Do not use the machine
for the following
Cutting of materials other than solid materials suitable for
materialographic studies. In particular, the machine must not be
used for cutting of any type of explosive and/or flammable
material, or materials which are not stable during machining,
heating or pressure.
The machine may not be used with cut-off wheels which are not
compatible with the machine requirements (e.g. saw-blade or
toothed cut-off wheels).
Model – Discotom-10 with fixed table
– Discotom-10 with automatic x-table
2.2 Discotom-10safety precautions
2.2.1 Read carefully before use
1. Ignoring this information and mishandling of the equipment can lead to severe bodily injuries
and material damage.
2. The machine must be installed in compliance with local safety regulations.
3. The machine must be placed on a safe and stable support table.
4. When lifting the machine using a forklift, lift from front or rear - never lift the machine from the
side.
5. When lifting the machine using lifting straps, ensure that the straps are crossed and do not
press on the sides of the machine.
6. The operator(s) must read the Safety and Operate the device sections of this manual and the
relevant sections of the manuals for any connected equipment and accessories. The
operator(s) must read the Instructions for Use and, where applicable, Safety Data Sheets for
the applied consumables.
7. For maximum safety and lifetime of the machine, use only original Struers consumables.
8. Use only intact cut-off wheels. The cut-off wheels must be approved for use with rotational
speeds between 1,500 and 3,000 rpm.
9. The machine is not for use with saw-blade type cut-off wheels.
10. Do not use the machine for cutting materials that are flammable or unstable during the
cutting process (e.g. combustible or explosive materials). Do not use the machine for cutting
materials that are not suitable for materialographic cutting.
11. Observe the current safety regulations for handling, mixing, filling, emptying and disposal of
the additive for cooling fluid.
12. Do not use flammable cooling fluid.
13. All safety functions and guards of the machine must be in working order.
14. Modifying or disabling the protective cover may cause serious hazard.
15. The workpiece must be securely fixed in a quick-clamping device or similar. Large or sharp
workpieces must be handled in a safe way.
2 Safety
Discotom-10 7
