SkyPilot SkyConnector Mini Manuale utente
www.skypilot.com
SkyConnector Mini
User Guide
USER INSTRUCTIONS
1. Launch web browser and type 192.168.0.2 to access Mini
2. Username = "admin" Password = "public"
Wireless
Frequency band 5.250-6.075 GHz
Transmit power 24 dBm/250mW (6 Mbps)
Antenna 14 dBi (55° azimuth x 18° elevation)/vertical polarity
EIRP 38 dBm/6 W (6 Mbps)
Receive sensitivity -94 dBm at 6 Mbps modulation
Range Up to 7.5 miles (12 km)
Media access Time Division Duplex (TDD)
Modulation technique OFDM with adaptive modulation
Modulation rates 54, 48, 36, 24, 18, 12, 9, and 6 Mbps
Throughput Up to 13 Mbps TCP/20 Mbps UDP (at 36 Mbps modulation rate)
Latency 8-10 ms roundtrip per hop
Channel width 20 MHz
Channel resolution 5 MHz frequency control
Authentication RSA-based certificates
Encryption 128-bit AES
Product Specifications
Enclosure Outdoor UV stabilized plastic
Connectors (under RJ-45 to 12V/1A Power over Ethernet (PoE) injector
waterproof sliding door) (Optional) reverse-polarity SMA to external antenna
Power 100-240 VAC, 50-60 Hz input; 5 Watts
Mounting Pole mount (standard), wall mount (optional), or window suction mount (optional)
LEDs Power, Ethernet, and wireless signal strength
Dimensions 10.4”(26 cm) H x 3.2”(8 cm) W x 1.2”(3 cm) D
Weight 0.9 pounds (0.4 kg)
Operating temperature -4° to 158° F (-20° to 70° C)
Operating humidity 5 to 95% condensing
Certifications FCC Part 15.247, IC RS210, CE, ETSI 300-019-1.4 shock and vibration, RoHS
Warranty One-year limited warranty on hardware; 90-day limited warranty on software
SkyConnector Mini Specifications
Traffic Management
• VLAN support: IEEE 802.1q
• Traffic Prioritization:IEEE 802.1p,
protocol type, IP port,IP ToS field,
and IP address list
• Traffic Filtering: protocol type, IP
port, and IP address list
• Traffic Shaping: upstream and
downstream per-user rate control
Configuration, Management,
& Monitoring
• NMS integration: SNMPv2c
• EMS: SkyControl™
• IP address: DHCP or static
• Firmware:Multiple versions stored
in nonvolatile memory; updated
over the air via FTP
• Provisioning:Manual or automated
• Configuration file:XML over HTTP
• MIB support:MIB-II (RFC 1213);
EtherLike (RFC 2665); Bridge (RFC
1493); SkyPilot private MIB
• Remote management: CLI via
Telnet, SNMPv2c
www.skypilot.com
www.skypilot.com
NOTE: This equipment has been tested and found
to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to pro-vide reasonable
protection against harmful interference when the
equipment is operated in a commercial
environment. This equipment generates, uses, and
can radiate radio frequency energy and, if not
installed and used in accordance with the
instruction manual, may cause harmful
interference to radio communications. Operation
of this equipment in a residential area is likely to
cause harmful interference in which case the user
will be required to correct the interference at his
own expense.
!
Changes or modifications not expressly approved
by the party responsible for compliance could void
the user’s authority to operate the equipment.
ADDITIONAL INFORMATION AND COMPLIANCE
This is a Point-to-Point CPE Wireless Device.
Altri manuali SkyPilot Router di rete
Manuali Router di rete popolari di altre marche
NETGEAR
NETGEAR FS526T - Switch Manuale utente
Korenix
Korenix JetNet 5710G Series Manuale utente
Automated Logic
Automated Logic ZN551 Manuale del proprietario
Cisco
Cisco ASR 1000 Series Manuale dell'operatore
EnGenius
EnGenius ESR-9710 Manuale utente
Cisco
Cisco 805 Series Istruzioni operative e di sicurezza