating Elements 5
Technical Data 6
Inserting the batteries 7
Placing 8
Operation 8
Cleaning and care 12
Disposal 13
Warranty and Service 13
Importer 14
- 1 -
Read these operating instructions carefully before using the device for the
first time and preserve this manual for future reference. Pass this manual on
to whoever might acquire the device at a future date.
IB_KH2198_99_DT42360_LB6.qxd 17.12.2008 11:32 Uhr Seite 1
PROJECTION ALARM CLOCK
KH2198/99
Safety information
To avoid potentially fatal injury through electric shock:
• Only use the device in dry rooms.
• Never allow fluids or objects to penetrate into the device.
• Do not place objects containing fluids, e.g. flower vases, on the device.
To avoid burn and other injuries:
• Place the device in an open and well-ventilated area so that heat pockets
cannot be created within it. Never cover the ventilation slits!
• Do not place open fire sources, e.g. candles, on the device.
• Avoid close proximity to heat sources, e.g. direct solar radiation, heaters
and other devices etc.!
• This device is not intended for use by individuals (including children) with
restricted physical, physiological or intellectual abilities or deficiences in
experience and/or knowledge unless they are supervised by a person
responsible for their safety or receive from this person instruction in how
the device is to be used.
• Children should be supervised to ensure that they do not play with the
device.
- 2 -
IB_KH2198_99_DT42360_LB6.qxd 17.12.2008 11:32 Uhr Seite 2
Note:
Only for KH2199: This device is equipped with non-slip rubber pads. As floor
and furniture upper surfaces comprise of various materials and are cleaned
with various types of polishes and/or cleaning agents, it cannot be completely
excluded that some of these substances contain components that could attack
the rubber pads and soften them. If possible place an anti-slip material under
the pads of the device.
Note:
In certain countries there could be exceptional regulations for the allocated
radio frequency ranges.
Take note that you may not exploit irregularly received radio services, pass
them on to third parties or improperly misuse them.
Information regarding the handling of batteries
The device uses batteries. When handling batteries, please observe the
following:
Explosion Hazard!
• Do not throw batteries into a fire. Do not recharge the batteries.
• Never open batteries, never solder or weld batteries. The risk of explosions
and injuries exists!
• Regularly check the condition of the batteries. Leaking batteries can cause
damage to the device.
• If you do not intend to use the device for an extended period, remove the
batteries.
- 3 -
IB_KH2198_99_DT42360_LB6.qxd 17.12.2008 11:32 Uhr Seite 3
• In the event of the batteries leaking acids, put on a pair of protective
gloves.
• Clean the battery compartment and the battery contacts with a dry cloth.
• Keep batteries away from children. Children could put batteries into their
mouths and swallow them. If a battery is swallowed, medical assistance
must be sought IMMEDIATELY.
Important !
No liability/warranty claims will be considered for damage to the device
caused by the effects of moisture, water penetration or overheating!
Intended Use
This device is designed to wake you by means of an alarm tone or radio and
also for the reception of radio transmissions. Any other usage of, or modifi-
cation to, the device is deemed to be improper usage and carries the risk
of serious personal injury. The manufacturer accepts no liability for damages
that result from an improper use of the device or that are caused by an in-
correct operation of it. It is not intended for commercial use.
- 4 -
IB_KH2198_99_DT42360_LB6.qxd 17.12.2008 11:32 Uhr Seite 4
Items supplied
1 Projection alarm clock with radio, 1 Operating manual
The batteries and a 3V-mains adaptor (accessories), required for operation,
are not included in the supply.
After unpacking the device, immediately check to determine that all listed
items are present and that the device is in a faultless condition. Remove all
packagng materials and the protective foil from the display.
