StorageTek FLEXLINE 96126 Manuale utente

PART NUMBER EDITION NUMBER

PRODUCT TYPE

SOLUTIONS

FLEXLINE

ONLINE STORAGE SYSTEMS

INSTALLATION INSTRUCTIONS FOR SOLARIS

Open Systems Host Attach

96126 2

FlexLine™

200/300 Series

Installation Instructions

for SOLARIS open

systems disk host attach

ii Second Edition 96126

StorageTek Proprietary

Information in this file is subject to change. In the event of changes, the information

will be revised. Comments concerning its contents should be directed to:

200/300 Series Program Manager

Storage Technology Corporation

One StorageTek Drive

Louisville, CO 80028-2129

or sent email to: glsfs@stortek.com

Export Destination Control Statement

These commodities, technology or software were exported from the United States in

accordance with the Export Administration Regulations. Diversion contrary to U.S. law is

prohibited.

Proprietary Information Statement

This document and its contents are proprietary to Storage Technology Corporation and may

be used only under the terms of the product license or nondisclosure agreement. The

information in this document, including any associated software program, may not be

reproduced, disclosed or distributed in any manner without the written consent of Storage

Technology Corporation.

logo are trademarks or registered trademarks of Storage Technology Corporation. Other

products and names mentioned herein are for identification purposes only and may be

trademarks of their respective companies.

Information Control

The information in this document, including any associated software program, may not be

reproduced, disclosed or distributed in any manner without the written consent of Storage

Technology Corporation.

Should this publication be found, please return it to StorageTek, One StorageTek Drive,

Louisville, CO 80028-5214, USA. Postage is guaranteed.

96096 Second Edition iii

StorageTek Proprietary

Summary of Changes

The following is the history and summary of changes for this publication.

Date Edition Description

October 2003 First Initial Release

October 2004 Second Updated to reflect new FlexLIne™ terminology

Summary of Changes

iv Second Edition 96096

StorageTek Proprietary

This page intentionally left blank.

96126 Second Edition 1

StorageTek Proprietary

Solaris - Installation

Instructions

The following pages help ensure that you order and configure a viable solution

for your SUN operating environment running Solaris 2.7, 2.8, or 2.9 (and

appropriate patches - see Table 1 on page 5). Customers and StorageTek

personnel should also be familiar with the FlexLine™ 200/300 Series storage

system Site Preparation Guide, the Storage Manager Concepts Guide, and

the Storage System Planning Checklist.

■Introduction

This manual is organized to help plan your SUN Solaris configuration, provide

order information, and help to install and attach your storage system to the

SUN host server running Solaris. The following should be used in conjunction

with the Siebel configurator.

Plan your site configuration

Prior to placing an order for StorageTek storage equipment, one should make

sure of the system needs. First measure the locations of each current and

future host, storage system, and other network components. Fill in this form

with the requested information.

✔Parameter Outcome

Solaris operating system

Distance between host and storage

system

Distance between other devices

Number of HBAs needed (two are

recommended)

Number of storage systems being

installed

Number of FC cables needed

Solaris - Installation Instructions-

2 Second Edition 96126

StorageTek Proprietary

Select Host Adapter (s)

Pick the type and quantity of the fibre channel Host Bus Adapters (HBAs)

needed for your host systems. Refer to the Interop Tool for connectivity

information.

Select the Fibre Channel Cables

Select the length of fiber optic (or copper) cable and the quantity for

connection to the host systems. The following is an example of optical cables

that may be ordered through StorageTek to attach a QLA2300F HBA to the

Control Module (aka Controller). Write in the quantities needed.

There are also LC to SC cables that would allow one to use a 2 Gb HBA and

cables with existing switches. The following cables are available in this event.

Quantity 2 Gb FC Optical Cable Description Part #

10 meters (32.8 feet) LC to LC Duplex 10800221

50 meters (164 feet) LC to LC Duplex 10800222

100 meters (328 feet) LC to LC Duplex 10800223

Note: Other lengths are available. Consult the Siebel Configurator.

96126 Second Edition 3

StorageTek Proprietary

Introduction

If installing through a switch, you may need a set of the following.

Check your quantities against your earlier distance measurements to ensure

your order includes all cable attachments. Also, if ordering copper cables,

make sure that the connector ends meet your need. One end mates with the

HBA, and the other end, typically, mates with the control module’s host

interface minihubs (or array module host ports).

Note: Unless there is an existing management station, cable connections to

the management station should be via 10BaseT Ethernet.

