Installation Manual - 300 Series Consoles & 310 Show Controller
Getting Started
The processor unit is designed to sit on a desk, or to be mounted onto, or under
a desk, or wall-mounted, or mounted within a 19 inch rack unit. Multi-purpose
brackets are supplied with the unit as shown.
Mounting the processor unit
(including 310 Show Controller)
Under Desk
Mounting
Fixed to Desk
Fixed to Wall
Note: Allstandardmodelsaresupplied
daisy-chained with a line terminator on
the last module. Additional modules
can be added to the daisy chain, and
the line terminator moved to the last
module. Alternatively, remote modules
can be connected to one of the other
RJ45 Sbus connectors.
Important Note: Do not fit or remove
the Sbus connectors unless the con-
sole has completely powered down.
Underside of command
module
Cat 5 cable
RJ45 Sbus connector
on Processor unit
Connecting The processor to the
Command Module
(Optional on 310 Show Controller)
19 in Rack Unit
Page 5
Note: The equipment can be mounted
to a wall with the brackets supplied.
Ensurethefixings(e.g.wallscrews)are
suitable for the weight of the unit and
are of sufficient size for the slots
provided in the back plate. The unit
can be regarded as wall mounted
moveable equipment. The means of
fasteningmustpermitreadyremovalfor
maintenance and repair. Therefore
after hanging the unit on its brackets,
do not tighten the screws fully, so that
the unit can be lifted from the wall.
When rack mounting, ensure that no
hazardous conditions are created due
to uneven mechanical loading.
Ensure that reliable earthing of the
equipment is maintained at all times.
Consideration should be given to the
supply circuit feeding the equipment
and the effect that overloading might
have on overcurrent protection and the
supply wiring.
