Assembly: Refer to separate assembly instruction sheet enclosed.
Handle Position: Adjust the handle to the desired height and lock cam handle lever.
WARNING: Do not turn machine when handle is in upright locked position.
About the Machine
WARNING RISK OF POTENTIAL INJURY: To reduce the risk of injury, unplug before adding the drive pad assem-
bly or any other service to the machine.
WARNING: Improper connection of the machine grounding conductor can result in a risk of electric shock.
GROUNDING: This machine must be grounded. If it should malfunction or breakdown, grounding provides a path
of least resistance for electric current to reduce the risk of electric shock. This machine is equipped with a cord having
equipment grounding conductor and grounding plug. The plug must be inserted into an appropriate outlet that is
properly installed and grounded in accordance with all local codes and ordinances.
Consult with a qualied electrician or technician if you are in doubt as to the electrical outlet being properly ground-
ed. Do not modify the plug equipped with this machine. If the machine does not t the electrical outlet, arrange for a
proper outlet to be installed by a qualied electrician.
This machine is for use on a nominal 120-volt circuit. It has a grounded plug that looks like the plug illustrated in
Figure A below. A temporary adapter that looks like the adapter illustrated in Figures B and C may be used to connect
this plug to a 2-pole receptacle as shown in Figure B if a properly grounded receptacle is not available. The temporary
adapter should be used only until a properly grounded outlet (Figure A) can be installed by a qualied electrician. The
green colored ear, lug, or the like extending from the adapter must be connected to a permanent ground such as a
properly grounded outlet box cover. Whenever the adapter is used, it must be held in place by a metal screws.
NOTE: In Canada, the use of a temporary adapter is not permitted by the Canadian Electrical Code.
Brush Attachment Removal:
With cable unplugged, LOCK handle in upright position and tilt machine back on the handle until the underside of the
machine is visible. For scrubbing, polishing brushes and/or pad drivers which utilize synthetic oor pads, position the
three slots of the center clutch plate over the three lugs on the gearbox or transmission. Turn the brush to the left, as far
as it will go until secure and in a ready-to-use position. If using synthetic oor pads, it is easier to attach the oor pad
prior to installing drive pad assembly. To remove, turn the brush or pad driver to the right and disengage the cloth plate
from the gearbox or transmission.
