Snooper S1000 Manuale utente

1 • UK

Quick Start Guide

Kurzanleitung

Résumé du mode d’emploi

Guía de inicio rápido

S1000

2 • UK

3 • UK

QUICK START GUIDE • UK

CONTENTS

Page 3 Start Up

Installing the SD Card

Page 4 Charging the Internal Battery

Page 5 Powering Syrius using the Built-in Battery

Page 6 Installing Syrius using the Windscreen

Suction Cup bracket

Page 7 Operating Instructions

Starting Up

Easy Set Up

Screen Settings

Page 9 Brightness & Volume Control

Page 10 Quick Start Guide to Navigation

Page 13 Quick Menu

Using the Multi-route function

Page 16 System Security Code

Page 17 System Requirements and Software Installation

Page 18 Downloading the AURATM Camera Database

Page 20 Accessories & Price List

Page 21 Vehicle Speciﬁc Professional Mounting Brackets

2 • UK

3 • UK

To utilise the AURA™ Camera database you will need to register your Syrius and

perform a download. Please refer to, ‘System Requirements and Software Installation’

later in this Quick Start Guide for further information.

Start Up

1. Installing the SD Card

Before using Syrius, you will need to install the SD Card included with the device. The SD

Card comes complete with a digital map of Western Europe and is also where the AURATM

camera database is stored if you choose to subscribe and download it.

Start by moving the ‘ON OFF RESET’ switch located on the back of the unit to the‘ON’

position, then remove the SD card from its packaging and insert it into the SD Card

slot as indicated. Switch on the device by pressing the standby power button located

on the top of the unit. Syrius will automatically synchronise with the SD Card. Once

the synchronisation is completed, the SD Card will not function with any other device.

Your Syrius is now ready to navigate and the camera database can be downloaded if

necessary.

Please note that if the unit does not activate when you press the standby power

button for it may require charging.

Refer to the section‘Charging the

internal battery’ later in this guide.

SD Card

4 • UK

5 • UK

2. Charging the internal battery

Although Syrius can be charged using the

cigarette lighter in your vehicle, a complete

charge is more easily achieved by using the

USB mains charger included. When new, the

battery in your Syrius is approximately 20%

charged.

To charge the unit fully, move the ‘ON

OFF RESET’switch to the ‘ON’position and

connect the USB mains charger as indicated

in the picture on the right. The battery

will take approximately 3 hours to charge.

Once fully charged the battery will last

approximately 3 hrs during normal use.

Note: The new battery’s full performance is

only achieved after two or three complete

charges and discharges.

CAUTION

THERE IS A RISK OF EXPLOSION IF THE BATTERY IS REPLACED WITH AN

UNAPPROVED TYPE. USING THE WRONG TYPE OF BATTERY MAY DAMAGE

YOUR UNIT AND INVALIDATE YOUR WARRANTY. ONLY SNOOPER AUTHORISED

PERSONNEL SHOULD REPLACE THE BATTERY. PLEASE DISPOSE OF USED BATTERIES

ACCORDING TO LOCAL WASTE MANAGEMENT RULES AND REGULATIONS.

FURTHER INFORMATION CAN BE FOUND IN THE USER MANUAL.

Plug the charger into a

240V AC mains socket

Plug the USB charger

cable into the USB

socket on the Syrius

4 • UK

5 • UK

3. Powering Syrius using the built-in battery

Once Syrius is fully charged, it is ready for use. Move the ‘ON OFF RESET’switch to the ‘ON’

position and press and hold the standby/power switch on the of the unit for to switch on

the device.

WARNING

PLEASE DO NOT USE OR LEAVE THE SYRIUS IN EITHER WET OR HUMID CONDITIONS,

OR IN EXTREME TEMPERATURES, AS THIS COULD PERMANENTLY DAMAGE THE UNIT

AND THE BATTERY. WHEN NOT IN USE DO NOT LEAVE THE UNIT ATTACHED TO THE

WINDSCREEN, ESPECIALLY WHEN THE WEATHER IS WARM, TO AVOID DAMAGE TO

THE UNIT AND ALSO REDUCE THE RISK OF THEFT

WARNING

THE DEVICE MAY RESTART IF EXPOSED TO STATIC ELECTRICITY, PLEASE AVOID

TOUCHING THE USB SOCKET ON THE SIDE OF THE UNIT.

