Softing Echocollect Manuale di installazione e d'uso

Configuring a Softing echocollect to establish data

exchange between a Siemens S7-300 and an

Allen-Bradley ControlLogix

echocollect

How to...

Version: E-032014-01

The information contained in these instructions corresponds to the technical status at the time of printing of it and is

passed on with the best of our knowledge. The information in these instructions is in no event a basis for warranty

claims or contractual agreements concerning the described products, and may especiallynot be deemed as warranty

concerning the qualityand durabilitypursuant to Sec. 443 German Civil Code. We reserve the right to make any

alterations or improvements to these instructions without prior notice. The actual design of products may deviate from

the information contained in the instructions if technical alterations and product improvements so require.

It may not, in part or in its entirety, be reproduced, copied, or transferred into electronic media.

Disclaimer of liability

Softing Industrial Automation GmbH

Richard-Reitzner-Allee 6

85540 Haar / Germany

Tel: + 49 89 4 56 56-0

Fax: + 49 89 4 56 56-488

Internet: http://industrial.softing.com

Email: info.automation@softing.com

Support: support.automation@softing.com

The latest version of this manual is available in the Softing download area at: http://industrial.softing.com.

Table of Contents

echocollect - How to... 3

Table of Contents

Chapter 1 ..................................................................................5

Introduction

Chapter 2 ..................................................................................6

NetCon echo – echocollect port network

settings

Chapter 3 ..................................................................................7

Create a connection to the S7-300 PLC

Chapter 4 ..................................................................................9

Create a connection to the ControlLogix

PLC

Chapter 5

..................................................................................12

Create the table to establish data transfer

from "Data_to_S7" (CLX) to "DB1"

(S7-300)

Chapter 6

..................................................................................16

Create the table to establish data transfer

from "DB2" (S7-300) to "Data_from_S7"

(CLX)

Chapter 7 ..................................................................................20

Finished table mapping

This page is intentionally left blank.

Chapter 1 - Introduction

echocollect - How to... 5

1 Introduction

This document provides step by step instructions on how to establish data exchange

between a Siemens S7-300 PLC and an Allen-Bradley ControlLogix PLC, using a Softing

echocollect device.

General description of the presented example

Both PLCs and the echocollect are in the same network.

No program changes required on the PLCs. All the configuration is done on the

echocollect.

The data source tag on the ControlLogix is an array of 50 integers called Data_to_S7.

The target data block on the S7-300 is DB1, defined also as an array of 50 integers.

The data recipient tag on the ControlLogix is an integer called Data_from_S7.

The source data block on the S7-300 is DB2, defined as one byte.

Software used

Softing NetCon echo V4.33

Conventions

The following conventions are used throughout Softing customer documentation:

Keys, buttons, menu items, commands and

other elements involving user interaction are

set in bold font and menu sequences are

separated by an arrow

Open Start Control Panel

Programs

Buttons from the user interface are enclosed

in brackets and set to bold typeface

Press [Start] to start the application

Coding samples, file extracts and screen

output is set in Courier font type

MaxDlsapAddressSupported=23

Filenames and directories are written in italic

Device description files are located in C:

\StarterKit\delivery\software\Device

Description files

Note

This symbol is used to call attention to notable information that should be

followed during installation, use, or servicing of this device.

Chapter 2 - NetCon echo – echocollect port network settings

6echocollect - How to...

2 NetCon echo – echocollect port network settings

1. Start NetCon echo and configure the network settings of the echocollect port to be

used. We will use port 1 (Eth 1).

a. Click on Station Own Station 1.

b. As a minimum, the IP address and subnet mask are required. DNS and Router

addresses may be necessary in some cases.

Chapter 3 - Create a connection to the S7-300 PLC

echocollect - How to... 7

3 Create a connection to the S7-300 PLC

1. Click on Connection New Connection.

2. Enter a connection name.

3. Click on Logic Table Connection and select the PLC/Raw and Ethernet options.

Chapter 3 - Create a connection to the S7-300 PLC

8echocollect - How to...

4. After clicking [OK], select the TCP/IP and Siemens S7 options.

5. Enter the IP address of the S7-300 and click [OK].

6. Click [OK] again.

Chapter 4 - Create a connection to the ControlLogix PLC

echocollect - How to... 9

4 Create a connection to the ControlLogix PLC

1. Click on Connection New Connection.

2. Enter a connection name.

3. Click on Logic Table Connection and select the PLC/Raw and Ethernet options.

Chapter 4 - Create a connection to the ControlLogix PLC

10 echocollect - How to...

4. After clicking [OK], select the TCP/IP and Rockwell CompactLogix / ControlLogix

options.

5. Enter the IP address of the ControlLogix PLC and then click on [Protocol Settings].

6. Enter the CPU slot number (2 in our example) and click [OK].

Altri manuali per echocollect

Indice

Altri manuali Softing Portale

Softing

Softing FG-200 HSE/FF Guida alla risoluzione dei problemi

Softing

Softing dataFEED uaGate 840D Guida all'installazione

Softing

Softing edgeGate Guida alla risoluzione dei problemi

Softing

Softing smartLink HW-DP Manuale utente

Softing

Softing echolink S7-compact Manuale utente

Softing

Softing uaGate SI Guida alla risoluzione dei problemi

Softing

Softing Modbus mbGate PA Manuale utente

Softing

Softing FG-260 Guida alla risoluzione dei problemi

Softing

Softing epGate PA Manuale utente

Softing

Softing pnGate DP Manuale utente

Softing

Softing pnGate PA Guida alla risoluzione dei problemi

Softing

Softing Echochange Manuale utente

Softing

Softing dataFEED edgeGate Guida alla risoluzione dei problemi

Softing

Softing echocollect Manuale utente

Softing

Softing uaGate MB Manuale utente

Softing

Softing pnGate PA EX Manuale utente

Softing

Softing mbGate PA Guida alla risoluzione dei problemi

Softing

Softing echolink one2PROFINET Manuale utente

Softing

Softing Echochange Manuale utente

Softing

Softing NETLink S7-Compact Manuale utente

Manuali Portale popolari di altre marche

LST

LST M500RFE-AS Manuale utente

Kinnex

Kinnex Media Gateway Manuale utente

2N Telekomunikace

2N Telekomunikace 2N StarGate Manuale utente

Mitsubishi Heavy Industries

Mitsubishi Heavy Industries Superlink SC-WBGW256 Manuale utente

ZyXEL Communications

ZyXEL Communications ZYWALL2 ET 2WE Manuale utente

Telsey

Telsey CPVA 500 - SIP Manuale utente

RTA

RTA 460A-NNA4 Scheda tecnica

Shaw

Shaw Gateway HDPVR Manuale utente

ABB

ABB VSN900 Guida rapida

Commander

Commander Pulse Manuale utente

2N Telekomunikace

2N Telekomunikace ATEUS EasyGate 501309E Manuale utente

NETGEAR

NETGEAR C6300BD Manuale utente

Amit

Amit CDW531AM Manuale utente

HMS

HMS Netbiter EasyConnect EC150 Manuale utente

Huawei

Huawei EchoLife HG620 Manuale utente

AT&T

AT&T U-verse 3801 Manuale per l'uso e la cura

Logic IO

Logic IO RTCU MX2 turbo Manuale utente

Suttle

Suttle MediaMAX MXM-521 Manuale utente

Softing echocollect Manuale di installazione e d'uso

Manuali Portale popolari di altre marche