Strymon COMPADRE Manuale utente
COMPADRE - Dual Voice Compressor & Boost
pg 2
Controls and Connections
Front Panel
Rear Panel
Power Up Modes
Bypass Mode
FAV/MIDI Jack Options
External Control
Volume Pedal
FAV Switch Setup and Compare Mode
MultiSwitch Plus Setup
MIDI Functionality
Configuring to Use MIDI
Saving MIDI Presets
MIDI Specifications
Factory Reset
Features
Specifications
Appendices
Power Up Modes Quick Reference
Signal Flow Diagram
Sample Settings
Warranty
Table of Contents
3
6
7
8
9
10
11
13
17
19
20
21
22
24
27
29
30
COMPADRE - Dual Voice Compressor & Boost
pg 3
BOOST EQ
Selects the frequency shape for clean and dirty boost.
treble: Tightens the bottom end by boosting mid to high
frequencies.
mid: Fattens tone by pushing midrange frequencies.
flat: Full range frequency response.
COMP TYPE
Select the type of compression.
studio: Smooth compression as found in vintage rack
compressors.
squeeze: Hard compression typical of classic guitar pedals.
Controls and Connections – Front Panel
COMPADRE - Dual Voice Compressor & Boost
pg 4
LEVEL
Adjusts the output level of the
pedal by -6dB to +6dB when the
compressor is engaged. Noon is
unity gain.
COMPRESSION
Turning clockwise
increases compression by
lowering the threshold.
Fully counterclockwise, no
compression is applied.
BOOST
Adjusts the amount of boost
when the boost circuit is
active. Typical boost ~14dB in
Flat Clean boost.
DRY
Adjusts the amount of dry signal
summed with the compressor
output.
Controls and Connections – Front Panel (cont.)
COMPADRE - Dual Voice Compressor & Boost
pg 5
COMP
Engages and disengages the VCA
compressor independent of the
BOOST. RED LED ON indicates
that the compressor is engaged.
BOOST
Engages and disengages the
variable boost independent
of the COMP. The boost is
post-compression. RED LED
ON indicates that the boost is
engaged.
NOTE: When both BOOST and COMP are disengaged,
the bypass is either Buffered Bypass or True Bypass
depending on the selected mode.
Controls and Connections – Front Panel (cont.)
COMPADRE - Dual Voice Compressor & Boost
pg 6
FAV / MIDI
Connect a Strymon MiniSwitch
for remote selection of a Favorite
setting.
(See page 11 for details on configuring
for MIDI functionality and use with
MultiSwitch Plus.)
9VDC
Use the included power
supply or an adapter
with the following
rating: 9VDC maximum
center negative. 150mA
minimum.
BOOST TYPE
Selects between a clean or soft
clipping boost circuit.
CLEAN: Boost circuit increases
output level without introducing
noticeable clipping.
DIRTY: Boost circuit increases
output level while introducing the
soft clipping characteristic of an
overdrive pedal.
OUT
Low impedance
mono output.
IN
High impedance ultra
low-noise discrete Class
A JFET preamp input.
VOLUME
Connect a TRS expression pedal
for full-time volume pedal
functionality.
Controls and Connections – Rear Panel
COMPADRE - Dual Voice Compressor & Boost
pg 7
Power Up Modes – Bypass Mode
Turn the COMPRESSION knob to select one of the options below.
The COMP LED will change color to indicate the current status
as the knob is turned.
True Bypass: GREEN
Auto Bypass: AMBER (default)
True Bypass, but forces Buffered Bypass when Volume Pedal
jack is connected
Buffered Bypass: RED
Press and hold the
COMP footswitch while
connecting power to
the pedal. Once both
LEDs flash, release the
footswitch.
1
2
3Press the COMP or BOOST
footswitch to store the
bypass mode and begin using
Compadre.
NOTE: Power up modes are
saved unless they are changed
again with the steps above.
NOTE: Auto and Buffered Bypass allow for the Volume Pedal jack
to operate while the pedal is bypassed.
