PRODUCT COMPLIANCES
MANUFACTURERS EXTENDED WARRANTY
Product tested and complies to:
EN 60598-1:2009, EN 60598-2-1:, EN 62493:2010, EN 62471:2008,
EN 55015:2009, EN 61547:2009, EN 61000-3-2:2009, EN 61000-3-3:2008
This product is guaranteed by SIMX Ltd for 36 MONTHS from the date of purchase against faulty
materials or workmanship which affects its designed ability to operate. During this period if the product
has a defect of this nature it will be repaired or replaced free of charge by SIMX with the same item,
or a similar item, or a similar one of higher specification. ON CONDITION THAT:
The buyer returns it to the seller from whom it was bought, freight paid.
The product has been bought by the user. ie a receipt/sales invoice is produced
as proof of purchase.
The product has not been misused or handled carelessly, installed in anyway contrary to the installation
instructions, or installed in any unusually exposed or harsh environmental conditions.
This guarantee excludes liability for discolouration of paint or plastic, or any user replaceable parts.
It does not confer any rights other than those expressly set out above and does not cover any claims
for consequential loss or damage.
Our Goods come with guarantees that cannot be excluded under the Australian and New Zealand
Consumer law. You are entitled to a replacement or refund for a major failure and for compensation for
any other reasonably foreseeable loss or damage. You are also entitled to have the Goods repaired
or replaced if the Goods fail to be of acceptable quality and the failure does not amount to a major failure.
INSTALLATION
Unclip the front decorative cover attached to the base unit.
Using the luminaire as a mounting template, locate the fitting against the desired mounting location
and mark the wall through the mounting holes. Drill appropriate diameter holes in the wall to
suit the mounting screws supplied.
Remove the clear front lens from the luminaire. Pierce the centre of the cable entry gland,
and feed power supply cable through this and wire to the terminal block (Brown is L and Blue is N).
Failure to maintain polarity may result in irrepairable damage to the light. Note to retain IP rating,
round core cable must be used.
Resecure the clear front lens to the unit firmly using the screws supplied.
Locate luminaire over the pre-drilled mounting holes, and fix unit firmly to the wall.
Switch on power supply and test operation.
Select one of the front decorative covers supplied and click into place. The unrequired front covers
are fully recyclable and can be disposed of via your plastics recycling bin.
PUB1295 2206
Distributed in Australia by Ventair Pty Ltd.
4 Capital Place, Carrum Downs, 3201 VIC, AUSTRALIA.
Technical Support: 1300 665 926
e: info@ventair.com.au | www.ventair.com.au
Distributed in New Zealand by Simx Ltd
Ph: +64 9 259 1660 | Technical Support Ph: +64 9 259 1662
Specifications are subject to change without notice
