Reflection film installation
First, place the supplied non-slip mat on the dashboard, and place the HUD on it.
Second, please stick the reflection film on the windscreen.
Please Note:
The HUD will project the display information on the car windscreen, if you see a
double image on the windscreen when the HUD is projecting information, you will
need to install the reflection film (supplied) on the windscreen. If you can see a clear
display of information, then there is no need to use the reflection film.
The reflecting film should be pasted above the host machine and it should be able to
reflect the whole display screen.
Methods of pasting the film:
1. Spray some water on the place that the film will be pasted on the windscreen;
2. Remove the backing sheetmarked 1) of reflection film and place on the
windscreen in the required position.
3. After you have adjusted the location, you can use an anti scratch board or
something else flat to burnish the refelection film and squeeze the water out
until there are no bubble sor water in it.
4. Tear off the front side (marked 2) of the reflection film.
The first use of HUD
Start engine and power on HUD, showing the current vehicle voltage and then enter
to search ECU state, if the HUD shows speed, rotating speed, indicating that HUD has
been installed successfully. (After 1 minute, or if only display the voltage, please
check whether HUD, OBDII interface, and OBD data cable are connected correctly
Then press the HUD power switch, and start again)
HUDsetting
HUD display information is from ECU, you can now enter the setup mode to
fine-tune the HUD display value, in order to achieve exactly the same value as
dashboard. We have adjusted HUD according to the general test values at the factory,
if you find HUD display information is different from dashboard, then make the
following adjustments:
