SPIDER SpiderPro Pad Manuale utente
How to attach your SpiderPro Pad to a ThinkTank ProSpeed Belt
Updated 3/1/12
Downloaded from
www.spiderholster.com
BEFORE YOU START:
Please take a look at the images below, as you may
have slightly different attachment instructions.
A standard, flat
SpiderPro tension clip?
A curved Adapter clip?
Please skip to page 8
for instructions
Please continue to
page 2 below
After making sure of the exact
location of the Holster on your
Think Tank belt, position your
Holster onto the belt, make sure the
insert is there (see arrow)
Thread out the screws that attach the
Fabric Pro Pad using the provided 3/32”
hex wrench. Use the same wrench to take
off the metal ProSpeed Adapter bottom
part.
Prepare the two 3/8” Phillips head screws
and insert the small washers into them at
this time.
Pro Pad
ProSpeed adapter
bottom part
2 washers
and screws
Page 2
Align the ProPad holes with the center
holes right above the insert. You will be
using these two holes to attach the Pad
to the Holster.
Make sure the ears of the Pad are
underneath the belt.
Page 3
Take the bottom part of your ProSpeed
adapter and position it under the upper
metal clip.
Insert the Phillips screw--make sure to
thread the washer under the screw head.
Carefully wrench one 3/8 PHP
screw half way using a Phillips
head driver
Page 4
Wrench the second Screw half way--
keep tightening both screws
respectively until they are firmly in.
Turn over the belt so that the Pad/
Holster are facing you
Page 5
Attach your Velcro strip wider part
over the Padʼs ear with the long end
of the Strip going down as shown.
The softer area of the Velcro strip
should be facing you.
Wrap the Velcro Strip around the belt
and to itself--make sure it is as tight
as possible!.
Page 6
Repeat the same action on the left
side using the second Velcro Strip.
The ProPad should not move in any
way at this point. You are all done!
Page 7
After making sure of the exact location
of the Holster on your belt - position
your Holster onto the belt, making sure
that the holster is aligned in between the
beltʼs loop seams.
Take out the screws and washers that
attach the SpiderPro clip. Remove the
clip.
Page 8
Page 9
Turn over the belt/holster and press on the
belt so you can see the webbing loop
Insert the flat clip in between the webbing
loop and the belt as shown
Altri manuali per SpiderPro Pad
1
Indice
Altri manuali SPIDER Accessori per fotocamere
