Installation of the water armature:
•Drill a 12 mm hole through the sink.
1. Put the cover over the threaded rod of the
water tap.
2. Put the threaded rod through the drilled
hole in the kitchen countertop.
3. Slide the locking washer from underneath
over the threaded rod.
4. Now slide the snap ring onto the threaded
rod.
5. Screw the lock nut onto the threaded rod
and screw down the water tap.
6. Then take the blue hose and put the nut
over the hose.
7. Take the sleeve and put it onto the hose.
8. Subsequently take the insert sleeve and
stick it into the hose.
9. Now insert the hose into the inner
line of the threaded rod and then screw
the nut onto the threaded rod.
•Dimensions: 40cm x 13cm 43cm (LxWxH)
•Daily filter performance: up to 2000 liters
•Water purification without electricity–only 3 bar tap water pressure required
