SPEC-D Tuning 2LHP-GAM99JM-TM Manuale utente
*If you experience any difficulties that the instruction did not cover, Please seek local auto shop for advise.
*
Please wear protection before you work on your vehicle.
*An assistant is helpful when removing the front bumper.
*Please be careful while working with the bumper or body part to avoid scratching.
*
Do not make direct contact with the halogen bulb or the wire assembly until the unit has cooled down after use
.
WWW.SPECDTUNING.COM
Phillips Screwdriver
Trim Pad Remover
Flat Tip Screwdriver
Pliers
Wire Crimper
Wire Stripper
4 Blue Quick Splice Wire Connectors
4 Blue Male Quick Wire Connectors
4 Blue Female Quick Wire Connectors
2 Red Wires (8 inch)
2 Black Wires (8 inch)
Drill with 3/8 Drill Bit
Dremel Rotary Tools
1999-2005PONTIACGRAND-AMHEADLIGHTS
2LHP-GAM99JM-TM
2LHP-GAM99-TM
2LHP-GAM99JMB-TM
2LHP-GAM99B-TM
INSTALLATION INSTRUCTIONS
TOOLS AND SUPPLIES REQUIRED
1. Open the hood
3. Then remove the plastic cover
2. Remove the clips
4. There are two latches
WWW.SPECDTUNING.COM
p1
*If you experience any difficulties that the instruction did not cover, Please seek local auto shop for advise.
*
Please wear protection before you work on your vehicle.
*An assistant is helpful when removing the front bumper.
*Please be careful while working with the bumper or body part to avoid scratching.
*
Do not make direct contact with the halogen bulb or the wire assembly until the unit has cooled down after use
.
1999-2005
PONTIACGRAND-AMHEADLIGHTS
INSTALLATION INSTRUCTIONS
WWW.SPECDTUNING.COM
5. Pull the inner latch out first
6. Then pull the outer latch up
7. Gently pull out the headlight slightly, just enough to see
the back of the light
9. After you remove the headlight, it should look the same as
the picture shown above
8. Disconnect all the connectors and remove the headlight
10. These locations need slight modification by cutting out the
area shown above
WWW.SPECDTUNING.COM
p2
please see the “Halo and L.E.D. installation instructions”
If your headlights don’t have HALO or L.E.D. You can skip the
installation instructions.
( Please repeat the picture order from 1 to 22 for the opposite side)
17. After you modify the area, it should look same as the picture
shown above
18. Connect the harness from the headlight
19. Gently install the headlight to its original spot
21. Then push the inner latch back into place
20. Push the outer latch back into place
22. Gently put the plastic back
WWW.SPECDTUNING.COM
p3
23. The installation is now complete
WWW.SPECDTUNING.COM
p4
Questo manuale è adatto per i seguenti modelli
3
Indice
Altri manuali SPEC-D Tuning Accessori per automobili
SPEC-D Tuning
SPEC-D Tuning SSB3-CHKE84S2-WB Manuale utente
SPEC-D Tuning
SPEC-D Tuning LHP-JET99JM-8-TM Manuale utente
SPEC-D Tuning
SPEC-D Tuning 2LHP-DEN07-TM Manuale utente
SPEC-D Tuning
SPEC-D Tuning JEEP WRANGLER JK 2007-2016 Manuale utente
SPEC-D Tuning
SPEC-D Tuning SSB3-MDX07S2-WB Manuale utente
SPEC-D Tuning
SPEC-D Tuning 2LHP-ITRE98-TM Manuale utente
SPEC-D Tuning
SPEC-D Tuning SSB3-LIB08BK-WB Manuale utente
