Preparing for the installation
Install Tools and Materials
The antenna system is designed for simple installation and setup. However, the
following list of equipment or items should be available during installation of the
antenna.
■ Electric drill and drill bits
■ Socket wrench
■ Silicon sealant
■ Fastener suitable for specific application
1. Verification of the RV’s Power Supply.
■ Confirm that the RV’s power supply is 12VDC.
NOTE: Should IGN+ Close feature is to be installed/wired; permanent power
from the house battery is required. If this house power is to be isolated prior to
dish being fully closed, please contact technical@coastrv.com.au for further
assistance.
2. Verification of the Satellite Receiver and IDU’s attachment and the electricity
supply
■ Install the IDU and Satellite Receiver in the interior of the RV.
■ Connect power to IDU and Satellite Receiver.
■ Once the power of IDU and Satellite Receiver is verified, confirm that
both IDU and Satellite Receiver are working normally.
3. Procedure of the satellite’s attachment and installation.
■ Installation of the satellite must be on the flat roof surface area of the RV.
■ Connect 2x 7m coaxial cables and 1x 7m control cable to the satellites
Terminals.
■ Connect the IDU and the Satellite Receiver box with each of the coaxial cables.
■ Make sure that the satellite is working normally, once the power is supplied.
Warning: Things to consider when installing the antenna.
■ Turn off the power when attaching or detaching the antenna.
■ Make sure that the attached satellite is fixed on the flat surface.
■ when attaching, ensure that all the products are adhered properly.
■ Ensure that all the cables are connected properly.
