6SEMD 12 A1
GB
IE
Making ice cream
CAUTION! MATERIAL DAMAGE!
► Start the appliance first and then add ingre-
dients. Otherwise the ice mixture will freeze
onto the sides of the beaker 8and block the
ice scrapers 7. This will cause the motor to
overheat!
CAUTION! MATERIAL DAMAGE!
► Do not stop the appliance during processing!
Otherwise the ice mixture will freeze onto
the sides of the beaker 8and block the ice
scrapers 7when the machine is restarted.
This will cause the motor to overheat!
1) Remove the beakers 8from the freezer and
put the appliance together as described in the
section "Assembly".
2) Switch the appliance on by moving the On/
Off switch 1to the position I. The two ice
scrapers 7start turning.
3) Now fill the prepared ice mixture into the beak-
ers 8through the filling openings 4. Ideally,
use a bowl with a spout. Never add more than
300 ml per beaker 8. During processing the
mixture increases in volume!
NOTE
► You can also fill only one beaker 8with
ingredients. However, always use the appli-
ance with both beakers.
NOTE
► The ice scrapers 7may occasionally change
their direction of rotation. This happens when
the mixture becomes too stiff. This is normal
and not an appliance defect.
4) Allow the appliance to continue running until
you are satisfied with the consistency of the
mixture. After a maximum of 20 to 30 minutes,
the ice cream is ready.
5) Switch the appliance off at the On/Off switch 1
and pull the mains power plug out of the socket.
6) Turn the rotary switch 9 to to remove the
lid 5with the motor unit 2.
7) Pull the ice scrapers 7out of the ice cream.
If the ice cream sticks to them, scrape it off with
a plastic spoon or similar.
8) Lift the beakers 8out of the appliance and
remove the ice cream. Use only plastic or
wooden implements to do this.
CAUTION! MATERIAL DAMAGE!
► Do not use metal utensils to remove the ice
cream from the beakers 8.
NOTE
► If you would like to replace the lid 5on
the beakers, you must first detach the motor
unit 2from the lid 5. Then proceed as de-
scribed in the section "Assembly". Otherwise,
it is possible that the drive shafts 3do not
slide correctly into the drive shaft socket 6.
IB_111458_SEMD12A1_FI_BE_NL.indb 6 05.03.15 10:27
