smart acoustic SPCM300 Manuale utente
OPERATION MANUAL
SPCM300 - PENCIL CONDENSER MICROPHONE
The SPCM300 is a compact, small diaphragm cardioid
microphone, with a 14mm condenser capsule that is suitable
for acoustic instruments, drum cymbal and other stage
performances. The SPCM300 adopts a transformerless
output circuit to reduce electromagnetic interference to
ensure a low noise output. It has a wide frequency response.
Microphone Capsule
(14mm electrets capsule)
XLR Connector
(Microphone-level ouput)
01. Features & Specications
The Frequency Response Curves & Polar Diagram
• Polar pattern:
Cardioid
• Frequency range:
20Hz-20kHz
• Sensitivity:
-45dB±2dB (0dB=1V/Pa 1kHz)
• Output impedance:
<200 Ohms±-30%
•Equivalent noise level:
≤20dB
• Max SPL:
136dB for 0.5% THD
• Connector:
3-pin
• Power requirement:
48V phantom power
02. Microphone Set-up
Put the mic
into clip
Connect to a microphone input on a
mixer, console, or other devices with
48V phantom power.
Note: Must turn on 48V phantom power
on device to ensure correct operation.
Connect a XLR
to the mic
Clip SPCM300
03. General Operation
www.smart-acoustic.com
•Aim the microphone toward the desired sound source
(such as a speaker, singer, or instrument) and away
from unwanted sources and as far as possible from
reective surfaces.
•Place the microphone as close as practical to the desired
sound source.
•Work close to the microphone for extra bass response.
•Use only one microphone to pick up a single sound source.
•Add a windscreen when using the microphone outdoors.
•Avoid excessive handling to minimize pickup of mechanical
noise and vibration.
•Do not cover any part of the microphone grille with your hand,
as this will adversely aect microphone performance.
04. Precautions
•
Do not store the microphone in direct sunlight,
near heating devices or in a hot, humid or dusty place.
•
Do not allow the microphone to get wet.
•
Do not subject the microphone to strong impact.
•
Do not disassemble, modify or attempt to repair
the microphone.
•
After use in a high-moisture environment such as a stage
performance, wipe o the microphone with a dry cloth and
allow it to air dry. Do not store the unit in a closed space
(e.g., a plastic bag) until all moisture has evaporated.
•
Over time the microphone may become discolored
due to wear, or exposure to the sun.
Indice
Altri manuali smart acoustic Microfono
