
READY: Flashing shows that the system is preparing, Solid Light shows that the system can
operate.
DMX: Flashing shows that the DMX signal is connected, no display shows that there is none
connected.
FAULT: Sign will light up when any error is detected.
HEAT : Sign will light up when the system is heating.
a. Control Button Area:
MENU: entering into the menu select
DOWN: parameter reduction
UP: parameter increase
ENTER: confirm and save all parameters
a. Interface and Plugging Area:
POWER IN: 110VAC Power Voltage Input
POWER OUT: 110VAC Power Voltage Switching Output
DMX IN: DMX Communication Signal Input
DMX OUT: DMX Communication Signal Switching Output
a. Radio Frequency Identification Area:
The Product Identification card/emblem attached to the spark granules determines the parameter
and type of the product that is identified through swiping the card.
Please note that the card enables the unit for 15-25 minutes of operation (which is the amount of
time each batch will last). The card supplied only works once and is unusable after it has been
swiped.
Interface
•Main Interface:
•Displays DMX Address.
•Displays the present temperature of the inner core.
•Displays the error information when it happens.
Over current protection of the motor
Temperature sensor is not connected
The equipment stops due to the over-temperature of the chassis
The Sparkular Grain materials are about to run out