Simple S100 Manuale utente
User Guide
TM
© 2017 EcoFactor, Inc.
1
Introduction
*If you do not have a C-wire, or are not sure, visit www.thesimple.com/compatibility
The thermostat supports up to 2 stages of heating and
2 stages of cooling for conventional systems, and 2 stages of heating/
cooling for heat pumps, with and without emergency heat.
A common wire (C-wire) or other 24VAC power source is required.*
To sign up for an account and begin your installation, visit:
home.thesimple.com/install
To adjust settings remotely, or to create your personalized schedule, visit
home.thesimple.com, or install the Simple thermostat mobile app for iOS or
Android.
WARNING: Line voltage and millivolt systems are not supported.
2
Manual and Wiring Labels Screws and Wall Anchors
The wall plate comes snapped into
the back of the thermostat.
The optional trim plate can
cover unnished areas under the
old thermostat. It can be used
In the Box
3
Connect your system’s wiring using the table below.
Terminal Function
RC 24VAC for cooling.
RH 24VAC for heating. If there is only one R wire (R, RH, RC) then
connect it to RH. May be labeled V or VR for Lennox.
C Common wire. May be labeled X for Rheem, Ruud, or Lennox;
B for Trane, York.
Y 1st stage compressor, A/C or heat pump. May be labeled M
for Lennox.
Y2 2nd stage compressor, A/C or heat pump.
W/E 1st stage heating, or heat pump emergency heat. Some
heat pumps may designate emergency heat as E or X2, or
auxiliary heat as W1 or W2. May be labeled Y for Lennox.
W2 2nd stage heating. Not used for heat pumps.
O/B Heat pump changeover valve.
Wiring Guide
4
A
B
C
D
J
I
H
E
F
G
Display
5
Outside temperature, shown when your
account is congured with a ZIP code.
Indoor temperature.
Error/warning indicator.
The message line provides information to
the user and displays the menu options.
Fan indicator, ashes when running.
Mode indicator, the heat or cool icon ashes
when running. Automatic mode switching
occurs when AUTO is shown.
Efciency indicator when energy saving
settings are applied.
Temperature setting for the current mode.
Lock indicator when front panel is locked.
Status display for Hold, Away duration, and
energy management events.
A
B
C
D
E
F
G
H
I
J
6
MODE AWAY
DOWN
UP
MENU
Buttons
7
Function
During Thermostat Operation While in Menu
UP increases the temperature
setting.
Previous menu item.
DOWN decreases the
temperature setting.
Next menu item.
MENU enters and exits the
Settings menu.
Return to previous menu.
MODE changes the system
mode, and cancels Hold, Away,
Utility Event, or Efciency
adjustments.
Selects current item or
enters sub-menu.
AWAY enters timed energy
saving settings. Press again
to exit.
Return to previous menu.
8
You can select whether Heat or Cool is provided using the circular MODE
button. The MODE button cycles sequentially through the available modes.
Only the modes supported by your system are shown. For example, a
furnace-only installation alternates between OFF and HEAT when the
MODE button is pressed. A conventional system with both heating and
cooling will cycle through OFF, HEAT, COOL, and AUTO each time MODE is
pressed.
If your system supports both heating and cooling, Auto Mode is a
convenient setting to automatically switch between Heat and Cool mode.
Changing Modes
Altri manuali per S100
1
Indice
Altri manuali Simple Termostato
