Soltech SATELIS Manuale utente
02
SATELIS 50W
SATELIS 75W
03
01 Check List
02 Introduction
03 Battery Notes
04 Installation and Wiring Compliance
05 Mounting Accessories
06 Installation—50W
07 Installation—75W
08 Panel Angle
09 Remote Control Guide
Contents
05
06
08
010
011
012
014
016
018
04
01 Check List
SATELIS 50W
Solar Panel
Component Kit A
Component Kit D Component Kit E Component F Component G Component H
Component I Component J Component K Wire M
Component Kit B Component Kit C
Luminaire Battery Pack
05
SATELIS 75W
Solar Panel
Component Kit A
Component Kit D Component Kit E Component F Component G Component H
Component I Component J Component L Wire N
Component Kit B Component Kit C
Luminaire Battery Pack
06
02 Introduction
Thank you for purchasing SATELIS Urban Lighting Products.
Introduction
The high-performance SATELIS Series is a municipal-grade solar outdoor
lighting system that provides bright off-grid light. This heavy-duty com-
mercial dedicated series is ideal for highways, city streets, large parking
lots, and area lighting. It comes in a wide choice of configurations, lighting
outputs, and recommended pole heights. The Satelis series is optimized
to provide years of bright, reliable light. Industry-leading efficiency, dense
batteries, and advanced controls to guarantee the highest possible off-
grid autonomy.
Important
In order to avoid deep discharge of the battery during storage, please
fully recharge your battery every 4 months. Please make sure that the
light is installed in an area with sufficient sunlight irradiance. A strict
minimum of 3.5 hours/day of sunshine on average is recommended. Se-
lect the right operating mode according to the local legislation needs and
the local sunshine conditions. Keep it away from shadows. Self-cleaning
available when the light fixture have minimum angle of 15 degrees.
Please save these instructions. Read all of the instructions carefully
before attempting to carry out any installation or wiring. Do not open or
attempt to repair the product on your own, as it many cause serious
damage and would void the product warranty. Contact your local
distributor for any questions concerning the installation.
Range of the light module on the lighting fixture is 20–26 feet
(6–8 meters). The ideal installation spacing is >16 feet(5 meters). When
installing two or more lighting fixtures on one pole, select desired
operating mode before installation. Interference can cause delay or
malfunction when using the remote control to change operating modes
after installation.
Precautions when working with solar panels
When the solar panel is exposed to sunlight, a voltage appears at the
output terminals of the solar panel turning it into a source of electricity.
To avoid a shock hazard, make sure the solar panel is covered with an
opaque (dark) later such as paper or cloth during the installation. Do not
make contact with the terminals when the panel is exposed to sunlight or
any other light source.
07
SATELIS 50W
SATELIS 75W
26.5 inches
25V 30AH
SOLAR PANEL: 21.1 Lbs
SOLAR LAMP: 13.5 Lbs
BATTERY ASSEMBLY: 35.2 Lbs
MOUNTING FASTNER: 22 Lbs
25V 60AH
SOLAR PANEL: 21.1 Lbs
SOLAR LAMP: 13.5 Lbs
BATTERY ASSEMBLY: 51 Lbs
MOUNTING FASTNER: 22 Lbs
25V 60AH
SOLAR PANEL: 42.2 Lbs
SOLAR LAMP: 13.8 Lbs
BATTERY ASSEMBLY: 51 Lbs
MOUNTING FASTNER: 28.6 Lbs
25V 90AH
SOLAR PANEL: 42.2 Lbs
SOLAR LAMP: 13.8 Lbs
BATTERY ASSEMBLY: 66 Lbs
MOUNTING FASTNER: 28.6 Lbs
1.3 inches
3.5 inches
11.0 inches
32.0 inches
55.0 inches
1.3 inches
9.5 inches 6.3 inches
49.0 inches
49.0 inches
21.5 inches
3.5 inches
11.0 inches
32.0 inches 9.5 inches 6.3 inches
21.5 inches
08
1. The LiFePO4-battery-powered SATELIS lights are visibly brighter
than other outdoor solar lights, and their performance overall is
more reliable.
