STO N SHO SNS 288 Guida di riferimento

Installation Procedures

2021 BMW M3

SNS 288

Warning: Please read directions completely before starting. If you have any

questions, please contact STO NSHO, LLC before beginning your installation. Also,

please check our website (www.stonsho.com)for any updates or changes. Thank

You.

Parts Included: License Plate mounting bracket Assembly. Includes Base Plate and

License Plate Holder.

License Plate mounting Screws: (4) 6mm X 12mm (Phillips head) and

6mm nuts (10mm wrench size)

Base plate mounting screws: (2) Factory Screws removed and reused.

Tools Needed: 10mm socket with ratchet Note: 1/4 inch drive referred but 3/8 will work

but extra caution will be needed when tightening bolts.

Phillips screwdriver, and 10mm wrench

Step 1: Ensure all parts listed above are accounted for. Note: If at any time during the

installation process you need assistance please call (408) 776-4080.

Step 2: Separate the license plate holder from the base by simply pulling the pull pin ring

outward and sliding apart.

Step 3: Remove the two center screws as shown in figure 1. Position the base mount with the

pull pin on the right side as you are looking at the vehicle and line up to two holes where the

two factory screws were just removed. See figure 2.

Step 4: Using the two factory screws removed secure the base plate to the vehicle. See figure 3.

Step 5: Secure the license plate and frame (optional) to the license plate bracket using the

screws and nuts provided. Requires the Phillips screwdriver and 10mm wrench (Not included).

Step 6: Slide the license plate rods into the two tubes located on the base plate. Slide the rods

into the tubes until the rods hit the pull pin. Simply pull the ring on the pull pin and advance the

rods. Release ring and continue to advance rods until the pull pin locks into place. NOTE: The

rods and spring-loaded pull pin are required to be sprayed periodically with WD-40 or any

other silicone type spray lube. Failure to do so could result in either the failure of the pull pin

or the rods becoming difficult to remove or reinsert. Note: In harsh environments, such as

areas where roads are either salted or sanded in the winter, spraying of the rods and pull pin

should be performed on a regular basis. Failure to provide this maintenance may void your

warranty. See figure 4. In some occasions the license plate may require a little adjustment to

level. Simply pull pin and slide plate out approximately two inches, grab frame at arrows (See

figure 5) and rotate. If plate is high on left or right side, rotate high side down slightly and

release. Verify alignment and repeat as necessary. Once leveled plate will remain level.

Congratulations! You have just installed the STO N SHOTM (Patented) front license plate

mounting system. Thank You for your purchase.

Caution: Bracket lowers ground clearance by approx 1/2 inch.

Remove prior to entering automated car wash

Exercise care when entering or exiting steep driveways or damage will occur

Parking Stops or high curbs, stop well before or damage will occur

Remove prior to running on track or racing

If unsure, have bracket installed by your local Dealer or Body shop.

Limited Lifetime Warranty (Excluding Pull-pin). Pull pin will be warrantied for a period of 1 year

(12 months) from the date of purchase.

STO NSHO, LLC warrants to the original purchaser only that this product will be free of

manufacturing defects in material and workmanship for the life of the product (Excluding pull-

pin, see above) provided all maintenance is performed as required to the limitations and

exclusions set forth below:

Return product to any authorized dealer. Contact STO NSHO, LLC for the dealer nearest you.

Upon examination, STO NSHO, LLC or its representative will, at its sole option and expense,

repair or replace any product found to be defective. If product to be replaced via mail, STO

NSHO, LLC will return the repaired or replaced unit to you via its usual shipping method from

the factory to your address in the United States of America or Canada only. Any shipping costs

for addresses outside of the United States or Canada shall be the responsibility of the

purchaser.

This warranty is not transferable.

REMEDIES FOR BREACH OF WARRANTY.

This Warranty does not include repair for damage caused by improper use or handling,

including but not limited to damage caused by accident, mishandling, improper installation,

abuse, negligence, or any defect caused by repair to the product by anyone other than STO

NSHO, LLC.

This warranty does not cover reimbursement for your costs of removing and transporting the

product for warranty service evaluation, or installation of any replacement product provided

under this warranty.

This Warranty will be void if the product was not purchased from an authorized dealer or

reseller.