Typically, LC to LC Duplex Fibre Channel short wave optical cables are used

with the HBAs and the controller’s host minihubs, which have Small Form

Factor Packaged (SFP) Transceivers.

Place your Order

Make sure that you have the following.

When you make a new order, a CD-ROM along with a CD insert, commonly

called a Quick Start Guide will be in your host attach kit. The Quick Start Guide

will walk you through your installation—first referring you to the

Preconfiguration and Maintenance Setup Instructions, P/N 95966, and then to

any special instructions written to support your particular operating system

installation.

Quantity FC Optical Cable Description Part #

10 meters (32.8 feet) LC to SC 10800231

50 meters (164 feet) LC to SC 10800232

100 meters (328 feet) LC to SC 10800233

Quantity 1 Gb FC Optical Cable Description Part #

10 meters (32.8 feet) SC to SC Duplex 10800134

50 meters (164 feet) SC to SC Duplex 10800137

100 meters (328 feet) SC to SC Duplex 10800138

Note: Other lengths are available. Consult the Siebel Configurator.

✔Description

SUN Server running Solaris 2.7, 8, or 9 (and appropriate patches)

HBA(s)

Fibre Channel cables to configure your subsystem

Solaris - Installation Instructions-

4 Second Edition 96126

StorageTek Proprietary

CD-ROM file structure

During your installation you will be asked to install files from the CD supplied in

your host-attach kit. The CD is structured (in most cases) with two main

folders (Docs and Software). Inside the Docs folder are subfolders with

pertinent documentation. The following table shows the subfolder names.

Inside the Software folder you will find files called: client, agent, runtime,

RDAC, and utilities.

Note: Some operating systems will have additional directories such as a

Host Adapter, MIBs, or a Drivers folder.

A special SMclient (Field Tool) CD is available and required to fulfill your

preconfiguration requirements. It has special software tasks and applications

that may be necessary to upgrade your storage system.

Note: Refer also to the PDF documents and configuration and support files

to assist with your installation, and use the Interop Tool to get the latest

connectivity information.

■Storage System and Storage Manager - Overview

FlexLine™ 200/300 Series storage systems provide access to high-end

storage using Fibre Channel and RAID technology.

This document was created to aid in installing a storage system into a Solaris

operating environment. It includes driver information, steps to take when

planning and assembling a SAN installation, and a list of frequently asked

questions (and problems) that may be encountered. This manual is intended

to provide tips on attaching or creating a SAN environment as well as giving

some examples of problems that have been encountered.

In addition to this manual, information is available on the CRC by going to

Current Products >> Disk or Current Products >> Software. The CRC also has

tech tips, FAQs, notices and bulletins, and software updates.

Note: Firmware and NVSRAM updates may be downloaded from the CRC.

Backup documentation is on the engineering web page at:

http://gandalf.stortek.com/ctp/index.html

Sales and Preinstall Diagnostic and Service Engineering Papers

Hardware Install Cabinet Docs Miscellaneous

Software Install Release Notes

Questo manuale è adatto per i seguenti modelli

Indice

Altri manuali StorageTek Hardware di rete

StorageTek

StorageTek Flexline 96127 Manuale utente

Manuali Hardware di rete popolari di altre marche

Matrix Switch Corporation

Matrix Switch Corporation MSC-HD161DEL Manuale utente

B&B Electronics

B&B Electronics ZXT9-IO-222R2 Manuale utente

Yudor

Yudor YDS-16 Manuale utente

D-Link

D-Link ShareCenter DNS-320L Manuale utente

Samsung

Samsung ES1642dc Istruzioni per l’uso

Honeywell Home

Honeywell Home LTEM-PV Istruzioni per il montaggio

evertz

evertz 7700 Series Manuale utente

D-Link

D-Link ShareCenter DNS-343 Manuale utente

Asante

Asante AsanteBridge 1012 Manuale utente

FireBrick

FireBrick FB2700 Manuale utente

Audiovox Electronics

Audiovox Electronics ARWH2T Manuale utente

ADC

ADC DSX-1 Manuale

NetComm

NetComm NF2 Manuale utente

Alcatel-Lucent

Alcatel-Lucent 5620 Manuale utente

Dell EMC

Dell EMC XC6420 Series Manuale utente

Lanner

Lanner NCA-1020A Manuale utente

Allied Telesis

Allied Telesis AT-TN121-A Manuale utente

Arista

Arista CCA-ETM-Q12 Manuale utente