Installing the VHD-V61 camera
Before you installthe camera, read the following safety information:
nDo not subject the camera to rain or moisture
nTo prevent electric shock, do not remove screws or covers of the camera. There
are no self-serviceable parts. Refer to qualified service personnel for servicing
nDo not operate under unspecified temperature, humidity or power supply
nUse the soft dry cloth to clean the camera. If the camera is very dirty,clean it with
diluted neutral detergent; do not use anytype of solvent, which may damage the
surface
nThe installation must be performed by qualified service personnel or system installers
in accordance with all local rules
nDo not move the camera head manually. Doing so results inthe camera
malfunctioning
nBefore powering the camera, check the power voltage carefully. Ensure you are
using the correct power source
nEnsure that the camera is far awayfrom areas where there might be radiation, x-
rays, or strong electric waves, or where magnetism is generated
The rear view of the camera, shown below, indicates where to connect the cables:
To install the camera:
1. Connect the supplied HDMI-HDMI cable to the HDMI connector on the camera.
Connect the other end to the Camera-In connector on the StarLeaf room system.
2. Connect the supplied VISCA camera control cable to the RS-232 IN connector on
the camera. Connect the other end to the room system Camera Control
connector.
3. Connect power to the DC 12V power input connector.
Note: The selector switches on the rear of the camera have no effect on the operation
of the camera.
480-00260-02
