Skydigital Mini Bee Istruzioni operative

Mini Bee

USB 2.0 / IEEE1394 Mobile Storage

Installation and Operation Guide

Mini Bee

Skydigital Co., Ltd.

Contents

Importantsafeguards 1

SmartDrivepartlist 1

Installing the Smart Drive 2

System requirements for IBM compatible PCs 6

Windows95/98/Meinstallation 7

Windows 2000 / XP installation 8

System requirements for MAC 10.0 compatible PCs 10

Software/Hardwaretechnicalsupport 11

FCCWarningstatements 12

Important safeguards

The following instructions pertain to the risk of fire, electric shock, or bodily

injury

Please read all of these instructions carefully.

1.Follow all the instructions and cautions marked on this product or included in

the manual.

2.Never push object of any kind into the product through any of the cabinet

openings, as this may short out part that could result in damage to the product.

3. Never spill liquids of any kind into the product.

4. Do not disassemble or try to repair the PCB. Doing so voids your warranty.

5. Do not operate your product if the PCB or cable is broken,

split, or damaged in any way.

Mini Bee parts list

Smart drive

FireWire Interface Cable (6Pins to 6Pins_1.0m)

FireWire Interface Cable (6Pins to 4Pins_1.0m)

USB Interface cable (Type Ato Type Mini B_1.0m)

Power Cable (From PS/2_1.0m)

Install driver CD

M3 screw 5 pcs , 1.5 Tap screw 6 pcs

User manual, +mini driver, Bag

Inserting the Drive (HDD)

1. Hold both sides of the Mini Bee where it is not secured with the

screws. Disassembly the Mini Bee by gently pulling the PCB

from the case.

2. Connect the hard disk to the PCB’s connector (44 pins).

Use the left side pin No.1 as the reference

when connecting it.

(Check it again.)

Note: 4 pins left on the right side of the HDD are used to set

Master/Slave. Therefore, do not connect to the PCB connector.

3. Place 4 screws to each point of the hard disk.

4. Insert the HDD assembled to the PCB in the case.

5. Secure the HDD to the case with screws on each side of the case.

Tighten the screws with the screwdriver.

Operational Environment for IBM compatible PCs

IBM compatible PCs (Pentium or higher)

Where USB port is available

Built-in CD-ROM DRIVE or where DRIVER can be

downloaded from the Internet.

* Precautions when handling the Smart Drive

Avoid any shock since the Mini Bee is vulnerable to even a

small shock.

Storing at a high temperature for a long time may cause damage

to the Mini Bee

Avoid storing at a place with high humidity

Installation of the Driver

* Precautions

1) Run Tppinst.exe before connecting the Mini Bee.

2) Using hard disk with 2GB or lower may cause a data damage and

others.

3) Use HDD with 2GB or higher.

1) Your computer cannot read the new hard diskette if it is not

formatted with the Fdisk(Dos command).

2) Therefore, format the new diskette with the Fdisk (Dos command).

1.Windows 95/ 98/ ME/ 2000 User

1) Before connecting the Smart Drive, insert the provided CD to the CD-

ROM drive.

2) Open USB folder located under the PCB folder in CD-ROM. Execute

“Tppinst.exe” and click “Next”.

3) Select “complete” from Setup Type and click “Next”. The

installation of the driver is completed.

4) Connect the USB cable to the Mini Bee.

5) Connect the other side of the USB cable to the USB port of the

computer.

6) <HDD model (Example: SAMSUNG SV4002H USB Disk) etc.> USB

DEVICE is displayed.

7) Exit to “USB Disk”. Then, Drive icon is created in “My Computer”.

2.Window XP User<for USB1.1(1)>

1) Before connecting the Smart Drive, perform booting of the Windows

XP.

2) Insert the provided CD to the computer’s CD-ROM drive.

3) Open USB folder located under the PCB folder in CD-ROM. Execute

“Tppinst.exe” and click “Next”.

4) Select “complete” from Setup Type and click “Next”. The

installation of the driver is completed.

5) Ignore the message indicating that the Windows logo test to check the

compatibility of the Windows XP is not completed. Then, click

“Next”.