Operating Elements
qProjection lens
wTelescopic antenna
eSwitch ALARM ON/OFF/AUTO
rButton SNOOZE
tWaveband selector FM/AM
yButton PROJECTION LIGHT, Display illumination
uSwitch PROJECTION ON/OFF
iDisplay
oSound volume regulator OFF/BUZZ/VOLUME
aConnection for 3V power adapter
sFrequency scale
dTUNING regulator
fButton TIME
gButton ALARM
hButton MIN (Minute)
jButton HOUR (Stunde)
kBattery compartment
lProjection focus (FOCUS)
- 5 -
IB_KH2198_99_DT42360_LB6.qxd 17.12.2008 11:32 Uhr Seite 5
Technical Data
This device has been tested and approved in accordance with the basic require-
ments and other relevent regulations of the EMC guidelines 2004/108/EC
as well as the guidelines for low voltage devices 2006/95/EC.
Battery operation:
KH2198: 3 x 1.5 V Type Micro / AAA / LR03 (not supplied) for radio
operation, display illumination and projection.
KH2199: 3 x 1.5 V Type Mignon / AA / LR06 (not supplied) for radio
operation, display illumination and projection.
Operating voltage : 3 V (Radio operation/Projection), 1.5 V (hour)
Frequency range :
FM (USW) : 87,5–108,0 MHz
AM (MW) : 530–1600 kHz
Mains adapter:
(Mains adapter not supplied)
Input voltage: 230 V ~50 Hz
Output voltage: DC 3V (+/- 5%)
Rated current: min. 300 mA
Polarity:
Even when using 3 V mains adapter, a battery must be inserted. Otherwise,
the clock will not function.
For Model KH2198: Insert the single battery into the upper part of the battery
compartment k. The two other batteries, one above the other, power radio
operation and the projection.
For Model KH2199: Insert the single battery into the compartment marked
“CLOCK USE”.
- 6 -
IB_KH2198_99_DT42360_LB6.qxd 17.12.2008 11:32 Uhr Seite 6
Important:
Ensure that you have the correct polarities with the batteries and the power
adapter.
False polarity will damage the device.
The device can be operated as follows:
• only with batteries ,
• with a mains power adapter and a battery for the clock.
Inserting the batteries
KH2198:
You require three 1.5 V batteries of the type Micro / AAA / LR03.
1. Open the cover of the battery compartment kon the underside.
2. Insert the three batteries into the battery compartment k, paying heed
to the polarity markings shown in the battery compartment k.
Ensure that the black textile strip is positioned under the batteries, this will
make future battery exchanges easier.
3. Close the cover, ensuring that it engages.
KH2199:
You require three 1.5 V batteries of the type Mignon / AA / LR06.
1. Open the cover of the battery compartment kon the underside.
2. Insert the three batteries into the battery compartment k, paying heed
to the polarity markings shown in the battery compartment k.
3. Close the cover, ensuring that it engages.
- 7 -
IB_KH2198_99_DT42360_LB6.qxd 17.12.2008 11:32 Uhr Seite 7
Placing
• Place the projection clock onto a level surface.
• Position the projection clock such that the projection lens qis directed onto
an empty surface. The distance from the projection lens to the projection
area (ceiling or wall) must lie between 0,4 m and 3 m.
With KH2198: Projection of the time must be directed to an area lying
behind the projection alarm clock. Otherwise, the time will be shown
back to front.
With KH2199: Projection of the time must be directed to an area lying in
front of the projection alarm clock. Otherwise, the time will be shown
back to front.
Operation
Connect the external mains adaptor
This device can be operated with an external mains adaptor.
Please use only mains adaptors that meet these specifications:
Input voltage: 230 V ~50 Hz
Output voltage: DC 3V (+/- 5%)
Rated current: min. 300 mA
Polarity:
Attention:
Make certain that the polarity is correct – both for the batteries as well as
for the mains adaptor. Take note of the markings on the 3V direct current
connection a.
False polarity will damage the device.
- 8 -
IB_KH2198_99_DT42360_LB6.qxd 17.12.2008 11:32 Uhr Seite 8
Altri manuali per KH 2198
2
Questo manuale è adatto per i seguenti modelli
1
Indice
Altri manuali Silvercrest Orologio
