PU IQE 12/383.0 April 26, 2013 v
List of Figures
Figure 1: Front panel of the PU IQE 12/38 7
Figure 2: Display of the PU IQE 12/38 9
Figure 3: Operate mode 10
Figure 4: Standby mode 10
Figure 5: Off mode 11
Figure 6: Degas mode 11
Figure 7: Setting the energy 14
Figure 8: Viewing the Focus 1 parameter 16
Figure 9: Setting the focus parameters. 16
Figure 10: Setting emission current 17
Figure 11: Setting Pos X and Pos Y 18
Figure 12: Setting Width X and Width Y 18
Figure 13: Setting the timer 19
Figure 14: Setting ILimit 20
Figure 15: Setting IStandby 21
Figure 16: Blanking X and Y 22
Figure 17: Setting Blanking X and Blanking Y 23
Figure 18: Angles phi and theta 23
Figure 19: Setting phi and theta 24
Figure 20: setting Blank Level 25
Figure 21: Distances L and M 25
Figure 22: Setting L and M 26
Figure 23: Setting Deflect X and Deflect Y 27
Figure 24: Setting the HPIB address 27
Figure 25: Setting DS100 status 28
Figure 26: setting Remote mode 29
Figure 27: Setting the baud rate 29
Figure 28: Pin assignment of the RS-232 connector 32
Figure 29: Interlock switch 38
Figure 30: Location of internal fuse 41
Figure 31: Voltage principle 47
Figure 32: Pin out of the high voltage cable 47
Figure 33: Pin out of the deflector plug. 48
Figure 34: Rear panel of the PU IQE 12/38 48
Figure 35: Electronic block diagram 50
