
22 23
Turn on:
By connecting the battery to the lamphead it turns on automatically. The lamp can also be switched on by a short
press on the button of the lamp head. Depending on the ambient light, the SL starts lighting either with low beam
or daytime running light. Note: Only in the dark when the low beam is activated, it‘s possible to switch into high
beam.
Turn off:
To turn off the lamp, keep the button pressed for about 2 seconds.
Operation
Light mode:
A brightness sensor automatically switches between daytime running light and low beam.
Bluetooth remote control:
In order to save battery capacity, the remote connection between the lamp and remote control stays active for
only 1 hour when the lamp is switched off (standby) and the lamp can be switched on immediately at any time.
After that, the lamp may start with a delay, since the signal is only checked every 10 seconds (represented by
a blue blinking of the remote control). After 25 hours, the connection between the lamphead and the remote
control will be completely turned off. The lamphead can then only be activated again via the remote control
when the lamphead is reconnected to the battery or switched on using the underneath button of the lamphead.
Daylight
Small button:
- Switch to low beam
(Press again to deactivate,
sensor is not active)
Big button:
- Without function
English
Keep the button
pressed (let go to
select) until SL
lights up
Lights up 1x
Lights up 2x
Lights up 3x
Lights up 4x
Lights up 5x
Delay (5 sec / 16 sec.)
Factory setting: 16 sec.
Sensor calibration
Only in the assembled state!
Improper calibration may
greatly affect the functionality
of the light! Calibrate only
outdoors. No artificial light or
close to reflective objects!
Available settings
The sensor controlled switchover from night- to daytime
running light occurs as required in either 5 or 16 sec.
Saves the measured brightness value as a switching
point from daytime-to nighttime running light. The
successful sensor calibration is confirmed by a short
illumination of the daytime running light.
Explanation
Customizing the settings at the lamphead:
Reset to factory settings
ECO 1 High beam: 16W, Low beam: 8W, Daytime running light: 2W
Keep the small button pressed (let go to select) until the lamp lights up as many times you‘ll need it to.
Note: It will take about 6 sec. until the programming starts.
Note: The light outputs the maximum amount of light only if airflow lowers the temperature of the light
sufficiently. If the light is not cooled by airflow, its power is reduced incrementally to prevent the LEDs and
electronic elements from overheating.
Darkness / Night
Small button:
- With a short press: Low beam dims to 5W
(Not possible when ECO 2 is activated)
- Keep it pressed for about 2 sec.:
Activate daytime running light
(Press again to deactivate, sensor is not active)
Big button:
- If low beam is activated, switching to
high beam is possible.
ECO 2 High beam: 10W, Low beam: 5W, Daytime running light: 2W
Factory setting High beam: 25W, Low beam: 8W, Daytime running light: 2W