SKYLOTEC ICX Manuale utente
Translated versions
Introduction A
Product safety
& system description B
Rope C
Lifting systems &
equipment setup D
Battery care E
How to use the Ascender F
Service & maintenance G
Warranty terms H
Technical information I
MAT-BA-0301
Rev 2-2024 ENG MASTER Original Instruction
ICX
User manual
POWER
ASCENDER
DISCLAIMER
WARNING
Training and experience are required to lower the risk
of serious bodily injury or death.
This user’s manual provides general information about safe
operation and risks associated with the use of the SKYLOTEC
ActSafe ICX Power Ascender. It also gives details of maintenance
procedures.
Never use the equipment unless you have read and understood
this manual and completed a SKYLOTEC approved training in the
use of the power Ascender system. SKYLOTEC Nordic AB, our
partners and subsidiaries, disclaim any liability for damages,
injuries or death resulting from the use of the equipment which is
not in compliance with this manual.
This manual may be updated without notice.
For more information about updates and safety warnings,
visit www.skylotec.com
Failure to read and follow
the instructions within
this manual may result
in re, damage to property,
personal injury or death.
4
A
INTRODUCTION
About SKYLOTEC A.01
About this manual A.02
Denitions A.03
FOREWORD
Thank you for choosing the SKYLOTEC
ActSafe ICX Ascender.
This Ascender has been designed as
an ultra-portable and versatile lifting tool
for lifting people or equipment in a safe
and effective way. It revolutionises working
in a vertical environment.
BE AWARE:
A Power Ascender is a hi-tech tool
and should be treated with care.
5
AA.01 ABOUT SKYLOTEC
SKYLOTEC is a pioneer in developing
powered Rope Ascenders and has been
delivering high-performance powered
equipment since 1997.
SKYLOTEC has a worldwide distribution
network of dedicated experts selling our
innovative products to a wide variety of
users. Our Power Ascenders have been
successfully used for installing reworks at
the top of the Eiffel Tower, hostage rescue
from pirates at sea and providing essential
logistical support in offshore wind turbines.
SKYLOTEC products are redening the
possibilities for work in vertical environments.
We are completely committed
to our customers and do our
utmost to deliver top quality
products and service.
6
i
A.02 ABOUT THIS MANUAL
This manual gives detailed information on
features and safety. However, this manual
cannot replace the need for training and
experience. The Ascender must only be
used by operators who have undergone
the SKYLOTEC-approved training.
Safety messages of extra importance
are highlighted throughout this manual
using the signals ‘danger’, ‘caution’,
’note’ and ’recommendation’.
RECOMMENDATION
Instructions and tips on how best
to use the Ascender.
DANGER
CAUTION
Not following instructions or training
methods may result in SERIOUS
BODILY INJURY or DEATH.
Not following instructions or training
methods may result in BODILY INJURY,
or DAMAGE TO PROPERTY.
Note
Important information on the use of the
equipment used with the Ascender.
7
A.03 DEFINITIONS
Active/loaded rope
Loaded end of the work-positioning
rope system.
Anchor
Attachment point for rope or Ascender.
Ascending
Moving up the rope.
Backup system
A rope system which captures the load in
case of primary rope failure.Approved
according to backup system requirements
with backup device according to EN 12841-A,
EN 353-2 or equivalent certied device.
Competent Person
Operator with adequate training,
experience and certication.
Descending
Moving down the rope.
Passive/dead rope
Unloaded end of the work-positioning
rope system.
Primary rope
Work rope system used with Ascender.
Rope must be 11 mm (7/16”) and
approved according to EN 1891 A
or be an Equipment Lifting Rope
depending on the application.
User/operator
Operator of the Ascender, either by
the Throttle or by the Remote Control.
Secondary rope
See ‘Backup sytem’.
SWL
Safe Working Load. The maximum load
(as certied by a competent person) that an
item of lifting equipment may raise, lower or
suspend under particular service conditions.
WLL
Working Load Limit. The maximum
load that an item of lifting equipment
is designed to raise, lower or suspend.
8
B
PRODUCT SAFETY
& SYSTEM DESCRIPTION
Product safety B.01
Usage exclusions B.02
System description B.03
Rope mechanism B.04
9
v
B
B.01 PRODUCT SAFETY
SKYLOTEC Ascender operators must, before rst use, have undergone
training in the safe use of the Ascender by either SKYLOTEC or by a
SKYLOTEC-approved training partner.
The SKYLOTEC Ascender must be checked before every use by
a Competent Person and must undergo a minimum of one inspection
per year by SKYLOTEC or a SKYLOTEC-authorised person.
More frequent inspections may be required by your national regulations.
10
Indice
Altri manuali SKYLOTEC Attrezzatura di sicurezza
SKYLOTEC
SKYLOTEC HSG Series Manuale utente
SKYLOTEC
SKYLOTEC SKYVEST Manuale utente
SKYLOTEC
SKYLOTEC MAT-BA-0140-00 Manuale utente
SKYLOTEC
SKYLOTEC SKYLINE 2.0 Manuale utente
SKYLOTEC
SKYLOTEC MAT-BA-0205-00 Manuale utente
SKYLOTEC
SKYLOTEC MAT-BA-0130 Manuale dell'operatore
SKYLOTEC
SKYLOTEC DEUS 3300 Manuale utente
SKYLOTEC
SKYLOTEC SECUPIN SPA-TYP-1-L Manuale utente
SKYLOTEC
SKYLOTEC ERGOGRIP SK 16 Manuale utente
SKYLOTEC
SKYLOTEC MARK 1 PLUS Manuale utente
SKYLOTEC
SKYLOTEC KOMPAKT Manuale utente
SKYLOTEC
SKYLOTEC MARK 1 PLUS Manuale utente
SKYLOTEC
SKYLOTEC Climbing Technology Visor G Manuale utente
SKYLOTEC
SKYLOTEC SKN Series Manuale utente
SKYLOTEC
SKYLOTEC Climbing Technology DOBLE Manuale utente
SKYLOTEC
SKYLOTEC CT CLICK UP Manuale utente
SKYLOTEC
SKYLOTEC SIRIUS Manuale utente
SKYLOTEC
SKYLOTEC ACX Manuale utente
SKYLOTEC
SKYLOTEC Sirro 2 Manuale utente
SKYLOTEC
SKYLOTEC RIDER 3.0 Manuale utente
