Stermay M1 Manuale utente
USER MANAUL
UNDERWATER SCOOTER
STERMAY M1
Please read the operation instructions carefully before using this product.
Please operate in the correct way based on complete understanding.
STERMAY
Honor customers
STERMAY M1 is one type technology products which able to provide thrust power for you under water. It has small body, portable and
disassemble structure, easy to carry, use and renewal. Machine body bottom set integrated type outer configured sliding rail, coordinate
the switch part according to your requirements, able to carry different outer configure equipment (SUP, sport camera, lighting lamp, etc).
OLED display screen on machine able to indicate gear, power, signal and other information.
STERMAY M1 provide 3 types different speed for you, easily realize diving, surfing and other water recreational activities ,provide one
complete new experience!
Please read this USER MANAUL before install and use the product carefully to make you correctly use this product, strictly follow
the operation instruction to correctly install and use, avoid incorrectly install and use to caused accidents!
Please safety keep User Operation Instruction for future reference.
Hope you happily operating !
Thank you for you choice STERMAY M1!
STERMAY
Caution！
！This device complies with Part 15 of the FCC Rules / Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).
Operation is subject to the following two conditions: (1) this device may not cause harmful interference. (2) this device must accept any
interference received, including interference that may cause undesired operation.
！L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et
Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux
conditions suivantes : 1. L’appareil ne doit pas produire de brouillage; 2. L’appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d’en compromettre le fonctionnement.
！Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the
equipment.
！NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
STERMAY
1. Product overview
1.1 Product overview............................03
2. Safety warnings
2.1 Safety warnings...............................03
6. Operating instruction
6.1 How to use when diving .............................11
6.2 How to use when suspended on SUP........12
7. Outer configure equipment installation
methods
7.1 Install the M1 on the SUP...........................13-14
7.2 Install the sport camear on the M1............15
8. Maintenance
8.1 Cleaning after use ......................................16
8.2 Storage ........................................................16
8.3 Disposal at end-of-life ................................16
8.4 Warranty Policy...........................................17
3. Product Introduction
3.1 Package list .....................................06
3.2 Specification ...................................06
3.3 Product diagram.............................07
4. Assembling Instruction
4.1 Install the Battery...........................08
4.2 Remove the Battery........................08
4.3 Handle assembling.........................09
5. Charging Instruction
5.1 Battery charging .............................10
5.2 Remote Handle charging ...............10
Content
02
STERMAY
STERMAY M1 formed with head cover, body, remote handle, handle, propeller and tail cover, the power system integrated into
machine body, remote handle set signal remote system. Face of machine set OLED display screen that indicate the signal connection,
rest power volume, speed mode and other information.
STERMAY M1 able to assort the switch part to connect the over water carriage tools such as canoe to use, also able to carriage
underwater sport camera, lighting lamp and other equipment to record the underwater beautiful moment .
1. Product overview
This operation instruction recorded the correct and safety operating method and other important text contents to avoid it
hurt you and caused loss. Icon and diagram explain symbols are help you understand, maybe different to entities. Please
read and understand the relate marks and notes carefully before use the Stermay M1, and strictly follow it.
Please safety keep the operation instruction for future reference use.
Model reference for the battery of main unit M1-01 , main part battery charger XSG2552500 and USB charger K05V050100U.
2. SAFETY WARNINGS
03
！Do not use the product for users whose body status unsuitable to swim, snorkeling and diving sports.
！Do not use this product under the situation that affected by ethyl alcohol or medicine.
！Do not wear the articles which not relate to swim, such as necklace, ring, earrings and wrist-watches, etc.
！Do not use this product under bad weather, such as thunderstrom, typhoon, hail, cold waves, sea status above level 3, etc.
！Do not use this product under the dangerous environment such as water plants, shark, reef, sand stone and others.
！This product is amusement equipment, not applied in lifesaving.
！This product is for Single user only.
！This product only can be used in water, please don’t idle in air when not use,avoid the motor burned because too heat.
！This product and the accessories can’t close to fire source, can’t heavily press.
！The operating temperature of this product is 5℃-40℃,the storage temperature of any accessory of this product is 0℃-40℃.
！Before using this product, please make sure this product can work normally and the battery has enough power.
！Before using this product, please make sure that the water is suitable for swimming, snorkeling,etc., and the product is allowed.
STERMAY
04
！This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved.
！Children shall not play with the appliance.
！Cleaning and user maintenance shall not be made by children without supervision.
！For main unit: • Rechargeable batteries are to be removed from the appliance before being charged;
• Batteries are to be inserted with the correct polarity;
• If the appliance is to be stored unused for a long period, the batteries should be removed;
• The supply terminals are not to be short-circuited;
！For remote handle:
！In case of any damaged power cord, it must be replaced by the manufacturer or its service agent or similar authorized personnel to
avoid any possible danger.
