SKC Quick Take 15 Manuale utente

Operating Instructions

Catalog No. 228-9515

SKC Inc.

863 Valley View Road

Eighty Four, PA 15330 USA

Form #40076—Rev 0710

Table of Contents

Quick Guide................................................................................1

Description..................................................................................2

Performance Prole....................................................................3

Operation....................................................................................5

Mounting Sampling Media..........................................................7

Calibration and Setting Flow.......................................................8

Setup ..........................................................................................9

Sampling...................................................................................11

Advanced Setup .......................................................................13

Maintenance.............................................................................17

Battery Operation .....................................................................19

Cautions and Warnings ............................................................19

Service Policy...........................................................................20

Warranty...................................................................................21

Ordering Information.................................................................22

Notice: This operating instruction may not address all safety concerns (if any) associated

with this product and its use. The user is responsible for determining and following the

appropriate safety and health practices and regulatory limitations (if any) before using

the product. The information contained in this document should not be construed as legal

advice, opinion, or as a nal authority on legal or regulatory procedures.

QuickTake 15 Quick Guide

Terms »

Star Button 

Turns on LED, toggles between displays, and exits without saving

Up and Down Arrow Buttons 

Scroll through presets, increase or decrease sampling parameters, and toggle

between setup options

Button Sequence

or = Press individually.

[] = Press both simultaneously.

= Security code, press in sequence

Programming Sequences »

• To activate pump LED:

Press and hold for 2 seconds.

• To check battery status:

Press .

• To choose a run time preset:

Press or to scroll through presets. Once desired preset displays,

press [] to start sampling.

• To Run or Hold:

Press [].

• To repeat a sample run:

From Done, reset (rSEt), or sampling error (SErr), press [] to return to

run time preset. Press [] to sample.

• To change or calibrate ow:

Note: Flow rate does not appear on LED.

Press or and scroll to a run time preset. Press and hold CAL for 2 seconds.

(Does not require a security code.) Press or  to change ow rate until desired

ow appears on calibrator. Press . When Stor displays, press [] to save

setting or  to ignore changes to ow setting.

• To interrupt run, terminate a sample, or reset pump:

While in Hold, press . Sample reset (rSEt) will display. Press [] to reset

pump or to ignore reset and return to Hold.

www.skcinc.com

SKC Inc., 863 Valley View Road, Eighty Four, PA 15330

Description

The QuickTake® 15 is a portable, baery-powered air sampling pump designed

specically to provide constant airow for the short sampling times required for mold

screening. QuickTake 15 allows timed samples to be taken within the ow range of

5 to 15 L/min. A diaphragm pump operating with a closed loop ow control

system, the QuickTake 15 maintains constant ow and is suitable for use with

spore trap cassees such as VersaTrap, wall cavity samplers, the BioStage 200

impactor, and lter cassees including microvacuum cassees. The QuickTake

15 features a programmable timer that provides up to eight programmable

run time presets of 1 to 999 minutes, continuous run with manual shut-o, or

intermient sampling. A rechargeable lithium-ion baery pack provides run

times up to four hours.

Charging jack

(on side of case,

not shown)

High-contrast LED

display for readout

of presets, run time,

and battery status

Calibration mode

button

Up arrow

increases ow

and time and

scrolls through

presets

Inlet

(shown without adapter)

LED indicates

active battery

charging

Down arrow

decreases ow

and time and

scrolls through

presets

Star button

activates LED and

toggles between

displays

Speaker for end of

timed run alarm

Printed Quick Guide

Tubing Adapter

Cassette Adapter

Ring for shoulder

strap attachment

QuickTake 15 Performance Prole

Flow range: 5 to 15 L/min

Flow compensation

accuracy: ± 5% of set ow

Compensating ow

back pressure range: 15 L/min at 8 inches water back pressure

10 L/min at 15 inches water back pressure

5 L/min at 20 inches water back pressure

Power: Rechargeable 7.2-volt lithium-ion (Li-Ion) battery (see Li-Ion Battery

Shipment on page 4), or battery with standard AC charger/adapter

(115 V), or battery with deluxe AC charger/adapter (100-240 V)

Battery recharge time: Approximately 5 hours

Typical Run time: VersaTrap Cassette: 4 hours at 15 L/min

Results when tested with a new pump and new fully charged

battery. Pump performance may vary.

The AC charger/adapter can be used to extend baery run

time, but it is not a baery eliminator. Therefore, it will

not provide indenite run times.

Temperature: Operating: 32 - 113 F (0 - 45 C)

Storage: -4 - 113 F (-20 - 45 C)

Charging: 32 - 113 F (0 - 45 C)

Protect sample pump from weather when in use outdoors.

