Spatech CADI Manuale utente

PEDICURE SPA USERMANUAL

Before Operating the unit, please read this manual thoroughly and retain it for future reference

RECEIVING AND INSPECTION:

PLEASE TAKE NOTE! Thoroughly inspect each shipment immediately upon arrival. It is

important that you notify the driver and insist on a notation of the damage. Make

this notation directly on the freight company’s waybill or bill of lading. Failure to note

damage on the waybill or bill of lading may impede and/or prevent any claims that

you may have against the freight carrier.

If missing parts or damage is found. Please notify the carrier at once and request an

inspection. DO NOT DISCARD THE SHIPPING BOX. If you give the carrier a clear

receipt for goods that have been damaged in transit, you do so at your own risk and

expense.

TRADEMARK DISCLAIMER

CADI, BELLO, CELIO, BENILLI, MARLO, PORADA, ELO, and LUXE is the registered trademarks of

Spatech, Inc. Reproduction or reuse of part or all of trademarks are expressly prohibited without

written permission from Spatech, Inc. Due to limitation of the printing process, product colors shown

might look different from actual colors. Spatech will not be responsible for any misprint of this

advertisement. Spatech’s footspa specification and prices may change without prior notice.

Pedicure Spas are intended for professional used only, always follow your State Board’s sanitation

and disinfectant guideline.

SAFETY PRECAUTIONS:

Warning

THIS PRODUCT IS FOR INDOOR USE ONLY

DISCONNECT POWER SUPPLY CORD BEFORE SERVICING

This product is to be connected to a branch circuit outlet protected by a Class

A GROUND FAULT CIRCUIT INTERRUPTER (GFCI), and the GFCI shall be tested

regularly for continued protection and correct operation. If a Class A GFCI

protected outlet is not available, DO NOT USE THIS PRODUCT! Please contact a

licensed electrician for installation of a Class A GFCI according to local electric

s, or

qui

lent

Warning

DO NOT USE if you are diabetic, have poor circulation, or if any area of your

feet or legs is inflamed or has an open sore. Consult your physician before

using if you have any kind of fungal infection, swelling, fracture or persistent

Warning

TO REDUCE RISK OF INJURY, DO NOT PERMIT CHILDREN TO USE THIS UNIT

UNLESS THEY ARE CLOSELY SUPPERVISED AT ALL TIME



LIRE LES INSTRUCTION DU FABRICANT AVANT DE METTRE EN MARCHE



UTILISER SEULEMENT A L’INTERIEUR



COUPER LE COURANT AVANT DE PROCEDRE AU DEPANNAGE, AU

NETTOYAGE

Warning

1. Excessive water temperature is dangerous and should be checked BEFORE

use.

2. Maximum temperature of the water should never exceed 100 degrees F.

3. DO NOT STEP/ STAND IN FOOT BASIN.

4. Always enter and exit the Pedicure Spa slowly and carefully.

5. NEVER bring and / or operate any electrical devices into or near the

Pedicure Spa.

6. M

load in spa

ir is 250

bs (114

Warning

If a crack in the GLASS BOWL occurs, DO NOT handle unless the proper attire

and equipment is used. Discontinue use of the bowl until proper equipment is

replaced. You may be held accountable for any injury that may occur. Spatech,

Inc. is not liable for any injury that may occur.

STATES’ NOTICE

In the common wealth of most of the States, all pedicure spas shall be installed for Commercial

usage in the states, are required to have backflow preventer. This equipment shall be installed

between the water inlets and the spa at Salon’s cost.

PLEASE SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE

Connect drain with power drain (pump) or gravity drain (no pump)

Using ¾” schedule 40 PVC (Power Drain) or 1 ¼” flex tube (Gravity Drain) and appropriate P-

Traps connect drain to meet local plumbing codes.

Rubber connection to the drain should be removable for easy service and should not be

permanent to prevent damages.

Plumbing Flow Pattern for Gravity Drain:

*** Extra 1 ¼” Flex-hose is supplied for fast connecting to underground 1 ½” connector

Hot and cold water supply lines

Before water line connections, please follow

below:

Determine if your spa chair is used for a new construction of a salon or a replacement spa

chair.

1. New construction: Make sure to remove any and all debris and/or dust from current hot cold

water pipes before hooking up to spa. Suggested direction to remove debris: turn on water and

drain into a bucket or container.

2. Replacement Spa: Always use new hot/cold water hoses when connecting a new spa chair

to prevent debris, such as old rubber particles, from clogging drain.

*** Vaccum Breaker

Due to Town and/or State requirement/s are varies in building code, if the Town and /or

State requires Vacuum Breaker, As the Plumber MUST provide Vacuum Breaker according

to building code requirement.

Electrical Service:

INSTALLATION

A 110V, 60Hz, 15 Amp GFCI protected grounded circuit must be used to

supply power to the pedicure spa

Water Supply:

• Observe and follow all local codes in regards to plumbing connections

• 30 to 80 PSI water pressure is needed to correctly fill the basin a correct

level

• The hot water supply temperature must not exceed 150oF (65oC);

exceeding this temperature may cause damage to your unit and injury. If

the temperature is higher than this, then please lower your water heater to

the correct and acceptable temperature

• Carefully connect the incoming water supply lines to appropriate fittings

located on the back of the pedicure spa. For hot and cold water supply

fittings below. For power drain/floor drain fittings location

• Shut-off valves are recommended

• To prevent the water supply contamination, our shower head includes a

back flow preventer (see figure 1). We also highly recommend you to install

a Reduced Pressure Back Flow (RPBP) for each hot & cold water supply line.

Please check with your local plumbing code requirements.

Spatech recommends Watts 909 RPBP for each main supply line (see figure

2). Installation must be done by a licensed plumber, and installation

procedures must comply with all state and local codes.

Connect drain with power drain (pump) or gravity drain (no pump)

Using ¾” schedule 40 PVC (Power Drain) or 1 ¼” flex tube (Gravity Drain) and appropriate P-

Traps connect drain to meet local plumbing codes.

Rubber connection to the drain should be removable for easy service and should not be

permanent to prevent damages.

WALL CLEARANCE & SPA to SPA RECOMMENDED CLEARANCE SPA

DIMENSION.

Questo manuale è adatto per i seguenti modelli

Indice

Altri manuali Spatech Pedicure Spa

Spatech

Spatech LUXE Manuale utente

Manuali Pedicure Spa popolari di altre marche

hadewe

hadewe Xantos-BT Manuale utente

Terraillon

Terraillon TONIC 2 Manuale utente

XENOX

XENOX Nail 35K Manuale utente

Continuum

Continuum Echo Manuale utente

DIR

DIR DRAGON Manuale utente

UFESA

UFESA BH5624 Manuale utente

Peter Bausch

Peter Bausch 0300 Manuale utente

Remington

Remington PFS-600 Manuale utente

hadewe

hadewe Veloria MD Manuale utente

j&a

j&a Cleo AX Manuale utente

European Touch

European Touch RINATO XL SPA Manuale utente

HoMedics

HoMedics BubbleBliss FB-30 Guida

HoMedics

HoMedics JetSpa Elite FB-300 Guida

HoMedics

HoMedics BubbleSpa BL-150 Guida

Lexor

Lexor ELITE Manuale utente

Scarlett

Scarlett VitaSpa SC-CA304PS11 Manuale utente

Lexor

Lexor LIBERTE Manuale utente

DIR

DIR Gragon 5820 Manuale utente