Sonance ARCHITECTURAL Series Manuale utente

Determine the location for the mounting platform.

Ensure there is adequate room for the BPS6

subwoofer at the location of the platform.

The speaker opening must be located within

12” (305mm) of the BPS6 to allow the port

tube to reach through the platform.

Place the mounting template on the side of

the joist and drill four 1/2” (12.7mm) holes

through the joist at the locations shown on

the mounting template.

Attach the mounting platform to the joists.

See mounting platform quickstart guide or visit

www.sonance.com/in-wall-in-ceiling/

architectural-series for detailed

installation manual.

Hold the side of the BPS6 with the rubber

damping pad up against the side of the joist

and install the four lag screws and washers to

secure the BPS6 in place.

3 4

12” (305mm)

BPS6

Port tube

(1) Quickstart guide

(1) Bandpass subwoofer w/ port tube

(1) Cardboard mounting template

Mounting screws & washers:

(4) 5/16” x 2” lag screws (for thinner beams)

(4) 5/16” x 3” lag screws (for thicker beams)

(4) 5/16” washers

Box Contents

Bandpass subwoofer can be installed in joists spaced 16” on center or greater.

AS BANDPASS STEREO SUBWOOFER QUICKSTART GUIDE

BPS6

SONANCE ARCHITECTURAL SERIES®

Sonance and Architectural Series are registered trademarks of Dana Innovations.

Due to continuous product improvement, all features and specifications are subject to change without notice.

For the latest Sonance product specification information, visit our website: www.sonance.com

SONANCE • 212 Avenida Fabricante • San Clemente, CA 92672-7531 USA

(800) 582-7777 or (949) 492-7777 • FAX: (949) 361-5151 • Technical Support: (800) 582-0772

www.sonance.com

06.05.1433-5946

On the end of the BPS6 port tube there is a tether.

The tether will be used later to guide the BPS6 port

tube through the mounting platform opening.

Position end of port tube as close as possible

to back of mounting platform. Loop tether into

the anchored zip tie and secure. This process

ensures that bandpass connector is easily

attached later and other tradespersons won’t

infringe on port tube assembly area.

5 6

7 8

Tether into

zip tie

Tether

For wiring diagrams &

detailed eManual scan

the QR code or visit

www.sonance.com/

in-wall-in-ceiling/

architectural-series

Secure the wires with a zip tie near the

terminals to prevent accidental removal by

another tradesperson.

Attach the four conductor wires from the

amplifier to the input terminals on the end of

the BPS6. Positive wires to red terminals and

negative wires to black terminals. Run the

speakers wires to amplifier location and run

signal test with 9V battery. NOTE: Port tube

contains foam plug with tether, make sure

pressure levels don’t expel the foam and

tether. Do not connect the voice coils

in parallel.

Questo manuale è adatto per i seguenti modelli

Altri manuali Sonance Subwoofer

Sonance

Sonance BPS-1 Manuale utente

Sonance

Sonance Bandpass Subwoofer BPS-1 Manuale utente

Sonance

Sonance VP10SUB Manuale utente

Sonance

Sonance Son Of Sub Manuale utente

Sonance

Sonance LS47SAT Manuale utente

Sonance

Sonance Landscape LSV10SUB Manuale utente

Sonance

Sonance Cinema Series SUB 10-150 Manuale utente

Sonance

Sonance D8 Manuale utente

Sonance

Sonance VP10SUB NC Manuale utente

Sonance

Sonance Cinema Series SUB 12-250 Manuale utente

Sonance

Sonance VIRTUOSO A800D Manuale utente

Sonance

Sonance The Sub Manuale utente

Sonance

Sonance BPS8 Manuale utente

Sonance

Sonance BPS-1 Manuale utente

Sonance

Sonance LANDSCAPE SERIES HS10SUB Manuale utente

Sonance

Sonance Landscape Series Manuale utente

Sonance

Sonance CRK20 Manuale utente

Sonance

Sonance ThinLIne Series Manuale utente

Sonance

Sonance LS10SUB Manuale utente

Sonance

Sonance BPS-1 Manuale utente

Sonance

Sonance XBW Manuale utente

Sonance

Sonance Cinema Series CINEMA SUB Manuale utente

Sonance

Sonance BPS6 Manuale utente

Sonance

Sonance D8 Manuale utente

Manuali Subwoofer popolari di altre marche

Sony

Sony XS-AW8 Manuale utente

Sony

Sony XS-L836 Manuale utente

B&C Speakers

B&C Speakers 15 HPL 76W Manuale utente

Velodyne

Velodyne DD-18+ Manuale utente

Hifonics

Hifonics HW-12 Guida rapida

Magnat Audio

Magnat Audio ADR 130 BP Manuale utente

Blitz

Blitz BZP106 Manuale utente

Technics

Technics SB-AS500 Manuale utente

Lyngdorf

Lyngdorf BW-2 Manuale utente

Lyngdorf

Lyngdorf BW-3 Manuale utente

Pyle Pro

Pyle Pro PYLE PRO PDW15125 Manuale utente

REL Acoustics

REL Acoustics Q Series Manuale utente

Pioneer

Pioneer Elite S-W1EX Manuale utente

L-Acoustics

L-Acoustics KIVA SB15M Guida rapida

B&C Speakers

B&C Speakers Woofer 12 HPL 76 Manuale utente

KEF

KEF KUBE 200 Manuale utente

Yamaha

Yamaha SW500 Manuale utente

Adam

Adam Sub15 Manuale utente