SRT SRT326 Manuale utente
www.srt.se
Quickstart guide SRT326
SRT3260210A14_QG_EN_STD
Speaker
Call buttonTimer button
Alarm button
GSM status
Charge indicator
Timer/Man down
status
Charge socket
SIM card slot
On/off switch
Microphone
Sending an alarm
Press the alarm button
until the device vibrates.
The personal alarm
vibrates as soon as the
alarm is registered.
Turn on/off
Move switch into on or
off position
The personal alarm
vibrates shortly and
thereafter turns on/off.
Status LEDs
Timer status LED
Charge indicator LED
(charger connected)
Charge indicator LED
(no charger connected)
GSM status LED
Solid
Searching for a GSM
network
Slow blinking
Connected to a GSM
Rapid blinking
Voice call in progress
Turned off
The device is either
turned off or in sleep
Turned off
Timer alarm not active.
Blinking three times
every 15 seconds
The device is on and
shows the battery status
with three ashes:
Blinking green
every other second
The device is on and
charging
Blinking red every other
second
The device is off and
charging
Solid green
The device is on and fully
charged
Solid red
The device is off and fully
charged
green green green
Very good
greengreen red
Good
green redred
Low
redredred
Critical
Alternating between
solid red and green
The device is shutting
down
Alternating between
solid red and green
The device is shutting
down
Charging
(desktop stand)
Lift the rubber ap on
the side of the device.
Insert the charger
cable into the mini
USB connector.
The charge indicator
LED will blink red or
green when charging.
The charge indicator
LED will turn into a solid
red or green when the
device is fully charged.
Place the unit in the charge
stand.
Charging (USB)
Charging times
Before using your alarm
device the rst time it
should be charged for 4
hours. Whenever the bat-
tery is fully discharged it
should be charged for at
least 4 hours. The device
should be charged daily.
Blinking (red)
Timer alarm active.
www.srt.se
Altri manuali SRT GPS
