Strong SRT ANT 15 Manuale utente

Active Outdoor Antenna DVB-T SRT ANT 15

User Manual

PART 1 l English

Table of Contents

1.0 Introduction 3

2.0 Package contents 4

3.0 Safety notes 5

4.0 Connecting the antenna 5

5.0 Installation of the antenna 9

PART 1 l English

1.0 Introduction

Thank you for purchasing the Strong SRT ANT 15 DVB-T Antenna. This antenna has been specially

designed to receive digital terrestrial signals. It can be connected to any Digital Terrestrial Receiver

(DVB-T), and is specially designed for Outdoor use. The antenna housing is UV protected and

weather-proof sealed. With the multi-functional mounting materials supplied you can install the

antenna on a wall, on your balcony or on a pole outside the house.

This DVB-T Antenna is an “Active type” antenna, it has a built-in low noise ampliﬁer that ampliﬁes the

received signal for better performance. The antenna therefore needs 5 V power supplied by your

terrestrial receiver, or by an AC adaptor (supplied with the antenna).

We recommend that you carefully read this user manual before you install the antenna. This will help

you to get the best performance out of your antenna.

Speciﬁcations:

Frequency range: VHF 47 - 230 MHz, UHF 470 - 870 MHz

Gain: 20 dB for VHF and UHF

RF Output Impedance: 75 Ohm

Power Supply - 2 powering methods: 5 V DC 40 mA via ANTENNA connector of the digital

terrestrial receiver or

9 V DC 100 mA via External 230 V AC to DC adapter

Special features: n Choice of installation methods:

wall-mounted or pole-mounted installation

n Built-in VHF and FM ﬁlter

n Weather-proof and UV protected housing

n Built-in low noise ampliﬁer technology

n Highly directional to optimise accurate pointing to the

transmitter and to reduce pick up of unwanted signals

PART 1 l English

2.0 Package contents

1. Active DVB-T Outdoor Antenna.

2. Multidirectional base.

3. Wall mounting kit.

4. Pole Mounting kit.

5. Coaxial Cable.

6. Power Injector.

7. AC Adaptor.

8. IEC male to IEC female Coaxial Cable.

Multi-directional base Wall Mounting kit Pole Mounting kit

Coaxial Cable Power Injector AC Adaptor

Main unit

PART 1 l English

3.0 Safety notes

n Use only originally supplied accessories

n Before you make any connections: disconnect your equipment from the 230 V mains power

to avoid electrical shocks during installation

n Short Circuit in the coaxial cable MAY permanently damage your Digital Receiver

n Never use AC Adaptors with incorrect speciﬁcations. This MAY permanently damage your

antenna or Digital Receiver. Always check voltages and polarisation of the adaptor before

connecting it

4.0 Connecting the antenna - preparations:

Step 1: Check if the broadcast in your country is Horizontally or Vertically polarised.

Step 2: Fix the Antenna to the multi-directional base as shown in the pictures:

PART 1 l English

Step 3: Depending on how the signals are broadcasted (Horizontal or Vertical) you will have

to mount your antenna in the Horizontal or Vertical position for best performance.

(Vertical-Broadcast) antenna mounted V (Horizontal-Broadcast) antenna mounted H

Step 4: Your antenna needs 5 V power to work properly. Check in the menu or user manual of

your terrestrial receiver to see if it supports the needed 5 V power.

A. To power the antenna with Digital Terrestrial Receiver:

1. Turn on your TV set and turn on your Digital Terrestrial Receiver.

2. Press the “MENU” button on the remote control of your Digital Terrestrial Receiver. Check in the

Set-Up or Installation Menu of your Receiver to see if the antenna power is set to “ON”.

(Normally this is indicated in the menu as ANT power, Ext Antenna power or Active antenna power).

Refer to the User Manual of your Digital Terrestrial Receiver.

PART 1 l English

3. Once you are sure that your receiver supports 5 V antenna power, switch off your receiver and

disconnect it from the 230 V mains power.

4. Take the supplied “long” coaxial cable and connect the end with the “F connector” (screw type

connector) to the antenna. Carefully press the inner lead of the cable into the Female-F connector at

the back of the antenna. Turn the covering nut clockwise with your HANDS until it is ﬁxed.

5. Connect the IEC Male end to your Set Top Box. Normally the input connector on your receiver is

marked as “ANT” (in) or as (in). Refer to the User Manual of your Digital Terrestrial Receiver.

6. Connect your receiver to the 230 V mains power and switch ON your receiver and TV set.

7. Proceed to 5.0 “Antenna installation”.

Powering by STB or Digital TV

Coaxial Cable

STB or Digital TV

Water-Drop Loop

(recommended)

Indoor Outdoor

PART 1 l English

If your receiver does not support 5 V antenna power, then please follow the next steps:

B. To power the antenna with external power adaptor:

1. Switch OFF your receiver and disconnect it from the 230 V mains power.

2. Take the short Coaxial (IEC male to IEC female) Cable. Connect the IEC Male end to your Set Top Box.

Normally the input connector on your receiver is marked as “ANT” (in) or as “RF” (in). Refer to the

User Manual of your Digital Terrestrial Receiver.

