7
Connecting the Exhaust Duct
Only rigid or flexible metal ducting should be used for exhaust ventilation.
1. Place the exhaust fitting over the exhaust vent in the upper right corner of the
back of the appliance. See Fig. 3 on the previous page. The opening of the
fitting should point down for a downward exhaust, and up for an upward
exhaust.
2. Connect a rigid or flexible metal duct to the end of the exhaust fitting and feed
it to the chosen moist air outlet (ventilation shaft, window, etc.).
3. Ventilation must not be connected to an air duct used as a chimney for
exhaust gases or appliances using other combustible material.
4. The distance between the dryer and the moist air outlet should not exceed 80"
(2 meters), otherwise water can accumulate in the duct.
5. Periodically clean (vacuum) the interior of the ventilation exit or duct.
Adjusting the Leveling Legs
Your dryer is shipped with four legs in the bag
containing your Use & Care Guide. To install the
leveling legs, see the illustration to the right.
If the floor is uneven, adjust the legs. Do not insert
pieces of wood or any other object under the legs.
Place the dryer on a sturdy flat surface. If the dryer is placed on an uneven or
weak surface, noise or vibration will occur.
Electrical Connection
WARNING: Improper use of the grounded plug can result in the risk of electrical
shock. If the power cord is damaged, have it replaced by an
authorized service technician.
This appliance should be properly grounded for your safety. The power cord of
this appliance is equipped with a three-prong plug which mates with standard
three-prong wall outlets to minimize the possibility of electrical shock.
Do not under any circumstances cut or remove the third ground prong from the
power cord supplied.
The use of an extension cord is not recommended.
This appliance requires a standard 115/120-volt 60Hz electrical outlet with three-
prong ground. To prevent accidental injury, the cord should be secured behind
the appliance, not left exposed or dangling.