Standby/Power

6 • UK

7 • UK

4. Installing Syrius using the Windscreen Suction Cup bracket

You can mount your Syrius to the inside of your vehicles windscreen using the

windscreen bracket provided.

Clean the area where you wish to position

the bracket thoroughly with a good quality

glass cleaner. This allows a more secure seal

on the windscreen.

Place the suction cup and bracket on

the windscreen and push the locking

lever towards the windscreen to secure

the bracket.

Adjust the angle of the bracket so that

when the unit is attached to it you can

view the display and operate the controls

safely.

Position Syrius onto the bracket, by

inserting the bottom of the S1000 ﬁrst

and ﬁnally clipping the top of the bracket

into the slot on the back of the unit.

To remove Syrius simply unclip the unit,

by pushing the top of the bracket and taking

the unit from the holder.

Syrius can be powered directly either

from the internal battery if it is fully

charged or powered from the cigarette

lighter socket. To use the cigarette lighter

socket, plug the USB plug on one

end of the power cable into the power

socket on the side of Syrius and plug

the larger plug into the cigarette

lighter socket of your vehicle.

Please Note: Only use the cigarette lighter power cable provided with Syrius. Syrius

operates on 5V and using any other cigarette lighter power cable will damage your

device and void the warranty.

Bracket Adjuster

Locking Lever

6 • UK

7 • UK

Operating Instructions

1. Starting Up

Once you have synchronised the SD Card it is time to perform the ﬁrst Start Up.

First make sure your vehicle is parked in as open a space as possible, clear of tall

trees and buildings so that the built in GPS antenna has a clear view of the sky above.

Next, switch the unit on by moving the‘ON OFF RESET’ switch located on the back of

the unit to the‘ON’ position, then press the standby power switch on the left hand

side of the unit for.

Whilst the Syrius software is loading, a start-up display will be shown for just a few

seconds and then an‘Information Screen’ will be displayed. Press the ‘I Agree’ button

and the screen will display a section of a map.

Syrius needs to acquire a minimum of four satellites in order to work. Once this has

been achieved Syrius will ascertain your position and this will be indicated by a green

arrow icon on the on-screen map and the GPS signal strength will be shown to the

bottom right hand corner of the display. Your Syrius is now ready to navigate.

As the GPS engine and antenna have never been used before, the ﬁrst ‘Cold’start

could take anywhere from 15 – 30 minutes to establish a satellite connection. Once

initialised, subsequent start ups will take less time and eventually should take only

a matter of minutes.

2. Easy Set Up

Screen settings - There are a number of map views or diﬀerent types of information that

can be displayed on the screen at any one time:-

3D 2D North

8 • UK

9 • UK

To modify the information shown access the Menu by simply touching Syrius in the

centre of the screen with your ﬁnger and then press the‘Conﬁgure’ button.

Next press the icon where you will see the list of options

89 MILES

0:33LEFT 20:33PM

NW HOLLOWAY ROAD

Current time or vehicle speed

Direction and name of road

Estimated journey time or Estimated time of arrival

Distance to destination

GPS Signal strength Battery status

8 • UK

9 • UK

To change a setting press it with your ﬁnger and a list of the options available will be

shown next to a tick box. Simply press the tick box to indicate which option you would

like to choose.

Press‘OK’ at the bottom of the screen. Your chosen settings will now be saved and will

appear on the screen each time you use your Syrius. If you want to switch between

your Current Speed and the Atomic Clock or the Estimated Time of Arrival and the Time

to Destination during your journey simply touch the LCD screen where either piece of

information is displayed and the unit will display the alternative setting and vice versa.

However, each time you switch on the device the original setting will be displayed.

Brightness and Volume Control - Both the volume and screen brightness can be

adjusted within the‘Conﬁgure’ Menu. To set either function touch the screen in the centre

with your ﬁnger and then press the ‘Conﬁgure’ button. The screen will then display a

number of diﬀerent icons.

Brightness Control - Press the icon. Syrius

enables you to adjust the brightness of the display

and save two brightness settings: one for driving

during the day and one for driving at night.