Run time features: User-selectable features, user-adjustable presets (see Advanced

Setup)

Preset timed runs: 1, 2, 5, 10, or 15 min

Manually set continuous

run with manual shut-off: 1 to 999 min (repeats 1 to 999-min

runs indenitely until user stops

pump or power supply is depleted)

Intermittent sampling: See Advanced Setup

Flow fault features: If the pump is unable to compensate due to excessive back pressure,

the pump will go into ow fault mode (see page 12 for details). Flow

fault features are enabled as the default setting. Flow fault may be

disabled at the user’s option. See Advanced Setup.

Flow fault: Flow fault displays immediately.

Pump shuts off after 5 seconds

Fault restart: Pump attempts restart every

10 seconds up to ve times

Compare the information in this table to pump compensation range to determine appropriate applications.

Typical Back Pressure of Sampling Media (inches water)

Flow Rate (L/min) 5.0 8.0 10.0 12.0 15.0

Filter/Pore Size (µm)

37-mm MCE/0.8 11 18 22 28 36

37-mm PVC/5.0 4 7 9 11 15

Media compatibility: VersaTrap and other bioaerosol cassettes, wall cavity samplers,

BioStage® 200 impactor, and other lter cassettes including

microvacuum cassettes

Housing: ABS plastic

Dimensions: 10.3 x 4.6 x 2.4 in (26.2 x 11.7 x 6.1 cm)

Weight: 32 oz (907 g)

Approvals: CE (models with 223-245 charger only)

Li-Ion Battery Shipment

Rechargeable, lithium-ion batteries for use with SKC sampling pumps have been

tested in accordance with the UN Manual of Tests and Criteria and are designated as

UN3091.

For air shipments:

Rechargeable lithium-ion batteries in SKC pumps are subject to the A-45 exemption to

the IATA regulations and are not regulated for air shipments. This information must be

written on the shipping document when shipping by air.

For ground shipments:

US DOT regulations specify a limit of 24 or fewer battery cells in one shipping box. If

you exceed 12 QuickTake 15 pumps with battery packs in one shipping box, specic

shipping requirements must be followed. Contact SKC for more information or refer to

the regulatory authority in your area.

Indicates a warning, caution, or note.

www.skcinc.com

See http://www.skcinc.com/instructions/1721.pdf for more information

on maintaining, disposing, and shipping Li-Ion batteries.

Operation

Button Sequence

Buons must be pressed in the sequence

shown.

or  = Press individually

[] = Press both simultaneously

 = Security code, press in sequence

Operating the Pump

• To activate LED:

Press and hold  for 2 seconds.

• To check battery status:

With the LED on, press .

Battery Status Indicators

Full charge; approximately 75% to 100% baery capacity

remaining.

Baery is charged enough to operate the pump;

approximately 25% to 75% baery capacity remaining.

Baery charge is low (charge baery); approximately

1% to 25% baery capacity remaining.

Low Baery Fault. Pump will stop running, beep, and

go to sleep in 10 seconds.

• To operate from AC power:

The QuickTake 15 may be run using AC power with the AC charger/

adapter with baery. Insert the charger plug into the jack on the pump

and the charger into a standard wall outlet. Operate the pump.

The charge light on the LED will ash if the battery is charging during AC

operation.

The AC charger/adapter can be used to extend battery run time, but it is not a

battery eliminator. Therefore, it will not provide indenite run times.

Indice

Altri manuali SKC Pompa dell'acqua

Manuali Pompa dell'acqua popolari di altre marche

Neptun

Neptun NPHW 5500 Manuale utente

Sensidyne

Sensidyne Gilian BDX-II Istruzioni per l'installazione e il funzionamento

Draper

Draper 47808 Manuale utente

Trolla

Trolla 12820 Manuale utente

Sunfab

Sunfab SVH Series Manuale utente

WilTec

WilTec 50740 Manuale utente

Fieldmann

Fieldmann FVC 5015 EK Manuale utente

Everbilt

Everbilt EFSUB5-122HD Manuale utente

Graco

Graco Husky 3300e Manuale utente

esotec

esotec 101018 Manuale utente

moyno

moyno 2000 CC Manuale utente

Becker

Becker BASIC VASF 2.80/1-0.AC230 Manuale utente

Sykes AmeriPumps

Sykes AmeriPumps GP100M Guida alla risoluzione dei problemi

DUROMAX

DUROMAX XP WX Series Manuale utente

BRINKMANN PUMPS

BRINKMANN PUMPS SBF550 Manuale utente

Franklin Electric

Franklin Electric IPS Manuale utente

Xylem

Xylem e-1532 Series Manuale utente

Milton Roy

Milton Roy PRIMEROYAL Manuale utente