INTRODUCTION
Thank you for purchasing a Sterling Pro Bottle Cooler. The range has been designed and
manufactured to high standards to give a long and reliable life.
Please read carefully the contents of this manual and ensure installation and operation
instructions are followed. Failure to comply with instructions may cause operational faults
or affect your warranty.
USE AND RESTRICTIONS
The Sterling Pro coolers have been designed to chill pre-packaged bottled or canned drinks
only.
The cabinets are designed for indoor use only in ambient temperatures from +12OC to +32OC
65% humidity.
INSTALLATION
Please follow these instructions carefully, if the appliance is installed incorrectly then the
performance and reliability will be reduced.
Electrical installation should only be carried out by a suitable trained person.
INSPECTION
Inspect the appliance for any superficial damage on receipt and record any findings on the
Carrier’s delivery note also notify your supplier immediately. You have 24 hours to report
damage to your retailer.
HANDLING
Do not drag the appliance, transport with a suitable padded sack barrow; do not put
pressure onto the glass doors.
Keep the appliance vertical and on its base; do not tip upside down. If the appliance has been
tipped onto its back, side or front then leave the cabinet standing on its base for 2 hours before
switching on.
LOCATION
Place the appliance on a flat level surface in a well ventilated position away from any heat
sources. It should not be exposed to any water spillage, spray, steam or high humidity. The
appliance can be placed under a work top providing there is at least 40mm clearance to the
sides 50mm to the rear and 20mm to the top of the cabinet. The greater the ventilation around
the cabinet the lower its energy consumption will be. The front grill must be kept clean and
clear at all times to ensure optimal cooling.
ELECTRICAL CONNECTION
This appliance must be earthed; do not switch on until installation has been completed.
The appliance comes with a factory fitted supply lead complete with a 13A 3 pin plug therefore
it only needs to be connected to a suitable power point.
A power socket of type earthed 13A 240V and protected by a RCCB (residual current circuit
breaker) should be used which is easily accessible for the isolation of the appliance.
The socket should be installed in accordance with current I.E.E. regulations if in doubt contact
a qualified electrician.