Setting Compadre to Buffered Bypass mode preserves the high
frequency response of your guitar signal through your pedal chain and
long cable runs.
COMPADRE - Dual Voice Compressor & Boost
pg 8
Power Up Modes – FAV/MIDI Jack Options
3Press the COMP or
BOOST footswitch to store
the bypass mode and
begin using Compadre.
NOTE: Power up modes are
saved unless they are changed
again with the steps above.
Select the mode of the FAV/MIDI jack for external control of Compadre.
Turn the BOOST knob to select the function of the FAV/MIDI jack.
The BOOST LED will change from RED to BLUE to indicate the
current status as the knob is turned.
FAV Mode - RED (default)
Allows you to connect
MiniSwitch or another
external latching footswitch
with a TRS cable to store and
recall your Favorite setting.
(See page 10 for more details.)
MIDI Mode - BLUE
Connect MIDI EXP Cable
or MIDI > TRS interface to
access 300 presets and
remotely control patch
parameters via MIDI.
(See page 13 for more details.)
Press and hold the
COMP footswitch while
connecting power to
the pedal. Once both
LEDs flash, release the
footswitch.
1
2
COMPADRE - Dual Voice Compressor & Boost
pg 9
Use a TRS Expression pedal to control the output volume.
External Control – Volume Pedal
Connect the Expression pedal to the VOLUME jack of
Compadre using a TRS cable.
1
NOTE: When Compadre is in Buffered Bypass or Auto Bypass
mode, the pedal will still function as a Volume pedal even when
both BOOST and COMP are bypassed.
(See page 7for more details.)
We recommend using an expression pedal with a 25k Ohm
minimum potentiometer.
COMPADRE - Dual Voice Compressor & Boost
pg 10
Connect MiniSwitch or other external latching footswitch with a
TRS cable to store and recall your favorite setting.
External Control – FAV Switch Setup and Compare Mode
Configure the FAV/MIDI
jack for FAV mode.
(See page 8 for more info.)
Connect an external switch
with a TRS cable to the
FAV/MIDI jack.
Dial in your desired sound.
To save your sound as the
FAV setting, press and
hold the BOOST footswitch
for 2 seconds.
Step on the external footswitch
to toggle between your FAV
setting and the current knob
and toggle switch positions.
1
2
3
4
COMPARE MODE
With the FAV engaged, as a knob
or switch is adjusted, the BOOST
LED flashes GREEN when the
current knob or toggle switch
position matches the setting of
the saved FAV setting.
NOTE: Along with the knobs
and toggle switches on the
face of the pedal, the setting of
the rear BOOST TYPE switch
and the bypass state of BOOST
and COMP are stored with the
FAV setting.
NOTE: Saving presets works
differently when using MIDI.
(See page 17 for more details.)
NOTE: The FAV setting is
stored at MIDI program change
number 0.
OR
Altri manuali per COMPADRE
1
Indice
Altri manuali Strymon Pedale musicale
Strymon
Strymon Iridium Manuale utente
Strymon
Strymon Ola Manuale utente
Strymon
Strymon sunset Manuale utente
Strymon
Strymon Lex Manuale di riferimento
Strymon
Strymon Riverside Manuale utente
Strymon
Strymon Lex-rotary Manuale utente
Strymon
Strymon BRIG Manuale utente
Strymon
Strymon TimeLine Manuale utente
Strymon
Strymon Zuma Manuale utente
Strymon
Strymon Volante Manuale utente
Strymon
Strymon TimeLine Manuale utente
Strymon
Strymon Lex-rotary Manuale utente
Strymon
Strymon DECO Manuale utente
Strymon
Strymon NIGHTSKY Manuale utente
Strymon
Strymon DIG Manuale utente
Strymon
Strymon DECO Manuale utente
Strymon
Strymon Orbit Manuale utente
Strymon
Strymon sunset Manuale utente
Strymon
Strymon Flint Manuale utente
Strymon
Strymon brigadier Manuale utente