THE FOREGOING WARRANTIES ARE EXCLUSIVE AND IN LIEU OF ALL OTHER EXPRESSED AND

IMPLIED WARRANTIES. ALL SUCH OTHER WARRANTIES, INCLUDING BUT NOT LIMITED TO

IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND NON-

INFRINGEMENT, WITH RESPECT TO THE PRODUCT. TO THE MAXIMUM EXTENT PERMITTED BY

LAW, STO NSHO, LLC SHALL NOT BE RESPONSIBLE FOR ANY INCIDENTAL OR CONSEQUENTIAL

DAMAGES EXCEPT TO THE EXTENT PROVIDED (OR PROHIBITED) BY APPLICABLE LAW, EVEN IF

STO NSHO, LLC HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.

Notwithstanding the above, if you qualify as a “consumer” under the Magnuson-Moss

Warranty Act, or applicable state laws, then you may be entitled to any implied warranties

allowed by law for the Warranty Period. Further, some states do not allow limitations on how

long an implied warranty lasts or allow the exclusion or limitation of consequential damages, so

such limitations may not apply to you. This warranty gives you specific legal rights, and you may

also have other rights which vary from state to state.

For the name of your nearest authorized STO N SHO dealer, contact: STO N SHO, LLC at (408)

776-4080 or go to www.stonsho.com

Fig 1

Fig 2

Fig 3

Fig 4

Fig 5

Indice

Altri manuali STO N SHO Accessori per automobili

STO N SHO

STO N SHO SNS 61 Guida di riferimento

STO N SHO

STO N SHO SNS 152 Guida di riferimento

STO N SHO

STO N SHO SNS 374 Guida di riferimento

STO N SHO

STO N SHO SNS 31 Guida di riferimento

STO N SHO

STO N SHO SNS 85 Guida di riferimento

STO N SHO

STO N SHO SNS 117 Guida di riferimento

STO N SHO

STO N SHO SNS 342 Guida di riferimento

STO N SHO

STO N SHO SNS 244 Guida di riferimento

STO N SHO

STO N SHO SNS 12 Guida di riferimento

STO N SHO

STO N SHO SNS 335 Guida di riferimento

STO N SHO

STO N SHO SNS 130 Guida di riferimento

STO N SHO

STO N SHO SNS 13 Guida di riferimento

STO N SHO

STO N SHO SNS 352 Guida di riferimento

STO N SHO

STO N SHO SNS 268 Guida di riferimento

STO N SHO

STO N SHO SNS 157 Guida di riferimento

STO N SHO

STO N SHO SNS 275 Guida di riferimento

STO N SHO

STO N SHO SNS 32 Guida di riferimento

STO N SHO

STO N SHO SNS 119 Guida di riferimento

STO N SHO

STO N SHO SNS 187 Guida di riferimento

STO N SHO

STO N SHO SNS 159 Guida di riferimento

STO N SHO

STO N SHO BIG MIKE SNS 139 Guida di riferimento

STO N SHO

STO N SHO SNS 138a Guida di riferimento

STO N SHO

STO N SHO SNS 276 Guida di riferimento

STO N SHO

STO N SHO SNS 285 Guida di riferimento

Manuali Accessori per automobili popolari di altre marche

James Baroud

James Baroud Odyssey Manuale utente

Motorola

Motorola i50sx Manuale utente

Yakima

Yakima 9MM STANDARD BIKE MOUNT Manuale utente

Feniex

Feniex T3 Manuale utente

Renault

Renault 77 11 423 180 Manuale utente

Kia

Kia E8300-4D000 Manuale utente

Brink

Brink 756843 Manuale utente

Whispbar

Whispbar K085W Manuale utente

v.link

v.link CI-VL2-PC-HSD Manuale utente

Viking

Viking Stack-Rack Guida rapida alla configurazione

Aries

Aries 203015 Manuale utente

Choetech

Choetech AT0005 Manuale utente

ZZ2

ZZ2 ZZAIR-PRO Manuale utente

Holman

Holman 4A80L Manuale utente

Thule

Thule 2075 Manuale utente

Motorola

Motorola T325 Manuale utente

TAUBENREUTHER

TAUBENREUTHER 16-3950 Guida all'installazione

DV8

DV8 FBJL-02 Manuale utente