• This part contains non replaceable batteries.
STERMAY
！Before using this product,please take protective measure,be sure to wear the life jacket or life saving equipment, and accompanied
by the diver with experience.
！When useing this product，please wear life jacket or life-saving equipment, wear well swim cap, never dress the loosen cloth, keep
safety distance with the people who are long hair or dress loosen cloth, avoid the long hair or loosen cloth rolling into propeller.
！When using this product,pay attention to surrounding environment to avoid collisions, don’t make the algae, ropes or other debris
rolling into propeller.
！Please tightly hold the handle when using this product,don’t make the head or tail of this product align to you or other people face.
！Please don’t use this product on the coastal beach, avid the sand, conch and other thin and small varias rolling into propeller.
！Please don’t use this product to dive into the depth under 5m.
！Please make ensure the battery and charger are dry before charging.
！The surrounding temperture range should keep at 10℃-40℃ when battery charging.
！Only use the charger equipped with the M1 underwater thruster.
！Only use the supply unit provided with M1 appliance to charge the battery.Other chargers are not allowed.
！Connect the charger into electric circuit first then connect the charger with battery when battery charging.
！Disconnect the charger from the circuit after charging, then disconnect the battery from the charger.
！The battery of this product can’t be disassembles, rebuild and damp.
！When you install，remove,and store the battery ,please keep this product and your hands dry and do it in a dry environment.
！If the battery send out any abnormal or deformation during usi
！Please keep the product ,including the battery,away from the water while charging.
ng or charging, please stop use or charging immediately.
！Please don’t place the battery into one sealed container to charge.
！Please don’t place the battery into where has water to charge in order to caused the battery and battery charger short circuit.
！Please don’t use when machine occur failure.
！Need renewal battery in time when battery damaged, not fully charged or battery working life obviously reduced.
！Person without permission shouldn’t repair arbitraily,unsuitably repair will caused the product leak water, damaged, fire or electric
shock.
05
STERMAY
·Main Unit*1 ·Remote Handle*1 ·Handle*1 ·Bettery*1
·Type-C*1 ·Typy-C adapter*1 ·Remote handle anti
lose rope (long type)*1
·User Manual*1
·Switching power
supply*1
·Connect Bracket
A*1
·Connect Bracket
B*1
·Camera Bracket*1
3.1 Package list
3. Product Introduction
3.2 Specification
The while machine
Size 41 x 33.5 x 17.2 (cm) 22.2V 100~240V
25.2V
2.5A
4500mAh
~3 H
0.65 kg
2.5 kg (includng Battery)
280W
5Km/h(Maxmium)
High / Medium / Low
~5m(Limit depth)
30~60 mins(Normal Using)
Sport Camera/SUP, etc
Weight
Power
Speed
Speed Setting
Working Depth
Durable time
Add-on Support
Battery Switching Power Supply
Charging Volage
Charging Current
Rate Capacity
Charging Time
Weight
Input Voltage
Output Votage
2.5A
Output Current
·Remote handle anti
lose rope(short type)*1
·O Ring*2
06
Please check whether your product package include the above articles before use this
product, if loss then please contact your distributor.
Please check whether appearance of the new machine has damages carefully after
unpacking.
STERMAY
3.3 Product diagram
Fast disassemble
Display screen
Power switch
Start-stop button
Handle Lock
Handle Lock
Track
Tail Cover
Head Cover
Top View
Bottom View
Reomte
Handle
Handle
Main Unit
07
STERMAY
4. Assembling Instruction
Must check and make ensure that installed the“O”seal ring before
connect power supply.
This product only allow adult carry out assembly work and strictly
follow this operating stipulates.
1.Press the Fast Disassemble Button to remove the Head Cover.
2.Push the Battery into cabin according the shape of Battery
Compartment until the bottom.
3.Force to tightly insert after make the Fix Position Groove of power
supply joint outer wall on Main Unit corresponding to the Convex
Rib on internal wall of battery power supply joint.
4.Turn Tighten Nut clockwise until tightened.
5.Make the Head Cover align to slot of Main Unit, lightly squeeze
and send out “Ta” sound then means it tightly locked.
4.1 Install the Battery
1.Press the Fast Disassemble Button to remove the Head Cover.
2.Turn the Tighten Nut counterclockwise until loosened.
3.Plug out the main unit power supply joint from the battery’s.
4.Remove the Battery from the Compartment by draging the
Lanyard on the battery.
5.Make the Head Cover align to slot of Main Unit, lightly squeeze
and send out “Ta” sound then means it tightly locked.
4.2 Remove the Battery
Battery
Head Cover
Tighten Nut
Fast Disassemble
Button
“O”seal ring
Battery
Compartment
Main Unit
Lanyard
08
Main Unit power supply joint
Fix Position
Groove
Battery power supply joint
Convex Rib
Lanyard
Indice
