6 7
3. Ensure the plastic clips of the mounting frame are facing into
the hole as shown.
4. Feed the full system through the forearm, and pull the Display
through so it exits the forearm through the mounting frame
hole. If a bend is required to allow the ribbon cable to run
along the forearm, carefully fold it at a minimum distance of
5mm from the Display. Use the extension cable, if required, to
ensure that the cable is not strained (with extra care required
at the joint with the Display).
5. Sit the Display flat on top of the mounting frame and push
the corners of the display until it clicks into place. The front of
the display should sit flush with the mounting frame and the
whole unit should feel secure in the forearm. Use the green
dispenser tip to apply silicone sealant to the gap between the
Display unit and the mounting frame ensuring it is water tight.
6. Secure the system inside the forearm using hook and loop
fasteners or similar to prevent movement.
When putting the Display into the forearm, use the edges of the four corners to gently push the S-Charge
Display into position, ensuring that too much force isn’t exerted directly onto the Display itself.
The Steeper S-Charge System and its associated components are not waterproof and should not be exposed
to moisture. Ingress of moisture may cause corrosion and potentially severe damage.
These products are not designed to be opened and have no user accessible or replaceable internal
components.
In the event of failure or suspected malfunction, please contact Steeper or your supplier.
If the S-Charge System or components have either been in storage or have been transported for longer than 1
hour, please leave in an ambient temperature (20°C) for a minimum of 2 hours before use.
Warning: do not modify this equipment.
For further information or troubleshooting guidance, please refer to the S-Charge System Technical Manual
on the Steeper website.
S-Charge System: Important Information