6) Select “Install the software automatically (recommended)” when the

Installation Wizard of the new hardware is executed.

7) Ignore the message indicating that the Windows logo test to check the

compatibility of the Windows XP is not completed. Then, click

“Next”.

8) Click “Exit” when completion of new hardware’s Search Wizard is

displayed.

9) Perform booting of the Windows XP.

10) Connect the USB cable to the Mini Bee.

11) Connect the other side of the USB cable to the USB port of the

computer.

12) <HDD model (Example: SAMSUNG SV4002H USB Disk) etc.>USB

DEVICE is displayed.

13) Exit to “USB Disk”. Then, Drive icon is created in “My Computer”.

3.Windows XP User<for USB2.(1)>

1) Perform booting of the Windows XP.

2) Connect the USB cable to the Mini Bee.

3) Connect the other side of the USB cable to the USB port of the

computer.

4) Finished.

4.Checking the installation of the driver

Check the installation of the driver from the

operating system (OS).

1) For the Windows 98/ME

Setting →Control →System →Device Manager →Universal

serial bus controller.

2) For the Windows 2000for USB1.1(1)

Setting →Control →System →Hardware →Device Manager →

General serial bus controller

3) For the Windows XP

Setting →Control →System →Hardware →Device Manger →

General serial bus controller

4) For the Windows XPfor USB2.0(1)

Setting →Control →System →Hardware →Device Manger →

General serial bus controller

5.How to stop the use of the Mini Bee.

To remove the Mini Bee during the use, follow the steps below.

1) Click the “Tray icon” located at the bottom of the screen. Then, the

following message is displayed.

2) Remove the Mini Bee from the USB port.

Operational Environment for MAC compatible PCs

1) MAC compatible PCs OS 10.0.

2) Install ISD Storage Driver before connecting

the Mini Bee..

3) You must format the hard disk from IBM compatible PCs.

Install ISD Storage Driverbefore connecting

the Mini Bee..

Reboot computer.

connecting from MAC compatible PCs to the Mini Bee..

Software / Hardware technical support

For technical support on Mini Bee Software / Hardware visit the

Corevalley WEB site at

www.skydigital.co.kr

or contact one of the following support centers:

Corevalley Technology Support Center

Telephone : +82-2-712-8545

E-mail: [email protected]

FCC Warning Statements

Note: This equipment has been tested and found to comply with the limits for

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a

residential/office installation.

This equipment generates, uses and can radiate radio frequency energy and, if

not installed and used in accordance with the instructions, may cause harmful

interference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation.

If this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more of the

following measures:

· Reorient or relocate the receiving antenna.

· Increase the separation between the equipment and receiver.

· Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected.

· Consult the dealer or an experienced Radio/TV technician for help.

CAUTION: Changes or modifications not expressly approved by the party

responsible for compliance could void the user’s authority to operate the

equipment.

Manuali Magazzinaggio popolari di altre marche

QNAP

QNAP TS 32PXU Series Manuale utente

LaCie

LaCie RUGGED RAID Manuale utente

Freecom

Freecom CLS DOCK Manuale utente

PNY

PNY Attache P-FD64MBATT3 Manuale utente

HP StorageWorks MSL2024 Manuale utente

OLT

OLT 6x6 Maximizer Manuale utente

Transcend

Transcend JetFlash 160 Manuale utente

LaCie

LaCie RUGGED MINI Manuale utente

Thunderbolt

Thunderbolt 600 Manuale utente

Panasonic

Panasonic LB-DH8 series Manuale

Intel

Intel RAID High Availability Manuale utente

LaCie

LaCie 12big Thunderbolt 3 Manuale utente

Spectra Logic

Spectra Logic T-Series Spectra T50e Manuale utente

Panasonic

Panasonic LKM-F931-1 Manuale utente

Tabernus

Tabernus Enterprise Erase E2400 Manuale utente

Rocstor

Rocstor COMMANDER 3F series Manuale utente

HP P9000 Manuale utente

Western Digital

Western Digital Ultrastar Data60 Manuale utente