3. Connect the other end of the cable to the connector on the power injector that is marked as “Receiver”.

4. Take the supplied “long” coaxial cable and connect the end with the “F connector” (screw type

connector) to the antenna. Carefully press the inner lead of the cable into the Female-F connector at

the back of the antenna. Turn the covering nut clockwise with your HANDS until it is ﬁxed.

5. Connect the other side of the cable to the connector at the power injector, it is marked as “Antenna”.

6. Insert the adapter to the 230 V mains power and insert the connector at the end of the lead to the

power injector - it is marked as “DC 9 - 12 V”.

7. Proceed to chapter 5. “Installation of the antenna”.

For point B - please see drawing below:

Powering by Adaptor

Coaxial Cable

STB or Digital TV

Water-Drop Loop

(recommended)

Indoor Outdoor

AC Adaptor (DC 9 V)

Coaxial Cable

Power Insert

PART 1 l English

5.0 Installation of the antenna:

1. Turn on your TV set and turn on your Digital Terrestrial Receiver.

2. Press the “MENU” button on the remote control of your Digital Terrestrial Receiver. Select the Menu

on your receiver that shows you the signal level indicators. (Normally you can ﬁnd the signal meter in

the Channel Scan ﬁeld of the menu). Refer to the User Manual of your Digital Terrestrial Receiver.

3. Now optimise the signal strength by ﬁnding the best position for the antenna. Keeping the antenna

in your hand, try to reach the highest or best possible position. Slowly move the antenna to different

positions around the house, at the same time monitor the signal bars in the menu, once the signal

indicator shows the maximum signal, ﬁx the antenna on that position.

Note: It is recommended NOT to place the antenna near to:

n Devices that are strong source of radiation or interference such as DECT and GSM telephones,

Transmitters, Microwaves, etc.

n Devices with high power consumption such as Electrical Heater, Air conditioner, Hairdryers, etc.

Once the best position for the antenna has been found it can be mounted and ﬁxed in that place.

You can ﬁx the antenna on the wall, on the balcony or on a metal pole.

PART 1 l English

Installation on the wall:

n Take the multi directional base and hold it to the position on the wall

n Mark the 4 holes with a pencil

n Drill 4 holes diameter 5,8 mm (make sure you are in a secured position and wear sufﬁcient

protective clothing while drilling

n Insert the 4 plastic plugs into the drilled holes

n Hold the multi directional base on it’s position

n Use the 4 screws to ﬁx the plastic mount on the wall

Altri manuali per SRT ANT 15

Indice

Altri manuali Strong Antenna

Strong

Strong SlimSat SA60 Manuale utente

Strong

Strong SlimSat SA64 Manuale utente

Strong

Strong SRT ANT 12 Manuale utente

Strong

Strong SRT ANT 15 Manuale utente

Strong

Strong SRT ANT 12 ECO Manuale utente

Strong

Strong SRT ANT 12 Manuale utente

Strong

Strong SRT ANT 12 Manuale utente

Strong

Strong SRT ANT100 Manuale utente

Strong

Strong SRT ANT 30 Manuale utente

Strong

Strong SlimSat SA61 Manuale utente

Strong

Strong SRT ANT200 Manuale utente

Manuali Antenna popolari di altre marche

Alfa Network

Alfa Network APA-L01 Manuale utente

Naval

Naval PR-422CA Manuale utente

Feig Electronic

Feig Electronic ID ISC.ANTH200/200 Series Manuale utente

TERK Technologies

TERK Technologies TV44 Manuale utente

Directive Systems & Engineering

Directive Systems & Engineering DSE2324LYRMK Manuale utente

HP J8999A Manuale utente

MobilSat

MobilSat MSP-S Manuale utente

Steren

Steren ANT-UHF 13 Manuale utente

Novatel

Novatel 600-G Manuale operativo

Radio Shack

Radio Shack Amplified VHF/UHF/FM Indoor Antenna Manuale utente

TRENDnet

TRENDnet TEW-AO12O Manuale utente

Radio Shack

Radio Shack 15-1837 Manuale utente

CommScope

CommScope CMAX-OMFX-43M-I53 Manuale utente

Ramsey Electronics

Ramsey Electronics DAP25 Manuale utente

COBHAM

COBHAM SAILOR 800 VSAT Manuale per l'uso e la cura

Trango Systems

Trango Systems AD900-9 Manuale utente

Steren

Steren ANT-100 Manuale utente

Proxim

Proxim 5054-PA-23 Manuale utente