2. To charge the battery fully may take up 6 to 12 hours.
3. Output will be reduced to 40% when the battery is below 40% of
its capacity.
4. Battery will stop charging when the ambient temperature is below
32°F or above 149°F.
Battery Status is indicated by the red/green indicator on the lighting
fixture as follows:
- Red indicator (Charging)
> Slow red light flashing = Charging
> Red light continuously on = fully charged
> Quick red flashing = charge fault
- Green indicator (not charging)
> Green light continuously on = more than 40% of the battery
capacity remaining
> Slow green light flashing = battery capacity below 10%
> Quick green light flashing = battery below 0% mode—Protect
battery does not over discharging
Storage
To avoid over discharge of the battery during storage, please recharge
the lighting fixture every 3 months. Use the dedicated charger to charge,
reset the switch when done.
03 Battery Notes
09
Battery pack Disconnect wires
Disconnect wires
Battery Replacement
1. Loosen the screws of the
battery pack.
2. Disconnect the wire
connectors.
3. Take out the battery pack.
4. Replace with a new one,
connect the wire connectors.
5. Tighten the screws.
(IAP) Intelligent Adaptive Program Battery
Control Technology
In order to extend the off-grid autonomy
of the SATELIS under shady trees, heavy
rain, and thick clouds, our controllers now
integrate an adaptive smart control feature
to actively track battery capacity and adjust
light output accordingly. Before integrating
this feature, selecting a light output percent-
age on the remote would yield an accurate
percentage of max LED brightness. Now with
(IAP), the controller actively monitors the
battery and regulates the electrical current
to the LEDs. The controller makes light output
of the selected percentage on the remote
relative to battery capacity rather than max
LED output. This smart-control feature can
increase our off-grid performance by up
to 40%. 0102
03
010
04 Installation and Wiring Compliance
1. Installation and wiring must comply with the State and National
Electrical Codes.
2. The SATELIS 50W and 75W models are intended for outdoor use
only and should not be installed in an unventilated area, and shall be
installed in an environment within the operational temperatures
defined for the product.
3. The average sunshine in the installation area should be above
3.5 hours/day in order to ensure full function of the lighting fixture.
Avoid areas with shades.
4. Before installation, if applicable, please ensure the light pole and its
foundation are solid enough to withstand the lighting fixture(s).
5. Before installation, please ensure that the battery is fully charged. Install
during sunny days if possible.
6. Before installation, please press the ON/OFF key in the remote
control and check whether it shows a red light on the indicator.
Please cover the panel and check if the light module turns on normally
within 1 minute.
After Installation
The lighting fixture will automatically turn on at night and turn off
during daylight.
Important
Always orient the solar panel facing the equator (e.g. facing south if in
northern hemisphere).
Always have a tilt angle of at least 15° to avoid dust accumulation
(0°=horizontal plane).
Indice
Altri manuali Soltech Attrezzatura di illuminazione
Soltech
Soltech Broadway 60 Manuale utente
Soltech
Soltech Cosmo 20W Manuale utente
Soltech
Soltech BEACON Manuale utente
Soltech
Soltech CEGONIA PRO Manuale utente
Soltech
Soltech SOLPORT Manuale utente
Soltech
Soltech SOLTAB Manuale utente
Soltech
Soltech SOLPORT Manuale utente
Soltech
Soltech FOCUS 10W Manuale utente
Soltech
Soltech BEACON Manuale utente
Soltech
Soltech SUNDIAL 3W 13" Manuale utente
Soltech
Soltech NUVO Manuale utente
Soltech
Soltech BROADWAY PLUS Manuale utente
Soltech
Soltech SUNLIKE PRO 30W Manuale utente
Soltech
Soltech PORTA SUNLIKE 8W Manuale utente
Soltech
Soltech SOLPORT Manuale utente
Soltech
Soltech SOLPAD Manuale utente
Soltech
Soltech SOLPORT 7W Manuale utente
Soltech
Soltech TEMPO Manuale utente
