How to Record a Voice Activated AUDIO file:
● On the top of the device is an ON/OFF switch
● Slide the switch into the ON position.
● A RED LED light will turn on
●When the Red LED light is present. Press and Hold on the ( - ) button. The same red
light will then switch to a BLUE LED, then flash a few times before disappearing. When
you see the blue light you know you successfully started a voice activated recording.
● When finished slide the switch into the OFF position.
● Please wait about 10 seconds before starting the next recording.
NOTE: Voice activation will not extend the battery life of the device.
NOTE: If the device runs out of power during the recording, it will finalize and save the
file before the battery dies.
How to Playback Files on the Device:
● Make sure the device is turned OFF first
● When in the off position, plug in your headphones.
●Slide the switch into the ON position.
● The device will begin playing an audio file
●Blue light = music folder/Standby mode
●Red light = playback folder
● Next to the solid light are 3 buttons ( - ) , (Play/Pause ) and ( + ) button
● The (Play/Pause ) button switches the device from Music folder to Recorded files folder.
● The music folder contains a SpyCentre audio file, to switch over to your recorded files
tap the (Play/Pause ) button
● To skip to the next files press the ( - ) or (+) button.
To change the VOLUME of the recording being played Press and HOLD the ( + ) or ( - )
button.
NOTE: If the device is turned off while playing back audio on the device, the next time the
playback mode is entered the playback will continue where the file left off.
How to Playback files on a PC:
●Connect the AUX to USB cable to the device and the other end to the USB port of the
computer.
●When connected the PC will recognize the device as a removable disk.
●Open the RECORD folder
●Open the VOICE folder
●Double click to play.
