ADDITIONAL WARNINGS
WARNINGS
WARNING: Do NOT look directly at LED light sources.
WARNING: Avoid direct contact with water.
SAFETY AND PRECAUTIONS
1. Suitable for indoor and outdoor use. Not for use with direct contact with water.
2. Do NOT look directly at LED light sources.
3. The LED modules used in this fixture are not serviceable.
4. This product is inspected prior to shipping. Do not use if product is cracked, broken or missing parts.
5. Suitable for use in operating environments ranging between -13° to 113°F (-25° to 45° C). Lifetime of this product may be
reduced with prolonged exposure to extreme temperatures.
WARNING: Avoid using this product in the immediate
vicinity of highly flammable materials, liquids and gases.
WARNING: This light is not waterproof.
WARNING: DO NOT alter or disassemble the fixture. It is
completely enclosed and does not contain replaceable or
serviceable parts.
2
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interfer-
ence, and (2) this device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or
modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
The user is cautioned that any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority
to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no guarantee that the interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
1) Reorient or relocate the receiving antenna. 2) Increase the separation between the equipment and receiver. 3) Connect the equipment into an outlet
on a circuit different from that of the receiver. 4) Consult the dealer or an experienced radio/TV technician for help.
1. Attach the handle to the mounting
crossbar by aligning the holes on the
crossbar with the holes in the handle
mounting plate (Fig 1). Insert the two
small star knob fasteners through the
handle mounting plate and into the
threaded holes in the crossbar and
tighten until the handle is securely
attached (Fig 2).
2. Add both lights to the
crossbar (Fig 3). by
fastening the medium star
knob fastener through the
center hole in the leg
stand of each light and into
the threaded hole on the
mounting crossbar (Fig 4).
Tighten each down until
secure.
DIMMING
• DO NOT USE THIS FIXTURE WITH DIMMERS.
Doing so will void the warranty of this product.
WARNING: Use only in 100-227v, 60Hz circuits.
ASSEMBLY INSTRUCTIONS
Fig 1
Fig 3
Fig 2
Fig 4
