SRP BIG SHOT Manuale utente

SRP BIG SHOT® Page 1 LT218 4/9/2019

Assembly Instructions

INFRARED HEATER

WARNING

FOR YOUR SAFETY

Improper installation, adjustment, alteration, service or

maintenance can cause property damage, injury or

death. Read the installation, operating and maintenance

instructions thoroughly before installing or servicing this

equipment.

Do not store or use gasoline or other flammable vapors and

liquids in the vicinity of this or any other appliance.

If you smell gas:

1. Open windows

2. Don’t touch electrical switches

3. Extinguish any open flame

4. Immediately call your gas supplier

OWNER

INSTALLER

Retain this Manual & ensure available for service.

Improper installation, adjustment, alteration, service or

maintenance can cause injury, death or property

damage. Read the installation, operation and service

instructions thoroughly before installing or servicing this

equipment

Provide Manual to Owner upon completion of installation!

Read and thoroughly understand these Instructions before

attempting any installation

SRP BIG SHOT®

RADIANT AGRICULTURAL HEATER

WIDE HEAT DISTRIBUTION

Canada: 563 Barton Street, Stoney Creek, Ontario L8E 5S1

USA: 315 N Madison Street, Fortville, IN 46040

www.superiorradiant.com

SRP BIG SHOT® Page 2 LT218 4/9/2019

CAUTION: FIRE OR EXPLOSION HAZARD

Maintain clearance to combustible constructions as further specified in this manual. Failure to do so

could result in a serious fire hazard. Heaters should not be located in hazardous atmospheres

containing flammable vapors or combustible dusts. Signs should be provided in storage areas

specifying maximum safe stacking height.

CAUTION: MECHANICAL HAZARD

This equipment expands and contracts with each operating cycle. The gas connection, suspension

hardware and the installation itself must safely allow this movement. Failure to do so could result in

serious fire or explosion hazard.

CAUTION: FIRE OR EXPLOSION HAZARD

This heater is equipped with an automatic ignition device. Do not attempt to light the burner by

hand. Failure to comply could result in a serious fire and personal injury hazard.

CAUTION: MECHANICAL HAZARD

Do not use high pressure (above 1/2 psi) to test the gas supply system with the burners connected.

Failure to do so could result in damage to the burner and its control components requiring

replacement.

CAUTION: SERVICE LIFE RISK

Do not install equipment in atmospheres containing halogenated hydrocarbons or other corrosive

chemicals. Failure to do so may lead to premature equipment failure and invalidation of the

warranty. Additionally, it is recommended that the equipment be installed with a slope downward

and away from the burner of ¼" (6mm) in 10' (3m) to allow start-up condensate drainage.

SRP BIG SHOT® Page 3 LT218 4/9/2019

Hang these about 100” apart.

Install Tubes and U-Bolts.

Step 1:

Step 2-A:

Step 2-B:

U-Bolt with extra nuts –close to Flange. The nuts sandwich the Hanger Bracket as pictured above.

Before installing the four U-Bolts, just ONE of the U-Bolts gets extra nuts, as shown here:

100”

Thread the extra nuts upwards

(they don’t need to be tight for now)

SRP BIG SHOT® Page 4 LT218 4/9/2019

On the burner side, the distance between

the Flange and U-Bolt should be 9”

On the U-Tube side, the distance between

the Tube’s end and U-Bolt should be 10”

Fasten the remaining 8 nuts onto the U-Bolts –leave these loose until the end!

Step 3:

Step 4:

Orient the Tubes within the U-Bolts.

9”

10”

SRP BIG SHOT® Page 5 LT218 4/9/2019

Install the Baffles: Pictured below is a bottom view of the heater.

2 foot Baffle is isolated in the Flanged Tube (Combustion Tube)

6 foot and 4 foot Baffle are linked together in the Non-Flanged Tube (Return Tube)

Step 5:

2 foot Baffle

(Big Shot 80 only)

4 foot Baffle

(Big Shot 80 only)

6 foot Baffle

(Big Shot 60 and 80)

Bend Baffle Tab

over edge of Tube

at 6:00 position

Lock both Baffles together before inserting:

Align the little tabs and keyhole together at a 90 degree angle. Insert the tabs into the keyhole.

Rotate to 0 degrees, and then slide both Baffles into the Non-Flanged Tube.

Bend Baffle Tab

over edge of Tube

at 6:00 position

SRP BIG SHOT® Page 6 LT218 4/9/2019

Step 6:

The Coupling has a tab inside to dictate the depth of the Tubes and U-Tubes.

Both edges of the Tube and U-Tube should be touching.

Attach Couplings and U-Tube together.

Step 7:

Place Reflectors onto heater.

They’ll be loose for now, but these two pictures depict how

the Reflectors will be oriented once they are fastened:

SRP BIG SHOT® Page 7 LT218 4/9/2019

Step 8-A:

Install the following components, 62” (middle)

from the edge of the Reflector:

Qty 2 - CR004 Reflector Brackets

Qty 2 - CR009 Spring Clip

Qty 4 - CH044 Screw, 8-32 x 1-1/4

Hex Head, Roberston #2

62”

Step 8-B:

Set the screws to a leave a gap of no more than 0.125”

SRP BIG SHOT® Page 8 LT218 4/9/2019

Step 9:

Install the Inner End Cap with 6 screws,

as pictured here:

End Cap with flanges on the inside (hidden).

SRP BIG SHOT® Page 9 LT218 4/9/2019

Step 10:

Fasten one Hanger to the Reflector,

using the standard screws.

Secondly, hold the Reflector tight to the bracket while fastening.

Screw the bracket to the reflector.

Firstly, ensure the Hanger Bracket is

perpendicular to the Reflector, and

then follow these dimensions:

Fasten this

bracket only.

(This bracket is left free

for reflector expansion)

6”

3”

Step 10-A:

Step 10-B:

Match the profile of the Reflector and Bracket as pictured:

SRP BIG SHOT® Page 10 LT218 4/9/2019

Step 11-A:

Orient the End Caps onto the Reflector.

Step 11-B:

Fasten the End Caps with a total of 12

standard screws.

End Cap with flanges on the outside

Altri manuali SRP Stufa

SRP

SRP UAB SERIES Manuale

SRP

SRP S Series Manuale

SRP

SRP WTH Series Manuale

SRP

SRP BRL40 Series Manuale

Manuali Stufa popolari di altre marche

oventrop

oventrop Regucor Series Manuale utente

Blaze King

Blaze King CLARITY CL2118.IPI.1 Manuale utente

ELMEKO

ELMEKO ML 150 Manuale utente

BN Thermic

BN Thermic 830T Manuale utente

KING

KING K Series Guida

Empire Comfort Systems

Empire Comfort Systems RH-50-5 Guida rapida

Well Straler

Well Straler RC-16B Manuale utente

EUROM

EUROM 333299 Manuale utente

Heylo

Heylo K 170 Manuale utente

Eterna

Eterna TR70W Manuale utente

Clarke

Clarke GRH15 Manuale di istruzioni

IRSAP

IRSAP The Radiator Company Ovali Manuale utente

Empire Heating Systems

Empire Heating Systems WCC65 Manuale utente

Wetekom

Wetekom 92 86 43 Manuale utente

Desa

Desa SPC170-F Manuale utente

Watlow

Watlow Watrod Electric Tubular Heaters Manuale utente

Haverland

Haverland ECO-DRY GPS Series Manuale elenco delle parti

Stelpro

Stelpro ASILVC2060 Series Manuale utente