Sky Ready RC Cobra Manuale
Cobra / Cobra Lite Build Instructions
Cobra / Cobra Lite Build Instructions
Parts List:
(2) Aluminum CLS plates
(1) Carbon fiber bottom plate (3mm)
(1) Carbon fiber top plate (2mm)
(4) Carbon fiber arms (5mm)
(4) 25mm aluminum standoffs
(1) TPU camera mount
(1) TPU eccentric camera bushing (left)
(1) TPU eccentric camera bushing (right)
(1) TPU SMA antenna mount
(1) TPU receiver antenna tube holder
(1) Receiver antenna tube
(2) Receiver antenna tube caps
(2) 2x6mm camera screws
(2) 1mm camera screw washers
(4) 3x16mm screws
(4) 3x10mm screws
Cobra / Cobra Lite Build Instructions
Step 1: Insert two arms into an aluminum CLS plate. Make two.
X2
Cobra / Cobra Lite Build Instructions
Step 2: Place the bottom plate into corresponding slots in the CLS plates. The single triangular cutout in the bottom
plate indicates the front of the quad.
Cobra / Cobra Lite Build Instructions
Step 2 (Continued):
Cobra / Cobra Lite Build Instructions
Step 3: Install (4) 3x16mm screws into the four holes in the bottom plate. Use blue (medium) thread lock. Install (4)
25mm standoffs onto the screws.
Cobra / Cobra Lite Build Instructions
Step 4: Press the eccentric camera bushings into the camera mount from the outside of the camera mount. The
bushings should fit flush with the sides of the camera mount when installed properly. The bushings have an off-center
hole, allowing the camera mount to be compatible with different length camera lenses. Orient the bushings so that
your camera lens does not stick out too far, but also so the top plate is not in view.
Step 5: Slide all TPU parts onto the standoffs as shown.
Cobra / Cobra Lite Build Instructions
Step 6: Place the top plate on the standoffs, and secure with (4) 3x10mm screws.
Cobra / Cobra Lite Build Instructions
Step 7: After assembling the frame, feed your receiver antenna wires into the back (smaller) holes of the TPU antenna
tube holder and run them out the front (larger) holes. Cut the antenna tube to the length of your exposed receiver
antenna wires. Slide the receiver antenna into the antenna tube and press the antenna tube into the hole of the TPU
antenna tube holder on each side. Place an antenna tube cap on each antenna tube.
Cobra / Cobra Lite Build Instructions
Exploded View
Questo manuale è adatto per i seguenti modelli
1
Indice
Altri manuali Sky Ready RC Drone