To set the daytime brightness select ‘DAY’ by

checking the tick box with your ﬁnger and then

using the‘+’and‘-‘ buttons to adjust the setting. To

set the‘NIGHT’setting, simply check the tick box

with your ﬁnger for ‘NIGHT’and follow the same procedure. Once you have selected the

desired brightness press the ‘OK’button at the bottom of the screen.

10 • UK

11 • UK

Note: The arrow icon in the bottom right hand corner of the display will return you

to the‘Conﬁgure’ menu if pressed but will not store any changes you have made.

You need to select the‘OK’ button in order to save your changes.

Volume Control - Press the icon. Using your

ﬁnger press either the‘+’ button to increase the

volume or the‘–’ button to decrease the volume.

Finally select the ‘OK’button to conﬁrm the setting.

Note: The arrow icon in the bottom right hand

corner of the display will return you to the

‘Conﬁgure’ menu if pressed but will not store

any changes you have made. You need to select

the‘OK’ button in order to save your changes.

ATTENTION!

Please don’t forget to register your Syrius online at www.snooperneo.co.uk

To register you will need the serial number which can be found on the bottom of

your Syrius.

3. Quick Start Guide to Navigation using a

post code

Take your Syrius outside so that the GPS receiver

can locate your position. This may take between

15 - 30 minutes the ﬁrst time. When satellite lock

is achieved, the screen will display your current

position on its map in a‘3D’navigation view. Your

position (and direction) is indicated by the icon.

Tip: To reduce the ‘cold start’ GPS time remain stationary.

Altri manuali per S1000

Indice

Lingue:

Altri manuali Snooper Sistema di navigazione per auto

Snooper

Snooper 2 Series Manuale utente

Snooper

Snooper S81 Series Manuale utente

Snooper

Snooper truckmate s7000 Manuale utente

Snooper

Snooper S1000 Manuale utente

Snooper

Snooper S5000 Manuale utente

Snooper

Snooper 8100 SERIES Manuale utente

Snooper

Snooper MY-SPEED XL G2 Manuale utente

Snooper

Snooper S8000 Manuale utente

Snooper

Snooper S7000 Manuale utente

Snooper

Snooper 6 Series Manuale utente

Snooper

Snooper Syrius Pro Manuale utente

Snooper

Snooper Syrius Manuale utente

Snooper

Snooper 6 Series Manuale utente

Snooper

Snooper syrius s600 plus Manuale utente

Snooper

Snooper S1000 Manuale utente

Snooper

Snooper Syrius Pro Manuale utente

Snooper

Snooper TRUCKMATE LITE S6000 Manuale utente

Snooper

Snooper Truckmate Pro S6800 Manuale utente

Snooper

Snooper AVN S7000 Manuale utente

Snooper

Snooper S7000 Manuale utente

Snooper

Snooper S7000 Manuale utente

Snooper

Snooper Syrius Truckmate S2000 Manuale utente

Manuali Sistema di navigazione per auto popolari di altre marche

Clarion

Clarion Navigation In-Car Entertainment Manuale utente

Rosen

Rosen DP-1001 Manuale utente

Alpine

Alpine INE-W970HD Manuale utente

Skoda

Skoda AMUNDSEN+ Manuale utente

Blaupunkt

Blaupunkt TravelPilot DX-N Manuale utente

Pioneer

Pioneer MZ360500EX Manuale utente

Sanyo

Sanyo NVM-4030 - Easy Street - Automotive GPS... Manuale utente

Kenwood

Kenwood DNN991HD Manuale utente

AvMap

AvMap Geosat 2C Manuale utente

Eonon

Eonon GE01B Manuale utente

Pioneer

Pioneer AVIC-Z920DAB Manuale utente

Nextar

Nextar M3-MX - Automotive GPS Receiver Manuale utente

Furrion

Furrion NV2200 Manuale utente

Mio

Mio MOOV 200-Series Manuale utente

Prestigio

Prestigio GeoVision 5150 Manuale utente

Hummer

Hummer 2006 H3 Manuale utente

Magellan

Magellan Maestro 4210 - Automotive GPS Receiver Guida alla configurazione

Garmin

Garmin StreetPilot c510 Manuale utente